Fluid filling of a membrane tube with self-weight

The filling of a membrane tube with self-weight by a fluid is studied theoretically for the first time. The fundamental problem depends on two non-dimensional parameters, $\beta$ and $\gamma$ which represent the importance of internal pressure and membrane self-weight respectively. The nonlinear equations are solved by an efficient numerical integration method. It is found that membrane self-weight has considerable effect on the tube geometry and the tension of the membrane at low filling pressures.     

Mesure en place de la permeabilite des sols fins

Bulletin of Engineering Geology and the Environment - La mesure en place de la perméabilité k des sols fins est un moyen d'améliorer la prévision des vitesses de tassement...     

Compartment tests of polyurethane foam seating assemblies

Data from compartment tests of polyurethane foam seating assemblies are reported. Results show that the behavior of such assemblies during fires is strongly dependent on the type and position of interliners and upholstery fabrics. An incidental comparison of peak rate of heat release obtained in a compartment test with a predictive model equation is made and selected data from the tests are presented.     

Geomechanical model simulation for the varied rock formations of the Kadana dam foundation,Gujarat, India

Bulletin of Engineering Geology and the Environment - Precambrian layered rocks consisting of quartzites, phyllites and metagreywackes of the Aravallis having a large variation in thickness,...     

Oxygen transfer in a rotating disc treatment plant

In this paper experiments are described in a bio-disc pilot plant. A new method has been developed for a reproducible measurement of the thickness of the waterfilm on the rotating discs. The results were used to calculate the oxygen transfer coefficient into water (K_L). The values of K_L, calculated in this way, appeared to be considerably higher than experimental K_L-values, which is mainly due to the fact that the water layer on the rotating disc is outdistanced by the disc. This effect has not been taken into account in the literature so far.     

Dynamic analysis and optimal feedback control synthesis applied to biological waste treatment

The dynamics and optimal feedback control of biological waste treatment processes are examined. Modern feedback control theory is applied and results are obtained for both proportional and proportional plus integral control. A dynamic mathematical model of the system is developed by employing a Monod kinetic model, which is modified to account for endogenous metabolism, and a complete mixing flow model in the growth chamber. The feedback control is implemented via the flow rate so as to maintain desired effluent concentrations. External disturbances which cause changes in substrate concentration and/or cell concentration are considered and optimal control effort is applied. Results are also presented for impulse and step changes in the influent substrate concentration. It is found that by changing the values of the weighting factors in the objective function, it is possible to obtain good control of either the effluent substrate concentration or cell concentration.     

钢管混凝土组合柱的研究进展

本文对钢管混凝土组合柱的研究现状进行了概述，并就其发展前景进行了展望．     

The development of macrolayer thickness of water in the pool boiling regime

ABSTRACT

The main purpose of this study is to analyse the phenomenon of pool boiling in water over a horizontally placed copper tube heater of 28?mm diameter. The experiment has been carried out to observe the bubble growth and departure characteristics for the heat flux range up to 40,000?W/m². The entire process is being recorded by a digital camera at different time intervals. The measured parameters have been used to determine the initial layer thickness, macro layer thickness and critical heat flux and validated with models proposed in the literature.     

Classic and novel brominated flame retardants (BFRs) in common sole (Solea solea L.) from main nursery zones along the French coasts

Brominated flame retardants (BFRs) were investigated in juvenile common sole from nursery zones situated along the French coast in 2007, 2008 and 2009. Extensive identification was performed with regard to PBDEs, novel BFRs 1,2-bis(2,4,6-tribromophenoxy)ethane (BTBPE) and decabromodiphenylethane (DBDPE), and other non-PBDE BFRs, namely, hexabromobenzene (HBB) and 2,2′,4,4′,5,5′-hexabromobiphenyl (BB-153). Polybrominated diphenyl ether (PBDE) concentrations (Σ 14 congeners) ranged from 0.01 ng/g to 0.16 ng/g wet weight (ww) in muscle, and 0.07 ng/g to 2.8 ng/g ww in liver. Concentrations were in the lower range of those reported in the literature in other European locations. Lower PBDE concentrations, condition indices and lipid contents were observed in the Seine estuary in 2009, possibly in relation to a lower water flow. The PBDE patterns and ratios we observed suggested that juvenile sole have a relative high metabolic degradation capacity. Non-PBDE BFRs were detected at lower levels than PBDEs, i.e., within the < method detection limit - 0.005 ng/g ww range in muscle, and < method detection limit - 0.2 ng/g ww range in liver. The data obtained is of particular interest for the future monitoring of these compounds in the environment.     

Particles and vegetation: implications for the transfer of particle-bound organic contaminants to vegetation

This paper presents a comprehensive review of the mechanisms responsible for the transfer of atmospheric particulate deposition and soil particulate re-suspension onto vegetation. The nature of atmospheric aerosols and dry/wet particulate deposition are reviewed, together with information from the literature on radionuclides as tracers of the air particle/soil particle to vegetation transfer processes. Information from these fields is used to make inferences about the potential significance of these pathways in supplying particle-bound semi-volatile organic chemicals (e.g. polycyclic aromatic hydrocarbons, polychlorinated dibenzo-p-dioxins and dibenzofurans, polychlorinated biphenyls) to vegetation. Retention of compounds on particles brought to the above-ground plant surfaces is discussed. In the absence of definitive field/experimental studies, calculations are made drawing on the literature data to estimate the contributions of atmospheric and soil particle-bound organic contaminants to the plant concentration. These show that depending on the site-specific, species-specific and compound-specific scenarios considered, particulate-bound inputs may be negligible or may dominate the supply of organic contaminants to the above-ground portion of plants. However, field/experimental studies and direct measurements are needed to provide reliable quantitative data on this topic.