Structural development and magnetic phenomenon in Zn–Cr–Fe multi oxide nano-crystals

The Cr³⁺ ions doped multi-oxide ZnFe_2−xCr_xO₄ ferrite nanoparticles have been synthesized by chemical co-precipitation method. Site occupancies of Zn²⁺, Cr³⁺ and Fe³⁺ ions were analyzed using X-ray diffraction data and Buerger's method. The effect of the constituent phase variation on the magnetic hysteresis behavior was examined by saturation magnetization which decreases with the increase in Cr³⁺ content in place of Fe³⁺ ions at octahedral B-site. Typical blocking temperature (T_B) around 90 K was observed by zero field cooling and field cooling magnetization study. Room temperature Mössbauer spectra show two paramagnetic doublets (tetrahedral and octahedral sites). The isomer shifts of both doublets decrease whereas quadrupole splitting and relative area of tetrahedral A-site increases with increasing Cr³⁺ substitution. The dielectric constant (measured on compositions x=0, 0.4, 0.8 and 1.0) increases when the temperature increases as in the semiconductor. This behavior is attributed to the hopping of electrons between Fe²⁺ and Fe³⁺ ions with a thermal activation.     

A selection of material using a novel type decision-making method: Preference selection index method

The aim of the current study is to implement a novel tool to help the decision-maker for selection of a proper material that will meet all the requirements of the design engineers. Preference selection index (PSI) method is a novel tool to select best alternative from given alternatives without deciding relative importance between attributes. In the present study, three different types of material selection problems are examined. A validation and consistency test of preference selection index method is performed in present work by comparing results of PSI method with published results of graph theory and matrix approach (GTMA), and technique for order preference by similarity to ideal solution (TOPSIS) method, respectively. The research has concluded that the PSI method is logical and more appropriate for the material selection problems.     

Preparation,dosimetric characterisation and investigation of related TSL defect centres in Li3Po4:Mg,Cu phosphor

L3PO4:Mg,Cu, a low effective atomic number and high sensitivity TSL phosphor, has been prepared. Its TSL glow curve shows a major peak around 360 degrees C with minor peaks around 110 degrees C and 230 degrees C. The optimum concentrations of the dopants are found to be 200 ppm each. Its gamma sensitivity is 1.2 times as compared to CaSO4:Dy (0.1 mol%). The optimum preirradiation annealing treatment is found to be 650 degrees C, 15 min. Its PL emission shows a band at 370 nm with excitation band at 250 nm. Dose to TSL response shows that its response is linear up to the gamma dose of 100 Gy for irradiations carried out at RT. An irradiated sample shows a distinct new ESR signal, which is tentatively assigned to an electron/hole localised on one of the oxygen(s) of the phosphate group. Step annealing experiments show decay of the defect centre around 340 degrees C. This correlates well with the TSL peak around 360 degrees C.     

Pr（Ⅲ） and Nd（Ⅲ） Absorption Spectroscopic Probe to Investigate Interaction with Lysozyme （HEW）

Pr（ Ⅲ ） and Nd（ Ⅲ ） can be utilized as absorption spectroscopic probes to investigate the interaction of biomolecules like Lysozyme （HEW） with Ca（ Ⅱ ） in-vitro ; the most abundant metal ion in the human body system. The spectroscopic techniques involving comparative absorption, absorption difference, and quantitative intensity analysis using 4f-4f transitions are utilized for changes in the inner sphere coordination pattern of Pr（ Ⅲ ） and Nd（Ⅲ ） in solution as well as in solid state. The present study deals with an important biomolecule in human metabolism, that is, Lysozyme （HEW）. The absorption er-Condon the probab spectral parameters such as the oscillator strength （P）, the Judd-Ofelt （Tλ） intensity parameters, and the Slatinter electronic parameters are calculated using chi square methods. The obtained results are used to determine le geometry of the complex in the solution, the nature of the bond between Pr（Ⅲ）/Nd（Ⅲ） with lysozyme, and the inner sphere coordination environment of f-f transitions. The results obtained from various experimental conditions are utilized to investigate the coordination changes in the Pr（Ⅲ）/Nd（Ⅲ） complexes caused by different coordinating sites of lysozyme, normalized bite, denticity, the solvent nature, the coordination number, the nature of bond and other parameters to mimic the interaction of the Ca（ Ⅱ ） ion with such biomolecule.     

Set size, novelty, and visual pop-out in infancy.

