Hydroxyl‐functional polyurethanes and polyesters: synthesis,properties and potential biomedical application

This mini review gives an overview of the synthesis of polyurethanes and polyesters with pendant hydroxyl groups performed mainly in our group. Significant for the synthesis of most of these polymers with hydroxyl‐functional side groups is that no protection groups are needed. This is realised either by generating the OH group during polymer synthesis—demonstrated by the preparation of hydroxyl‐functional polyurethanes from dicarbonate monomers and diamines—or by using catalysts which discriminate between primary and secondary OH groups—demonstrated by the synthesis of hydroxyl‐functional polyesters based on malic acid using scandium triflate as catalyst. In addition, the potential of carbonate couplers for the synthesis of multifunctional polyurethane is presented. The application of such multifunctional polyurethanes as antimicrobial polymers and coatings is briefly discussed. Copyright © 2012 Society of Chemical Industry     

Synthesis and Photocatalytic Properties of Single Crystalline (Ga1-xZnx)(N1-xOx) Nanotubes

Recently, (Ga_1-xZn_x)(N_1-xO_x) has gained widespread attention as a comparatively high efficiency photocatalyst for visible-light-driven overall water splitting. Despite significant gains in efficiency over the past several years, a majority of the photogenerated carriers recombine within bulk powders. To improve the photocatalytic activity, we used an epitaxial casting method to synthesize single-crystalline, high surface area (Ga_1-xZn_x)(N_1-xO_x) nanotubes with ZnO compositions up to x=0.10. Individual nanotubes showed improved homogeneity over powder samples due to a well defined epitaxial interface for ZnO diffusion into GaN. Absorption measurements showed that the ZnO incorporation shifts the absorption into the visible region with a tail out to 500 nm. Gas chromatography (GC) was used to compare the solar water splitting activity of (Ga_1-xZn_x)(N_1-xO_x) nanotubes (x=0.05–0.10) with similar composition powders. Cocatalyst decorated samples were dispersed in aqueous solutions of CH₃OH and AgO₂CCH₃ to monitor the H⁺ reduction and H₂O oxidation half reactions, respectively. The nanotubes were found to have approximately 1.5–2 times higher photocatalytic activity than similar composition powders for the rate limiting H⁺ reduction half reaction. These results demonstrate that improvements in homogeneity and surface area using the nanotube geometry can enhance the photocatalytic activity of GaN:ZnO for solar water splitting.     

Antioxidant activity of cyanidins isolated from Ogapy (Acanthopanax divaricatus var. albeofructus) fruits in U937 macrophages

Reactive oxygen species (ROS) are continuously produced in aerobic organisms. Overproduction of ROS is known to play a crucial role in the pathogenesis of many cardiovascular diseases, including atherosclerosis and hypertension. Superoxide dismutase (SOD) and catalase (CAT) play critical roles on the removal of excess ROS. In the present study, we investigated the antioxidant activity of cyanidins from ogapy (Acanthopanax divaricatus var. albeofructus, ADA) fruits against oxidative stress in hydrogen peroxide (H₂O₂)-pretreated U937 macrophages, and explored the plausibility of the therapeutic effect of cyanidins on atherosclerosis. As a result, H₂O₂ generation and lipid peroxidation induced by H₂O₂-pretreatment was decreased by the treatment of cyanidins in U937 macrophages. In addition, increased activity of SOD and CAT was shown in H₂O₂-pretreated cells when treated with cyanidins. Overall, the results obtained in this study showed that cyanidin 3-galactoside and cyanidin 3-lathyroside from ADA fruits could protect macrophages against the damaging effects of H₂O₂ treatment.     

Time‐series and extended Karhunen–Loève analysis of turbulent drag reduction in polymer solutions

Direct numerical simulations and statistical analysis techniques are used to study the drag‐reducing effect of polymer additives on turbulent channel flow in minimal domains. Additionally, a new formulation of Karhunen–Loève decomposition for viscoelastic flows is introduced, allowing the dominant features of the polymer stress fields to be characterized. In minimal channels, there are intervals of “active” and “hibernating” turbulence that display very different structural and energetic characteristics; the present work illustrates how the statistics of these intervals evolve over the entire range of drag reduction (DR) levels. The effect of viscoelasticity on minimal channel turbulence is twofold: first, it strongly suppresses the active turbulent dynamics that predominate in Newtonian flow and second, at sufficiently high Weissenberg number it stabilizes the dynamics of hibernating turbulence, allowing it to predominate in the maximum drag reduction regime. In this regime, the stress fluctuations become delocalized from the wall region, encompassing the entire flow domain. © 2014 American Institute of Chemical Engineers AIChE J, 60: 1460–1475, 2014     

Measurement of radiation emitted from thin vaporizing liquid films for the calculation of surface temperature

