Inhibition effect of carbon dioxide on the oxidation of hydrogen over a platinum foil catalyst

This paper investigates the catalytic ignition of the H₂/O₂/CO₂ mixture on platinum in a stagnation flow at atmospheric pressure experimentally and numerically. We measure the ignition temperatures of the gas mixtures flowing towards resistively heated platinum with various composition ratios and various diluent gases of N₂, Ar and CO₂. Compared with N₂ or Ar, the CO₂ dilution shows higher ignition temperature by about 50 K, even at the same composition ratio. The ignition temperature increase is proportional to the dilution ratio. Through the numerical simulation, it is illustrated that higher ignition temperature is caused by the adsorption of CO₂ and following dissociation on platinum surface, which was to date considered negligible in catalytic combustion.     

An adaptive p-persistent MAC scheme for multimedia WLAN

The letter proposes an adaptive p-persistent-based (APP) medium access control (MAC) scheme for the IEEE 802.11e distributed WLAN supporting multimedia services. The APP MAC scheme adaptively gives differentiated permission probabilities to transmission stations which are in different access category and with various waiting delay. Simulation results show that the APP MAC scheme can improve the performance of multimedia WLAN, such as small voice packet dropping probability, low delay variation, and high system throughput, compared to conventional MAC algorithms     

基于MATLAB的风能自校正自调整PID模糊控制器仿真研究

为了提高风力发电系统综合系统性能,在传统风力发电技术的基础上,对变速风力发电机组的自校正自调整PID模糊控制进行了详细的分析和研究,从而利用模糊控制和PID控制相结合的技术,取得了很好的效果。从MATLAB仿真结果看出系统精度及效率很高而稳态误差较小,鲁棒性较好。     

Measurement and numerical simulation of three‐dimensional fiber orientation states in injection‐molded short‐fiber‐reinforced plastics

To determine three‐dimensional fiber orientation states in injection‐molded short‐fiber composites, a confocal laser scanning microscope (CLSM) is used. Since the CLSM optically sections the specimen, more than two images of the cross sections on and below the surface of the composite can be obtained. Three‐dimensional fiber orientation states can be determined by using geometric parameters of fiber images obtained from two parallel cross sections. For experiments, carbon‐fiber‐reinforced polystyrene is examined by the CLSM and geometric parameters of fibers on each cross‐sectional plane are measured by an image analysis. In order to describe fiber orientation states compactly, orientation tensors are determined at different positions of the prepared specimen. Three‐dimensional orientation states are obtained without any difficulty by determining the out‐of‐plane angles utilizing fiber images on two parallel planes acquired by the CLSM. Orientation states are different at different positions and show the shell–core structure along the thickness of the specimen. Fiber orientation tensors are predicted by a numerical analysis and the numerically predicted orientation states show good agreement with measured ones. However, some differences are found at the end of cavity. They may result from the fountain flow effects, which are not considered in the numerical analysis. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 88: 500–509, 2003     

ESD protection design to overcome internal damage on interface circuits of a CMOS IC with multiple separated power pins

This paper reports a real case of electrostatic discharge (ESD) improvement on a complementary metal oxide semiconductor integrated circuit (IC) product with multiple separated power pins. After ESD stresses, the internal damage have been found to locate at the interface circuit connecting between different circuit blocks with different power supplies. Some ESD designs have been implemented to rescue this IC product to meet the required ESD specification. By adding only an extra ESD clamp N-channel metal oxide semiconductor with a channel width of 10 /spl mu/m between the interface node and the ground line, the human-body-model (HBM) ESD level of this IC product can be improved from the original 0.5 to 3 kV. By connecting the separated vertical sync signal (VSS) power lines through the ESD conduction circuit to a common VSS ESD bus realized by the seal ring, the HBM ESD level of the enhanced version IC product with 12 separated power supplies pairs can be significantly improved from original 1 kV up to > 5 kV, without the noise coupling issue.     

