Elimination of beta-blockers in sewage treatment plants

beta-Blockers are used to treat high blood pressure as well as patients recovering from heart attacks. In several studies, they were detected in surface water, thus indicating incomplete degradability of these substances in sewage treatment plants (STPs). In this study, we determined the sorption coefficients (K(D)) and degradation rates of the four beta-blockers sotalol, atenolol, metoprolol and propranolol in sludge from an STP operating with municipal wastewater. The sorption coefficients (K(D), standard deviations in brackets) were determined as 0.04(+/-0.035), 0.04(+/-0.033), 0.00(+/-0.023) and 0.32(+/-0.058) Lg(-1)(COD), and the pseudo-first-order degradation rate constants were estimated to be 0.29(+/-0.02), 0.69(+/-0.05), 0.58(+/-0.05) and 0.39(+/-0.07) Ld(-1)g(-1)(COD) for sotalol, atenolol, metoprolol and propranolol, respectively. These values translate into a typical elimination in STPs (sludge concentrations of 4g(COD)L(-1) and a hydraulic retention time of 6h) of 25%, 37%, 44% and 50% for sotalol, propranolol, metoprolol and atenolol, respectively. These results are also confirmed by measurements in two municipal STPs for atenolol, sotalol and propranolol. The estimated eliminations are slightly too high for metoprolol.     

Non-destructive evaluations of water uptake in epoxy coating

A commercial epoxy coating was studied on steel panels and as free films to investigate water uptake using non-destructive techniques (gravimetric analysis, Electrochemical Impedance Spectroscopy [EIS], Attenuated Total Reflection-Fourier Transform Infrared Spectroscopy [ATR-FTIR], and Scanning Acoustic Microscopy [SAM]) after immersion in 3.5 wt% NaCl solution. In epoxy free films, water uptake showed rapid absorption initially, slowing down due to the counteracting process between water uptake and leachable content. Later, a mass decrease indicated leaching dominance. On coated steel, EIS revealed rapid water absorption within 72 h, followed by slower uptake up to 336 h. The continuous increase in water content resulted from observed coating layer swelling, confirmed by SAM. ATR-FTIR analysis indicated hydrogen bonding of most absorbed water molecules to the epoxy matrix. By combining non-destructive techniques, water uptake mechanisms into the epoxy coating film were proposed.     

Involvement of glucocorticoids in testicular involution after active immunization of boars against GnRH

Active GnRH immunization of boars inhibits LH and testicular steroids but the consequences for spermatogenesis are unknown. Six boars were immunized three times against GnRH at 20, 24 and 28 weeks. Another six boars served as controls. Plasma LH and FSH were determined at 28 and 31 weeks. Testosterone and cortisol were determined before killing the pigs at 32 weeks. Tissue samples were taken for histology and fluid from the seminiferous tubuli for steroid determination. Individual germ cells were counted in histological sections. The glucocorticoid receptor (GCR), mitosis of spermatogonia and apoptosis were characterized by immunocytochemistry. Immunization reduced LH and testosterone to base levels whereas FSH was not changed. Testis weight was reduced by 64% due to a loss of Leydig cell cytoplasm (90.3%) and a decrease of tubule diameters (60.6%). Except for A-spermatogonia, all other spermatogenic cells were reduced by about 60%. Mitosis was reduced in immunized boars. Expression of GCRs was limited to spermatogonia and differed between immunized boars (8% of spermatogonia) and controls (2%). In the controls, androgen concentrations in tubular fluid were tenfold higher compared with immunized boars. Cortisol concentrations were of the order of 40 nmol/l both in the tubular fluid and blood plasma. These concentrations did not differ between groups. Apoptosis occurred only in spermatogonia and pachytene spermatocytes and was twofold higher in immunized boars compared with controls. Thus the availability of glucocorticoids in the tubuli and the expression of GCRs initiate apoptosis, which in turn reduces sperm yield. Testosterone is known to be an inhibitor of GCR expression, thus increasing the efficiency of spermatogenesis.     

Aluminium Foil as a Food Packaging Material in Comparison with Other Materials

Aluminium foil is an important material in laminates and has wide application in food packaging. Its barrier function against the migration of moisture, oxygen and other gases, and volatile aroma, as well as against the impact of light is generally higher than any plastic laminate material. Therefore, aluminium foil is used in the laminates when insufficient barrier properties are the limiting factor for shelf-life stability of food. The barrier properties of aluminium-coated plastic laminates, which can offer an alternative to aluminium foil laminates, are somewhat less efficient. The use of aluminium foil in rigid, semirigid, and flexible package for in-pack thermal processing allows the selection of package geometries that ensure rapid heating and minimum heat damage during processing. On the tightness of packages, the mechanical stability and quality of sealing is of particular importance. The chemical stability of aluminium foil in contact with food depends on the composition of the food items. With present toxicological knowledge, the use of aluminium in packaging material is considered to be safe, and inner-coating of the foil is recommended in specific cases.     

Antimicrobial enzymes: Applications and future potential in the food industry

Antimicrobial enzymes are ubiquitous in nature, playing a significant role in the defense mechanisms of living organisms against infection by bacteria and fungi. Hydrolytic antimicrobial enzymes function by degrading key structural components of the cell walls of bacteria and/or fungi, whereas antimicrobial oxidoreductases exert their effects by the generation in situ of reactive molecules. The potential of these enzymes in food preservation is still far from realized at present.     