Evaporation of liquid films, not subjected to motion, and with a starting thickness of 1 mm, was tested. Solvents dichloromethane and ethanol were used as liquids. Surface temperature during evaporation was measured in a non-intrusive way using pyrometry. The employed pyrometer was calibrated against a black body radiant. Measurement accuracy in the region of the ambient temperature is 0.2 K. Since any principal stray radiation is always measured along with the thermal radiation emitting from the liquid film, the measurement results are at first distorted. A correction calculation is described. With this, the various proportions of stray radiation can be subsequently calculated. In order to do this, the dimensions of the test equipment and the spectral data of the evaporating solvents must be taken into account. The quantity of stray radiation depends mainly on the properties of the surface onto which the liquid film is applied, as well as on the spectral transmissivity of the liquid. This was measured for every tested liquid according to wavelength and layer thickness. Where the spectral transmissivity of a liquid is low, a correction calculation of the measured surface temperature is not necessary, while a high level of accuracy is still retained.     

Lane Detection Based on Contrast Improvement in Foggy Road Image

<正>This paper proposes a lane detection algorithm using sub stretching of histogram.First of all,makes a decision whether the image has foggy or not.For this,sets the interest region and analyzes the histogram of the region. If the image has a fog,applies a contrast enhancement algorithm using sub-stretching of histogram.In order to detect lane information,uses connectivity of edge pixels of road image and finds the straight lines forward to the center of image.To evaluate the performance of proposed algorithm,tested the algorithm on the road image obtained by a driving test and verified its efficiency.     

Grundwasserfauna als Indikator für Oberflächenwasser-Grundwasser-Interaktionen im Bereich einer Uferfiltrationsanlage

The water quality of bank filtrate is strongly influenced by complex hydrological exchange processes. In particular, surface water coming into contact with groundwater is a potential hazard for drinking water quality. Therefore monitoring for surface water intrusion is required for assuring the quality of the raw water being used. The hydrological interactions of the Rhine bank filtration site at Flehe, Duesseldorf were analyzed hydro-chemically and faunistically and both approaches were compared. In addition, the degree of surface water influence was determined by using the fauna and the Groundwater-Fauna-Index (GFI) after Hahn (2006a). The fauna provided a more detailed impression of the hydrological situation of the study area than the water chemistry. By means of the fauna and the GFI, different groundwater types were identified, indicating different degrees of surface water intrusion. Thus, the fauna and the GFI are considered to be suitable measures for the assessment of the hydrological conditions as well as for the evaluation of the surface water impact on the groundwater and consequently are suitable for use in vulnerability assessment.     

Transport properties of sorbing contaminants in a fractured granite under oxidizing conditions

Migration of some sorbing chemical species has been studied in a single rock fracture of 1 m scale in order to understand the transport behavior of contaminants at underground environments. For the tracers, tritium and anions were used as nonsorbing ones and some sorbing cations such as Sr, Co and Cs were used as well. The experimental study was focused on the identification of the retardation and matrix diffusion of the tracer in the fracture. The hydraulic conductivity in the fracture was determined from the pressure differentials between pairs of boreholes. The hydraulic data were used with a variable aperture channel model to characterize the aperture distribution in the fracture. A transport model has been developed to describe the migration of the solutes in the flow field by using a particle tracking method. Results were plotted in the form of elution curves and migration plumes in the fracture. The experimental elution curves have been explored with the transport model which takes into account sorption and diffusion into the rock matrix. This comparison may contribute to further understanding on the heterogeneous flow field and the interactions between rock and chemical species.     

Optimization of the property profile of poly‐L‐lactide by synthesis of PLLA‐polystyrene–block copolymers

Diblock and triblock copolymers of poly‐L ‐lactide (PLLA) and polystyrene (PS) were synthesized and the mechanical properties of these copolymers studied. Free radical polymerization of styrene in the presence of 2‐mercaptoethanol as functional chain transfer agent produced mono‐functionalized PS‐blocks which were used as macroinitiators in the subsequent ring opening polymerization (ROP) of L ‐lactide to produce the diblock copolymers. Furthermore a α‐ω‐bishydroxyl functionalized PS‐block was synthesized by RAFT, which was then engaged as bifunctional initiator for the ROP of L ‐lactide to provide the triblock copolymers PLLA‐PS‐PLLA. Through the copolymerisation and high molar masses, it was possible to achieve an improved mechanical property profile, compared with pure PLLA, or the analogous blends of PLLA and PS. A weight fraction of PS of 10–30% was found to be the optimal range for improving the heat deflection temperature (HDT), as well as mechanical properties such as ultimate tensile strength or elongation at break. © 2012 Wiley Periodicals, Inc. J. Appl. Polym. Sci., 2013