The effects of set size and novelty on visual pop-out in 6-month-old infants was assessed in a perceptual-identification (memory reactivation) paradigm in which infants, trained and tested in their own homes, viewed a mobile containing a unique novel or familiar object amidst different numbers of familiar or novel distractors, respectively. Unique objects of both types popped out at all set sizes except the largest, where there was modest evidence that familiar distractors speeded processing (Experiment 1). When the proportion of familiar targets in a display of intermediate set size was increased, however, infants no longer detected the familiar target (Experiment 2). These findings offer additional support for the proposition that visual pop-out in infants and adults is the same phenomenon. (PsycINFO Database Record (c) 2011 APA, all rights reserved)     

Temperature dependence of vickers microhardness and creep of InBi single crystals

Variation of Vickers microhardness of InBi single crystals with temperature has been studied. Loading time dependence of the microhardness at different temperatures has been used for the creep study in the temperature range 30° – 85°C. The activation energy for creep has been evaluated and the results are discussed.     

Blue light stimulated luminescence in calcium fluoride, its characteristics and implications in radiation dosimetry

Strong optically stimulated luminescence (OSL), stimulated by blue light, has been observed, for the first time, in natural calcium fluoride (CaF(2)) phosphor, used as thermoluminescence dosemeters. Traps responsible for all three thermoluminescence (TL) peaks appearing upto 300 degrees C, i.e. 126, 196 and 264 degrees C, were observed to contribute to the blue light stimulated luminescence (BLSL) in CaF(2). When the areas under the respective curves (BLSL and TL) were measured, the BLSL measured at room temperature was found to be approximately 1.8 times the TL output of the dosimetry peak that appeared at approximately 264 degrees C. However, when measured after thermally annealing the first two TL peaks, the BLSL signal was found to be 0.26 times the TL output of the dosimetry peak at 264 degrees C. This paper describes the characteristics of the BLSL signal using linearly modulated OSL after subjecting the phosphor to different annealing treatments. Feasibility studies to assess the usefulness of BLSL in CaF(2) for environmental radiation monitoring are also discussed.     

Spatial and Temporal Resolution of Conjugate Conduction-Convection Thermal Resistance

A transient, 3-D solution to the heat conduction equation with a small square heat source on an adiabatic surface and Newtonian convection on the opposite side was obtained using Green's functions. The geometry conservatively models conduction spreading resistance encountered by small, concentrated heat sources such as light-emitting diodes and integrated circuits in general, mounted to larger substrates such as the base of a heat sink experiencing Newtonian convection. The solution is presented for a range of nondimensional parameters. Superposition techniques can also be used to extend the applicability of the current solution to the temperature prediction of arbitrary heat flux patterns in certain cases. This technique only holds for applications where the heat transfer coefficient is not a function of temperature, such as thermal management strategies designed to rely on forced convection with air.     

What kind of #conversation is Twitter? Mining #psycholinguistic cues for emergency coordination

The information overload created by social media messages in emergency situations challenges response organizations to find targeted content and users. We aim to select useful messages by detecting the presence of conversation as an indicator of coordinated citizen action. Using simple linguistic indicators drawn from conversation analysis in social science, we model the presence of coordination in the communication landscape of Twitter¹ using a corpus of 1.5 million tweets for various disaster and non-disaster events spanning different periods, lengths of time, and varied social significance. Within replies, retweets and tweets that mention other Twitter users, we found that domain-independent, linguistic cues distinguish likely conversation from non-conversation in this online form of mediated communication. We demonstrate that these likely conversation subsets potentially contain more information than non-conversation subsets, whether or not the tweets are replies, retweets, or mention other Twitter users, as long as they reflect conversational properties. From a practical perspective, we have developed a model for trimming the candidate tweet corpus to identify a much smaller subset of data for submission to deeper, domain-dependent semantic analyses for the identification of actionable information nuggets for coordinated emergency response.     

An automated approach to beat-by-beat QT-interval analysis

The present work attempts to resolve some of the problems encountered in QT interval analysis and to describe a new algorithm that uses wavelets to analyze the QT interval on a beat-by-beat basis. The QT interval is further segmented into its contributing factors to find the variability in the repolarization phase. The technique and the algorithm have been tested on control and disease data from the standard MIT ECG library to prove the reproducibility and accuracy of the system. The technique has been implemented on a PC DSP add-on card to do the analysis on a beat-by-beat basis