Optical signal routing using emission packet positioning of semiconductor heterostructure

We present a novel optical switching technique utilizing emission packet positioning of semiconductor heterostructure. A modulation-doped p-AlGaAs-GaAs heterostructure is employed to control spontaneous emission packet positioning with electric fields. Emission packets generated by optical input signals are brought over 150 /spl mu/m with electric fields, so the output fibers can detect the emission intensity as signals. The first-order analysis indicates that the drift velocity of minority electrons in GaAs limits the detectable maximum data rate and nanoseconds timescale signal routing operation at 20 Gb/s is possible at an electron drift velocity of 2/spl times/10/sup 7/ cm/s.     

Novel one-step route for synthesizing sub-micrometer PSt hollow spheres via redox interfacial-initiated method in inversed emulsion

Interfacial-initiated polymerization of styrene (St) was carried out in inversed emulsion with cumene hydroperoxide (CHPO) and ferrous sulfate (FeSO₄)/disodium ethylenediaminetetraacetate (NaEDTA)/sodium formaldehyde sulfoxylate (SFS) as the redox initiation system. The water-soluble Fe²⁺-NaEDTA-SFS acted as the reducing component and the oil-soluble CHPO as the oxidant component of the redox initiation system. Therefore, the primary radicals were produced mainly at the oil/water interface to initiate the polymerization of St. Thus, sub-micrometer hollow polystyrene (PSt) spheres were obtained by one-stage polymerization, which was supported by the techniques of transmission electron microscopy (TEM) and field emission scanning electron microscopy (FESEM).     

N-Type Field-Effect Transistors Using Multiple Mg-Doped ZnO Nanorods

Nanorod field-effect transistors (FETs) that use multiple Mg-doped ZnO nanorods and a SiO₂ gate insulator were fabricated and characterized. The use of multiple nanorods provides higher on-currents without significant degradation in threshold voltage shift and subthreshold slopes. It has been observed that the on-currents of the multiple ZnO nanorod FETs increase approximately linearly with the number of nanorods, with on-currents of ~1 muA per nanorod and little change in off-current (~4times10^-12). The subthreshold slopes and on-off ratios typically improve as the number of nanorods within the device channel is increased, reflecting good uniformity of properties from nanorod to nanorod. It is expected that Mg dopants contribute to high n-type semiconductor characteristics during ZnO nanorod growth. For comparison, nonintentionally doped ZnO nanorod FETs are fabricated, and show low conductivity to compare with Mg-doped ZnO nanorods. In addition, temperature-dependent current-voltage characteristics of single ZnO nanorod FETs indicate that the activation energy of the drain current is very low (0.05-0.16 eV) at gate voltages both above and below threshold     

2D Image Construction from Low Resolution Response of a New Non‐invasive Measurement for Medical Application

This paper presents an application of digital signal processing to data acquired by the radio imaging method (RIM) that was adopted to measure moisture distribution inside the human body. RIM was originally developed for the mining industry; we are applying the method to a biomedical measurement because of its simplicity, economy, and safety. When a two‐dimensional image was constructed from the measured data, the method provided insufficient resolution because the wavelength of the measurement medium, a weak electromagnetic wave in a VHF band, was longer than human tissues. We built and measured a phantom, a model simulating the human body, consisting of two water tanks representing large internal organs. A digital equalizer was applied to the measured values as a weight function, and images were reconstructed that corresponded to the original shape of the two water tanks. As a result, a two‐dimensional image containing two individual peaks corresponding to the original two small water tanks was constructed. The result suggests the method was applicable to biomedical measurement by the assistance of digital signal processing. This technique may be applicable to home‐based medical care and other situations in which safety, simplicity, and economy are important.     

泥土中微量六氯环戊二烯的气相色谱分析

采用SE 3 0为固定液进行色谱柱分离 ,用外标定量法测定泥土中的微量六氯环戊二烯 ,结果最小检知量为 0 .18× 10 - 6 ,相关系数为 0 .99992。     

WLAN chip antenna mountable above the system ground plane of a mobile device

A novel wireless local-area network (WLAN) chip antenna suitable to be mounted above the system ground plane of a mobile device is presented. The antenna in the study is easily fabricated from folding a single metal plate onto a foam base, and mainly comprises a short-circuited radiating strip and an antenna ground. The antenna ground occupies the bottom surface and two adjacent side surfaces of the foam base. When the antenna is mounted at the corner of the system ground plane, this antenna ground structure is expected to effectively reduce the antenna's possible fringing electromagnetic fields inside the mobile device. In this case, when the associated element such as the radio-frequency shielding metal case is placed under the proposed antenna, small or negligible variations in the antenna performance are obtained. Design considerations of the proposed antenna for WLAN operation in the 2.4 GHz band are described, and results of the constructed prototypes are presented.     

Design and analysis of low-power cache using two-level filter scheme

Power consumption is an increasingly pressing problem in modern processor design. Since the on-chip caches usually consume a significant amount of power, it is one of the most attractive targets for power reduction. This paper presents a two-level filter scheme, which consists of the L1 and L2 filters, to reduce the power consumption of the on-chip cache. The main idea of the proposed scheme is motivated by the substantial unnecessary activities in conventional cache architecture. We use a single block buffer as the L1 filter to eliminate the unnecessary cache accesses. In the L2 filter, we then propose a new sentry-tag architecture to further filter out the unnecessary way activities in case of the L1 filter miss. We use SimpleScalar to simulate the SPEC2000 benchmarks and perform the HSPICE simulations to evaluate the proposed architecture. Experimental results show that the two-level filter scheme can effectively reduce the cache power consumption by eliminating most unnecessary cache activities, while the compromise of system performance is negligible. Compared to a conventional instruction cache (32 kB, two-way) implemented with only the L1 filter, the use of a two-level filter can result in roughly 30% reduction in total cache power consumption. Similarly, compared to a conventional data cache (32 kB, four-way) implemented with only the L1 filter, the total cache power reduction is approximately 46%.     

Decreasing miscibility with greater heterogeneity in ternary polymer blend: poly(cyclohexyl methacrylate), poly(α‐methyl styrene) and poly(4‐methyl styrene)

A ternary blend system comprising poly(cyclohexyl methacrylate) (PCHMA), poly(α‐methyl styrene) (PαMS) and poly(4‐methyl styrene) (P4MS) was investigated by thermal analysis, optical and scanning electron microscopy. Ternary phase behaviour was compared with the behaviour for the three constituent binary pairs. This study showed that the ternary blends of PCHMA/PαMS/P4MS in most compositions were miscible, with an apparent glass transition temperature (T_g) and distinct cloud‐point transitions, which were located at lower temperatures than their binary counterparts. However, in a closed‐loop range of compositions roughly near the centre of the triangular phase diagram, some ternary blends displayed phase separation with heterogeneity domains of about 1 µm. Therefore, it is properly concluded that ternary PCHMA/PαMS/P4M is partially miscible with a small closed‐loop immisciblity range, even though all the constituent binary pairs are fully miscible. Thermodynamic backgrounds leading to decreased miscibility and greater heterogeneity in a ternary polymer system in comparison with the binary counterparts are discussed. © 2003 Society of Chemical Industry