The performance of activated sludge plants compared with the results of various bacterial toxicity tests—A study with 3,5-dichlorphenol

It was investigated whether and to what extent the results obtained by various methods of determining bacterial toxicity in waste water could be applied to conditions prevailing in activated sludge plants or in receiving water.3.5-Dichlorphenol (DCP) was studied as an example of a persistent chemical which constitutes a pollution risk to water. The bacterial toxicity limits determined by five different methods—respiration after a 20-h consumption period, consumption rate after 2-h incubation, dehydrogenase activity determined with TTC. gas formation in a fermentation tube and inhibition of the cell division of Pseudomonas—all agreed with the toxicity limit of 5 mg DCP I⁻¹ found in degradation tests in laboratory activated sludge equipment. No safety margin need be taken into account when the test results are applied to biological purification plants.In the activated sludge plants the degradation of the industrial waste water was markedly impaired only when the DCP concentration was increased to 25 mg I⁻¹. This varied in degree according to the sludge load at the beginning of the trial.Shock loads of DCP did not cause the expected fall-off in degradation but only a moderate fluctuation in its rate. The decline in degradation following continuous and also discontinuous addition of DCP was largely or completely overcome within a few weeks by the bacteria becoming adapted to DCP.In samples of river water the toxicity limit as determined by the tests was in the region of 2 mg I⁻¹.     

Treatment of gas-phase methanol in conventional biofilters packed with lava rock

The performance of laboratory scale methanol-degrading biofilters packed with lava rock was checked during almost 1 yr under different conditions. The biomass concentration and biomass adaptation of the inoculum dramatically affected the start-up and the performance of the systems during the first stages of operation. A fast start-up was obtained when using concentrated and adapted inocula, while diluted or non-adapted inocula proved to be much less efficient. The performance of the reactor during long-term operation was significantly affected by the toxic load and moisture content of the gas. Critical loads between 120 and 280 g/m(3)h were reached during different phases of the study. The reactor had a high stability to EBRT changes when working at values between 48.0 and 91.1s, showing little or no negative effect when decreasing the EBRT. Hardly any difference was observed regarding performance when using either a downflow or upflow feed, although slightly better results were obtained when working in a downflow mode.     

Effect of agitation, turbidity, aluminium foil reflectors and container volume on the inactivation efficiency of batch-process solar disinfectors

We report the results of experiments designed to improve the efficacy of the solar disinfection of drinking water, inactivation process. The effects of periodic agitation, covering the rear surface of the container with aluminium foil, container volume and turbidity on the solar inactivation kinetics of Escherichia coli (starting population = 10(6) CFU ml(-1)) were investigated. It was shown that agitation promoted the release of dissolved oxygen from water with subsequent decrease in the inactivation rates of E. coli. In contrast, covering the rear surface of the solar disinfection container with aluminium foil improved the inactivation efficiency of the system. The mean decay constant for bacterial populations in foil-backed bottles was found to be a factor of 1.85 (std. dev. = 0.43) higher than that of non-foil-backed bottles. Inactivation rates decrease as turbidity increases. However, total inactivation was achievable in 300 NTU samples within 8 h exposure to strong sunshine. Inactivation kinetics was not dependent on the volume of the water container for volumes in the range 500-1500 ml.     

Nitrogen inputs to stream water from forests along an elevational gradient in New Mexico

Studies of nitrogen inputs in precipitation and outputs in stream water for a number of terrestrial ecosystems support the hypothesis that undisturbed communities have the ability to reduce losses of nitrogen via stream water. In spite of different levels of biomass, productivity and stream discharge for these communities, net losses of nitrogen were similar. Maintaining nitrogen in an organic or cation form (NH₃, NH₄⁺) is an important factor in minimizing loss. This may be accomplished by slow rates of mineralization, rapid plant uptake, and denitrification through the electron sink pathway. Denitrification by the dissimilatory pathway may also be important.     

Environmental Implications of Treatment of Coastal Sewage Discharges

The environmental implications of implementing the requirement for treatment of coastal sewage prior to discharge, which were put forward in an EC draft Directive on municipal waste-water treatment, are examined. In order to establish the current situation, the results of a national survey of coastal and estuarine sewage discharges are presented. A review of the impact of sewage discharges on the marine environment is presented in conjunction with an assessment of the impact of sewage-treatment processes on the land and in the air. These aspects are integrated into overall conclusions about net environmental impact. Finally, a decision-tree approach to the assignment of priority to additional action required at individual locations is developed.     

Analysis of foundation installation for old buildings in downtown Saint Petersburg

Basic types of foundations supporting old buildings in Saint Petersburg are reviewed. Fundamental relationships between the width and depth of embedment of the foundations and the number of stories are analyzed on the basis of field observations. Average pressures against the lower surfaces of the foundations are compared with design strengths adopted from modern standards for bed soils.Translated from Osnovaniya, Fundamenty i Mekhanika Gruntov, No. 5, pp. 13–15, September–October, 2004.     

What can be taught in architectural design? — <Emphasis Type="Italic">parti,poché</Emphasis>, and felt qualities

This essay begins with a reflection on what has been taught in architectural design since the turn of the twentieth century. I shall trace back to the two disciplinary foundations of the French École des Beaux-Arts — parti and poché — in the education of an architect in the eighteenth and nineteenth centuries. I shall then attempt to superimpose parti and poché on a modern disciplinary framework, say that of mathematics, which leads to musings on a series of architectural problems that include pattern versus type, stability versus mobility, orthogonal versus oblique, confinement versus transparency, and aging versus metallic sheen. These paradoxes, I suggest, demand the education of an architect to address both the instrumental pattern of a building configuration and the ambient felt qualities of a room, rather than vision alone.     

ASSESSING AND MANAGING THE RISKS OF PATHOGEN TRANSFER FROM LIVESTOCK MANURES INTO THE FOOD CHAIN

A review was undertaken of (a) the levels and prevalence of Salmonella spp., Campylobacter spp., Listeria monocytogenes, Escherichia coli 0157. Cryptosporidium parvum and Giardia intestinalis in livestock manure, and (b) factors which affect their survival during storage and following land application. Pathogens are commonly present in livestock manures and can survive in soil for several months or years after spreading or excretion onto land. Temperature was identified as being the most important factor influencing pathogen survival, although pH, UV light and drying were also important. Various practical measures to minimise the risk of pathogen transfer into the food chain were identified, including treatment, extended storage and no/harvest periods following land spreading. Guidelines are being developed on managing farm manures to minimise the risks of microbiological contamination of ready-to-eat crops.     

Full scale fire tests for ship accommodation quarters

Ten full-scale test fires were conducted in a chamber simulating a three person ship accommodation quarter. The test fires used three different ventilation conditions, two types of bunks and furnishings with either polyurethane foam or chloroprene foam. The chamber was instrumented to follow the development of the fire.The furnishings with polyurethane foam were readily ignited and produced an intense fire within 2 to 4 minutes. The furnishings with chloroprene foam ignited but burned slowly with a small flame or in smoldering combustion.The ventilation conditions had a significant effect on the development and intensity of the fire as the test fires were burning under oxygen-limiting conditions.The solid pan bunks retarded the early development of the fire compared to open bunks for polyurethane furnishings. However, once the mattresses on the three bunks were ignited the intensity of the test fires was similar for both types of bunks.