Carbon Dioxide Evolution and Moisture Evaporation During Roasting of Coffee Beans

ABSTRACT: Evolution of carbon dioxide and water vapor during roasting of coffee was followed in an isothermal high-temperature short-time and a low-temperature long-time roasting process. In addition, CO₂ release during storage of roasted beans was followed. CO₂ and water vapor concentration were assayed in the exhaust air by nondispersive infrared gas analysis. Although CO₂ evolution rates differed in the 2 processes, the final total amount of CO₂ released after 63 d of storage remained equal. CO₂ evolution and differentiation between evaporation of initial water and chemically formed water showed that chemical reactions leading to relevant amounts of CO₂ and water start at ap -proximately 180°C. A mass balance established on the present measurements was able to account fairly well for the gravimetrically measured roast loss.     

Nonproteolytic Clostridium botulinum toxigenesis in cooked turkey stored under modified atmospheres

The ability of nonproteolytic Clostridium botulinum type B spores to grow and produce toxin in cooked, uncured turkey packaged under modified atmospheres was investigated at refrigeration and mild to moderate abuse temperatures. Cook-in-bag turkey breast was carved into small chunks, surface-inoculated with a mixture of nonproteolytic C. botulinum type B spores, packaged in O2-impermeable bags under two modified atmospheres (100% N2 and 30% CO2:70% N2), and stored at 4, 10, and 15 degrees C. Samples were analyzed for botulinal toxin and indigenous microorganisms, as well as subjected to sensory evaluation, on days 0, 7, 14, 28, 42, and 60. Given sufficient incubation time, nonproteolytic C. botulinum type B grew and produced toxin in all temperature and modified atmosphere treatment combinations. At moderate temperature abuse (15 degrees C), toxin was detected by day 7, independent of packaging atmosphere. At mild temperature abuse (10 degrees C), toxin was detected by day 14, also independent of packaging atmosphere. At refrigeration temperature (4 degrees C), toxin was detected by day 14 in product packaged under 100% N2 and by day 28 in product packaged under 30% CO2:70% N2. Reduced storage temperature significantly delayed toxin production and extended the period of sensory acceptability of cooked turkey, but even strict refrigeration did not prevent growth and toxigenesis by nonproteolytic C. botulinum. At all three storage temperatures, toxin detection preceded or coincided with development of sensory characteristics of spoilage, demonstrating the potential for consumption of toxic product when spoilage-signaling sensory cues are absent.     

The Haskell Refactorer, HaRe, and its API

We demonstrate the Haskell Refactorer, HaRe, both as an example of a fully-functional tool for a complete (functional) programming language, and to show the API which HaRe provides for building source-level program transformations for Haskell. We comment on the challenges presented by the construction of this and similar tools for language frameworks and processors.     

Photocatalytic Valorization of Plastic Waste over Zinc Oxide Encapsulated in a Metal–Organic Framework

The conversion of waste plastic into high-value-added chemicals is regarded as a promising approach for relieving global plastic pollution and contributing to the circular economy. Herein, a partial calcination strategy is developed to fabricate a zinc oxide/UiO66-NH₂ (ZnO/UiO66-NH₂) heterojunction, in which ZnO is encapsulated in porous UiO66-NH₂ for the photocatalytic valorization of plastic. This strategy preserves the framework structure of UiO66-NH₂, thus enabling the formation of ZnO with ultra-small size distributed inside the skeleton. The synergistic effect of the obtained ZnO/UiO66-NH₂ heterojunction facilitates providing an efficient channel for carrier/mass transfer and guarantees structural stability. As a result, ZnO/UiO66-NH₂ exhibits high activity for converting polylactic acid (PLA) and polyvinyl chloride (PVC) into acetic acid, coupled with H₂ production. This work provides a feasible strategy for rationally designing heterojunction photocatalysts, as well as an insight into understanding the process of photocatalytic valorization of plastic.     

Natural versus wastewater derived dissolved organic carbon: implications for the environmental fate of organic micropollutants

The interaction of organic micropollutants with dissolved organic carbon (DOC) can influence their transport, degradation and bioavailability. While this has been well established for natural organic carbon, very little is known regarding the influence of DOC on the fate of micropollutants during wastewater treatment and water recycling. Dissolved organic carbon-water partition coefficients (K_DOC) for wastewater derived and reference DOC were measured for a range of micropollutants using a depletion method with polydimethylsiloxane disks. For micropollutants with an octanol-water partition coefficient (log K_OW) greater than 4 there was a significant difference in K_DOC between reference and wastewater derived DOC, with partitioning to wastewater derived DOC over 1000 times lower for the most hydrophobic micropollutants. The interaction of nonylphenol with wastewater derived DOC from different stages of a wastewater and advanced water treatment train was studied, but little difference in K_DOC was observed. Organic carbon characterisation revealed that reference and wastewater derived DOC had very different properties due to their different origins. Consequently, the reduced sorption capacity of wastewater derived DOC may be related to their microbial origin which led to reduced aromaticity and lower molecular weight. This study suggests that for hydrophobic micropollutants (log K_OW > 4) a higher concentration of freely dissolved and thus bioavailable micropollutants is expected in the presence of wastewater derived DOC than predicted using K_DOC values quantified using reference DOC. The implication is that naturally derived DOC may not be an appropriate surrogate for wastewater derived DOC as a matrix for assessing the fate of micropollutants in engineered systems.