宽带放大器可靠性问题浅析

叙述了国产高频宽带放大器的质量和可靠性现状，详细介绍了这类产品的质量一致性检验、可靠性摸底试验和现场使用过程中出现的可靠性问题，用统计的方法得出了可靠性特征量，通过对失效样品的失效分析，总结出宽带放大器主要的失效模式和失效机理，并提出了消除和减少失效、提高宽带放大器可靠性的措施和建议。     

深亚微米MOSFET衬底电流的模拟与分析

利用器件模拟手段对深亚微米ＭＯＳＦＥＴ的衬底电流进行了研究和分析，给出了有效的道长度，栅氧厚度，源漏结深，衬底掺杂浓度以及电源电压对深亚微米ＭＯＳＦＥＴ衬底电流的影响，发现电源电压对深亚微米ＭＯＳＦＥＴ的衬底电流有着强烈的影响，热载流子效应随电源电压的降低而迅速减小，当电源电压降低到一定程度时，热载流子效应不再成为影响深亚微米ＭＯＳ电路可靠性的主要问题。     

DIRECT RESONANCE OF TURBULENT BOUNDARY LAVER OVER COMPLIANT WALLS

１．　ＩＮＴＲＯＤＵＣＴＩＯＮＴｈｅｍａｉｎｇｏａｌｏｆｔｈｉｓｐａｐｅｒｉｓｔｏｅｘｐｌｏｒｅｔｈｅｐｏｓｓｉｂｉｌｉｔｙｔｏｌｅａｒｎｍｏｒｅａｂｏｕｔｔｈｅｍｅｃｈａｎｉｓｍｏｆｔｕｒｂｕｌｅｎｔｂｏｕｎｄａｒｙｌａｙｅｒｆｌｏｗｉｎｔｅｒａｃｔｉｏｎｓａｎｄｉｔｓｅｆｆｅｃｔｓｏｎｃｏｍｐｌｉａｎｔｗａｌｌｐｅｒｆｏｒｍａｎｃｅ．Ｔｈｅｒｅａｒｅｃｅｒｔａｉｎｐｒｅｒｅｑｕｉｓｉｔｅｃｏｎｄｉｔｉｏｎｓｔｏｆｕｒｔｈｅｒｔｈｅｓｔｕｄｙｏｎｔｈｅｍｅｃｈａｎｉｓｍ，ｉ．ｅ．ｔｈｅｃｏ…     

UHF频段卫星移动通信系统若干问题的探讨

本文根据我国陆海空移动用户的需求与特点，借鉴国外经验，提出了建设ＵＨＦ频段卫星移动通信系统的建议；对照已建成的Ｃ波段卫星固定通信系统，分析了其优缺点；最后深入探讨了应用中的若干技术问题。     

Grain Boundary Sliding in Fatigue of Pure Aluminum

The distributions of plastic strain near grain boundaries induced by fatigue loading were investigatedby the fiducial grid method in pure aluminum specimens, and the resulted grain boundary sliding(GBS) was systematically analysed. The results show that the strain field near a grain boundary isnonuniform. GBS is restricted by the junction of grain boundaries and causes discontinuities of bothdisplacement and strain. A peak value of shear strain was created in short-range area across the grainboundary. GBS plays an important role in cyclic softening and secondary hardening. The control fac-tor of GBS is the relative orientation between two grains and the macro orientation of the grainboundary rather than the ∑ value of the boundary.     

Microstructure-Property Correlation in AI_4C_3 Dispersion Strengthened Al Composite

The microstructure and tensile properties of Al_4C_3 dispersion strengthened Al composite fabricatedby reaction milling technique were investigated.It is indicated that the rod-like Al_4C_3 dispersoidshaving a diameter of 0.02-0.03 μm and a length of 0.1-0.3μm are formed by reaction of C with Al,and uniformly distributed in the Al matrix.The interface between Al_4C_3 and Al is clean and theinterfacial bonding is good.The matrix consists of the subgrains which have the size of 0.3-0.4μm,and most of the Al_4C_3 dispersoids are distributed on the subgrain boundaries.The 11 vol.-%Al_4C_3/Al composite exhibits an UTS (ultimate tensile strength) of 400 MPa and anelongation-to-failure of 8.0%.     

应用粒子动态分析仪研究水力旋流器流场

利用粒子动态分析仪(PDA),对水力旋流器内固相颗粒流场做了全面的测定,得出水力旋流器内固相颗粒的流态、浓度及粒度分布,为进一步查清水力旋流器的工作机理提供了重要理论依据。     

国外MCM及其主要制造技术的发展现状

MCM具有胜过PCB、LSI和一般HIC的诸多优点,正在逢勃发展,可望成为九十年代的代表性技术。本文从市场和技术两个方面评述MCM的发展潜力,重点介绍近年来国外MCM主要制造技术的现状及发展态势,试图引起人们对它的关注。     

混合Hermite-Lagrange插值之同时逼近

对于(-1,1)中的结点组{X_k}_(k=1)~n,记l_k(x)为相应的Lagrange插值基本多项式,又记A_n=‖∑(2-x~2-x_k~2)(1-x_k~2)~-1丨l_k(x)‖。对于f∈C_([-1,1)~q与r=[q+2/2],本文证明满足条件H_n(f,x_k)=f(x_k)(k=1,2,…,n),H_n~(s)(f,±1)=f~(s)(±1)(s=0,1,…,n-1)的n+2r-1次代数多项式H_n(f,x)有逼近性质H_n~(s)(f,x)-f~(s)(x)=(?)其中δ_n(x)=n~(-1)(1-x~2)~(1/2),△_n(x)=δ_n(x)+n~(-2).作为证明的重要工具,本文还对n次代数多项式P_n(x),建立了另一形式的Bernstein不等武:若 P_n(x)=O(1)δ_n~q(x)ω(δ_n(x)),则p_n~(S)(X)=O(1)δ_n~(q-2S)(X)ω(δ_n(X))△_n~s(X)。     

永恒的回答——维斯康尼的建筑艺术

本文以维斯康尼的四个建筑作品为例分析了其建筑设计的艺术特性。凭借对“限制”内涵的深入思考和领会，维斯康尼以其独特的手法和操作方式营建其作品的永恒性。