Commutation of SR motors

Commutation schemes for most common types of switched reluctance (SR) motors are presented. Commutation can be achieved using two- or three-positions sensors and a simple commutation logic in a similar fashion to brushless electronically commutated motors. The commutation logic can be easily housed on a programmable logic array (PLA) or similar device. Two-quadrant operation, usually with two position sensors with variable phase shift and dwell angles, can be tuned up to achieve optimum efficiency at low cost. Four-quadrant operation with multimode commutation schemes, such as normal, boost, longdwell, and brake, which cover most of the SR drive applications, can be easily implemented with simple logic control and feedback from low-resolution position sensors. The speed range can be increased beyond the limit reachable with pulse-width modulation (PWM). A 100% increase in the speed range can be easily obtained by switching modes     

Analysis of an antijam FH acquisition scheme

An easily implemented matched filter scheme for acquiring hopping code synchronization of incoming frequency-hopping (FH) signals is analyzed, and its performance is evaluated for two types of jamming: partial-band noise jamming and partial-band multitone jamming. The system is designed to reduce jammer-induced false alarms. The system's matched filter output is compared to an adaptive threshold that is derived from a measurement of the number of acquisition channels being jammed. Example performance calculations are given for the frequency coverage of the jamming either fixed over the entire acquisition period or hopped, that is, changed for each acquisition pulse. It is shown that the jammer's optimum strategy (the worst case) is to maximize the false alarm probability without regard for the effect on detection probability, for both partial-band noise and multitone jamming. It is also shown that a significantly lower probability of false acquisition results from using an adaptive matched filter threshold, demonstrating that the strategy studied here is superior to conventional nonadaptive threshold schemes     

A DBR laser tunable by resistive heating

A distributed Bragg reflector (DBR) laser tuned by resistive heating is presented. It has a tuning range greater than 10 nm with only a 33% reduction in output power and a 10% increase in linewidth. Its behavior is easily modeled, agreeing well with simple theory     

Best ROBDD variable ordering for functions with disjunctivedecompositions

The problem of finding a variable ordering to minimise the size of a reduced ordered binary decision diagrams (ROBDD) is considered for functions possessing disjunctive decompositions. An example is presented showing that the best ordering for a function with a disjunctive decomposition cannot always be directly determined from the best orderings for the component functions     

Fast adders using enhanced multiple-output domino logic

Using an enhanced multiple output domino logic (EMODL) implementation of a carry lookahead adder (CLA), sums of several consecutive bits can be built in one nFET tree with a single carry-in. Based on this result, a new sparse carry chain architecture is proposed for the CLA adder. We demonstrate the design approach using a 32-b adder, and show that only four carries are sufficient for generating all sums, with a consequent reduction in the number of stage delays. Using a 1.2-μm CMOS technology, we verify our simulation procedures by fabrication and measurement of a 2.7 ns critical path     

Reconfigurable optoelectronic wavelength translation based on anintegrated electroabsorption modulated laser array

Reconfigurable optoelectronic wavelength conversion to 11 100-GHz spaced wavelengths is achieved using a wavelength selectable laser array with an integrated electroabsorption (EA) modulator at a bit rate of 2.5 Gb/s. Wide dynamic range at the input from -24.2 to -6.5 dBm is achieved and uniform back-to-back transmission performance is measured for all wavelengths     

Adaptive detection of DS/CDMA signals in fading channels

This paper examines the behavior of the minimum mean-squared error (MMSE) receiver in frequency-nonselective-fading channels. It is noted that the MMSE receiver will often lose phase lock on the desired signal when the desired signal dips into a deep fade. A modification to the MMSE receiver is presented which is demonstrated to function quite nicely in flat-fading channels. Analytical results for the modified MMSE receiver are presented and found to agree very well with simulation results. These analytical results are then compared to the theoretical performance of the conventional (i.e., correlator) receiver in terms of both bit-error rate (BER) and capacity. As expected, the modified MMSE receiver was found to offer a substantial improvement in both BER and capacity. Finally, a simple empirically derived formula is given which will give a good approximation to the BER of the modified MMSE receiver in a Rayleigh-fading environment. This formula can also be used to determine the number of users a given system can support. It is noted that as E_b/N₀ grows, it is quite feasible to approach 100% channel utilization with the MMSE receiver, whereas a conventional receiver is typically limited to a utilization of 10%-20%     

vBNS: not your father's Internet

The very-high-performance Backbone Network Service (vBNS) is an important part of ongoing efforts by government, industry, and academia to push the state of the art in Internet technologies and academic research applications. It is dedicated to serving research and education institutions whose scientific endeavors require networking performance not possible or not practical with commercial network services. Currently, the vBNS is implemented as an IP-over-ATM network-that is, its network layer (layer 3 of the open systems interconnection reference model promulgated by the International Organization for Standardization) runs the Internet Protocol on top of the asynchronous transfer mode protocol. Those protocols, in turn, run on a synchronous optical network (Sonet) OC-12-622.08-Mb/s-infrastructure. Though access was originally limited to five supercomputer centers and four network access points, the National Science Foundation's High-Performance Connections program is now expanding the vBNS to reach over 100 institutions. The vBNS also has connections to other research networks, both within the United States and abroad. Before describing the architecture of the vBNS, the services it provides, and the metrics developed to assess its performance, the article reviews the background against which it came into being. It also briefly discusses how the vBNS relates to the Next Generation Internet (NGI) and Internet2     

Adaptive multiwavelet initialization

The multiwavelet concept uses a set of scaling functions and a set of wavelets to generate an orthogonal multichannel multiresolution pyramid decomposition for finite energy signals. The multiple scaling functions extract the lowpass information of the input data set, and the multiwavelets extract the bandpass information. When the lowpass filters associated with the scaling functions are cascaded, a multiresolution pyramid decomposition/reconstruction system is formed with each pyramid convolution operator having several inputs and several outputs. However, there is only one data set available to initialize this process. This paper addresses the question of how to best modify the data set using prefilters so that its decomposition contains the most useful information for the chosen application. The “best” prefilters are determined by the minimization of the energy of preselected decomposition components. The resulting decomposition is, therefore, signal adaptive, and under appropriate conditions, perfect reconstruction of the input data set can be achieved with a proper postfiltering. The detailed discussions in the paper are focussed on the two-wavelet and two-scaling function case; the general multiwavelet case is addressed at the end of the paper. A compression example is provided to demonstrate the performance of the optimally initialized multiwavelet method and to compare it with a single wavelet method and another multiwavelet initialization method proposed by other authors