Continuous cleaning of A356 alloy melt using high frequency electromagnetic field

A set of device for electromagnetic separation (EMS) was designed and applied to process the continuous flowing melt. Tensile test was employed to compare effect of electromagnetic separation with that of the traditional processes. Compared with filtration by ceramic foam filter and process without filtration, multiple process combined with filtration and electromagnetic separation can effectively remove most of inclusions with diameter finer than 10μm in A356 alloy casting, hence improve its tensile properties. After being processed by electromagnetic filtration,the tensile strength of A356 scrap is enhanced by 8.27%, approaching the level of fresh A356 alloy.     

凝汽器管泄漏在线检测系统的开发

在分析各种凝汽器管泄漏检测方法的基础上，针对凝汽器泄漏的检测现状提出了基于示踪气体的凝汽器管泄漏在线检测系统。该系统把六氟化硫气体作为示踪气体，用两相流的方法喷射到凝汽器管中，如有泄漏则将进入真空室，在尾气中收集示踪气体并由此判断是否存在泄漏及确定泄漏的区域。检测系统主要包括气体处理和喷射系统、漏孔定量和定位系统及自动控制系统等。电厂的应用证明系统能够达到理想的效果。     

1 250 mm五机架六辊冷连轧工艺控制系统核心技术

简要介绍了自主设计制造、具有完全自主知识产权的1 250 mm五机架六辊冷连轧产线工艺及设备特点。重点阐述了冷连轧工艺控制系统的硬件配置、软件架构及核心技术。采用基于简易有限元的轧制力模型及基于成本函数的多目标负荷分配模型，实现了高精度的轧制规程计算。开发了原料板快速启车技术与板形多变量综合最优控制技术，实现了冷轧产品的尺寸精准控制。现场实际应用效果表明，机组稳定运行率达到99.8%以上，不同规格的产品厚度控制精度均达到±0.8%以内，板形控制精度均达到5I以内。     

利用高频磁场制备自生梯度复合材料的熔体温度选择

研究了通过在熔体凝固过程中的不同温度范围施加高频磁场制备自生梯度复合材料的工艺.对于Al/Mg2Si/Si自生梯度复合材料,近似计算及实验结果表明:Al Mg2Si二元共晶区(555～595C)是施加高频磁场的最佳温度范围,此时处于低粘性熔体中的增强颗粒容易被外加电磁阿基米德力分离.高频磁场施加温度过高或过低,均不易使增强颗粒产生梯度分布效果.     

Supported Molybdenum Carbides Lie Between Metallic and Sulfided Catalysts for Deep HDS

Hydrodesulfurization (HDS) of 4,6-dimethyldibenzothiophene on alumina-supported Mo₂C has been studied. These catalysts are stable and active under deep HDS conditions (0-250 wt ppm S). However, although they are well known to have hydrogenation properties, they lead preferentially to a non-hydrogenated product of the HDS reaction: dimethylbiphenyl. For the same reaction, supported platinum and sulfided molybdenum oxide lead to the hydrogenated products dimethyldicyclohexyl and methylcyclohexyltoluene, respectively. The ranking of HDS activity is as follows: MoS₂/Al₂O₃ < Mo₂C/Al₂O₃ < Pt/SiO₂.     

单螺杆挤出过程的数值模拟

以三段七区物理模型为基础，采用面向对象程序设计语言VisualC ，对整个单螺杆挤出过程进行了数值模拟。所得压力。温度等工艺参数的模拟结果与实验值吻合较好，说明采用数学模型的正确性和数值算法的可行性。     

Visual discovery of the correlation between BGP routing and round-trip delay active measurements

Inter-domain routing data and Internet active probing measurements are two types of information commonly available in huge datasets and subject to extensive, focused analysis. However, the study of the correlation between these two complementary types of information still remains one of the most challenging problems in today’s research in networking. In this paper we describe a metaphor for the visualization of the interplay between the routing information exchanged via BGP and the round-trip delay measurements collected by several geolocated probes. We implemented a prototype based on the above metaphor. Our prototype highlights both the Autonomous System topology and the latency associated with each AS-path over time. Further, it shows how probes are partitioned into clusters associated with each border gateway, based on observed traffic patterns. The resulting visualization allows the user to explore the dynamics of the correlation between the two types of information.     

高效镇痛剂依托啡的合成

以蒂巴因为原料，经三步反应合成了高效镇痛剂依托啡，总产率由原来的１９．１％提高到３５．９％，并对各单元反应的条件及影响因素进行了探讨。     

PET/纳米SiO2复合材料的制备(Ⅱ):纳米SiO2在PET中的分散性研究

研究了分散方法、纳米材料的加入体系、分散时间、分散剂的种类及SiO2 的加入量对纳米SiO2 在PET/纳米SiO2 中分散性的影响 ,用TEM对其分散情况进行表征 ,并对其分散机理进行探讨与研究。其结果表明 :采用球磨分散法并以氨基硅烷A1 1 2 0分散剂时分散效果最佳 ;当分散时间达 7 5h时 ,分散液中SiO2 基本以纳米尺寸存在 ;将分散液加入对苯二甲酸二甲酯熔体中并在球磨状态下进行酯交换SiO2 的分散效果最好 ,1 0 0nm以下的SiO2 达 95 0 7% ;体系中随SiO2 量的增加 ,其分散性变差 ,当纳米SiO2 的加入量为 1 %～ 4 %时 ,粒径在 1 0 0nm以下的SiO2 由 88%下降到 61 %。     

不饱和聚酯树脂光固化工艺的研究-光引发剂浓度

本文选用TPO、651两种光引发剂，分别配制引发剂浓度为0．25、0．5、1、2wt％的不饱和聚酯体系。通过测定光固化试样的显微硬度分析光引发剂浓度对固化程度的影响。结果表明，提高引发剂浓度能抑制氧阻聚的作用，但对于较厚的试样，引发剂浓度过高会导致固化不完全。