Using buried capacitor in LTCC-MLC balun

A novel chip-type ceramic balun designed in the 2.4 GHz ISM band frequency is presented. A buried capacitor is included in the balun, so that the length of the coupled transmission lines can be reduced and can be designed very easily. A meander or spiral broadside coupled-line is adopted to realise the proposed LTCC multi-layer balun. The measured performances of phase and amplitude balance for this LTCC-MLC balun show a good match with computer simulation     

A 1-V 10.7-MHz switched-opamp bandpass /spl Sigma//spl Delta/ modulator using double-sampling finite-gain-compensation technique

A 1 V switched-capacitor (SC) bandpass sigma-delta (/spl Sigma//spl Delta/) modulator is realized using a high-speed switched-opamp (SO) technique with a sampling frequency of up to 50 MHz, which is improved ten times more than prior 1 V SO designs and comparable to the performance of the state-of-the-art SC circuits that operate at much higher supply voltages. On the system level, a fast-settling double-sampling SC biquadratic filter architecture is proposed to achieve high-speed operation. A low-voltage double-sampling finite-gain-compensation technique is employed to realize a high-resolution /spl Sigma//spl Delta/ modulator using only low-DC-gain opamps to maximize the speed and to reduce power dissipation. On the circuit level, a fast-switching methodology is proposed for the design of the switchable opamps to achieve a switching frequency up to 50 MHz. Implemented in a 0.35-/spl mu/m CMOS process (V/sub TP/=0.82 V and V/sub TN/=0.65 V) and at 1 V supply, the modulator achieves a measured peak signal-to-noise-and-distortion ratio (SNDR) of 42.3 dB at 10.7 MHz with a signal bandwidth of 200 kHz, while dissipating 12 mW and occupying a chip area of 1.3 mm/sup 2/.     

Extended adaptive RBF equaliser for overcoming co-channelinterference

The authors investigate the problem of nonlinear adaptive equalisation in the presence of intersymbol interference, additive white Gaussian noise and co-channel interference. An extended radial basis function (RBF) network is proposed, in which regression weights are used in the output layer and the hidden unit is defined to have the Gaussian formula with the Mahalanobis distance. It is shown by simulation that the proposed structure gives reduced computational complexity without performance degradation, compared to that of the conventional RBF equaliser     

Inhibition of intratracheal lung cancer development by systemic delivery of E1A

Amplification or overexpression of HER-2/neu in human lung cancer has been correlated with poor prognosis and chemoresistance. We have previously reported that the adenovirus type 5 early region 1A (E1A) gene product can suppress HER-2/neu-mediated transformation phenotypes through inhibition of HER-2/neu expression. To find an efficient way to treat HER-2/neu-overexpressing lung cancer with E1A, a replication-deficient adenovirus containing the E1A gene, Ad.E1A(+), was used to transduce E1A into HER-2/neu-overexpressing and low expressing human lung cancer cell lines. Tumour cell growth in vitro and colony formation in soft agarose were greatly inhibited by Ad.E1A(+) transduction in HER-2/neu-overexpressing lung cancer cell lines. In HER-2/neu low expressing cell lines, E1A could not inhibit cell growth in vitro but could reduce the colony formation ability in soft agarose, indicating different effects of E1A in these two types of cancer cells. To test the therapeutic efficacy of E1A to lung cancer by systemic delivery in vivo, tumor-bearing mice were established by intratracheal injection of lung cancer cells and treated by i.v. tail injections of Ad.E1A(+). As a result, Ad.E1A(+) suppressed HER-2/neu overexpression and inhibited intratracheal lung cancer growth. However, no significant tumor suppression effect of Ad.E1A(+) was observed in mice bearing HER-2/neu low expressing cell line when the same therapeutic procedure was followed. Thus, we conclude that systemic delivery of Ad.E1A(+) can efficiently achieve therapeutic effect in HER-2/neu-overexpressing lung cancer in vivo.