Dynamics of coupled and uncoupled two-phase flows in a slab mold

Two-phase flows in a mold of a slab caster are studied using water modeling, particle-image velocimetry (PIV), and computational fluid-dynamics techniques. Two-way coupled flows are observed in liquidgas systems, because both phases influence each other’s momentum transfer. In addition to this concept, PIV measurements indicate the existence of structurally coupled flows, where the velocity vectors of both phases observe similar orientations. When the drag forces of the liquid, exerted on the bubbles, exceed a certain value of the inertial forces of the liquid phase, at high mass loads of gas (ratio of mass flow rates of the gas phase and the liquid phase), the flow becomes structurally coupled. These types of flows promote large oscillations of the meniscus level. Two jets, liquid and bubble, were identified; the latter always reported larger angles than the first, independent of the gas load. Thus, a gas-rich jet is located closer to the lower edge of the submerged entry nozzle (SEN) port, and the liquid-rich jet is found above this position. The liquid-jet angle approaches that of the SEN port when the flow becomes structurally coupled. Structurally uncoupled flows report gas jets that follow torrent-type patterns which are well explained using a multiphase fluid-dynamics model. Structurally coupled flows yield gas jets with a continuous pattern.     

Quattor: Tools and Techniques for the Configuration,Installation and Management of Large-Scale Grid Computing Fabrics

This paper describes the quattor tool suite, a new system for the installation, configuration, and management of operating systems and application software for computing fabrics. At present Unix derivatives such as Linux and Solaris are supported. Quattor is a powerful, portable and modular open source solution that has been shown to scale to thousands of computing nodes and offers a significant reduction in management costs for large computing fabrics. The quattor tool suite includes innovations compared to existing solutions which make it very useful for computing fabrics integrated into grid environments. Evaluations of the tool suite in current large scale computing environments are presented.     

Outlier Detection and Data Cleaning in Multivariate Non-Normal Samples: The PAELLA Algorithm

A new method of outlier detection and data cleaning for both normal and non-normal multivariate data sets is proposed. It is based on an iterated local fit without a priori metric assumptions. We propose a new approach supported by finite mixture clustering which provides good results with large data sets. A multi-step structure, consisting of three phases, is developed. The importance of outlier detection in industrial modeling for open-loop control prediction is also described. The described algorithm gives good results both in simulations runs with artificial data sets and with experimental data sets recorded in a rubber factory. Finally, some discussion about this methodology is exposed.     

High Performance Air Pollution Simulation Using OpenMP

The aim of this work is to provide a high performance air quality simulation using the sulphur transport Eulerian model 2 (STEM-II) program. First of all we optimize the sequential program with the aim of increasing data locality. Then, the optimized program is parallelized using OpenMP shared-memory directives. Experimental results on a 32-processor SGI Origin 2000 show that the parallel program achieves important reductions in the execution times.     

Hygrothermal properties of glass fiber reinforced cements subjected to elevated temperature

The effect of elevated temperatures on basic hygric and thermal properties of three types of glass fiber reinforced cement composites (GFRC) is analyzed in the paper. The main difference in the composition of particular GFRC is the use of wollastonite and vermiculite in two of them instead of usual sand aggregates. The composites containing wollastonite and vermiculite are found to have about four times lower thermal conductivity and two to three times lower thermal diffusivity in room temperature conditions. After heating the samples to 800°C and subsequent cooling, a decrease in room-temperature thermal conductivity as high as 50% and an increase in moisture diffusivity in the range of one to two orders of magnitude are observed for all types of studied materials. The application of wollastonite and vermiculite exhibits a positive effect on the high temperature linear thermal expansion coefficient. On the other hand, for temperatures higher than 450°C the thermal diffusivity of materials with wollastonite and vermiculite is higher than of common GFRC with sand aggregates.

---

Résumé L'effet des températures élevées sur les principales propriétés hygriques et thermiques de trois types de matériaux composites à base de ciment renforcés par des fibres de verre (GFRC) est analysé dans cet article. La différence majeure de composition de ces matériaux est l'utilisation de wollastonite et de vermiculite dans deux d'entre eux au lieu des granulats de sable habituels. Les matériaux composites contenant de la wollastonite et de la vermiculie s'avèrent posséder une conductivité thermique environ quatre fois inférieure et une diffusivité thermique deux à trois fois inférieure en conditions de température ambiante. Après avoir chauffé les échantillons à 800°C puis les avoir refroidis, on observe pour tous les types de matériaux étudiés une diminution de la conductivité thermique à température ambiante, à hauteur de 50%, et une augmentation de la diffusivité d'humidité, d'environ un à deux ordres de grandeur. L'application de la wollastonite et de la vermiculite montre un effet positif sur le coefficient linéaire à haute température de dilatation thermique. D'autre part, pour les températures supérieures à 450°C, la diffusivité thermique des matériaux contenant de la wollastonite et de la vermiculite est plus élevée que celle des GFRC communs avec des granulats de sable.

     

Anomalous Excess Heat Capacities of Ethanol + Alkane Mixtures

A thermodynamic study at atmospheric pressure on the ethanol + n-dodecane and ethanol + n-tridecane binary systems near their liquid-liquid critical points has been carried out. To this end, densities and speeds of sound were determined in the temperature range from 288.15 to 308.15 K, whereas differential scanning calorimetry was used to obtain isobaric heat capacities per unit volume from 288.15 to 303.15 K as well as liquid-liquid equilibrium curves. All these results for the mentioned properties were obtained over the complete composition range. They were used to obtain molar volumes, isentropic compressibilities, isobaric thermal expansivities, isothermal compressibilities, isochoric heat capacities, and the excess quantities of all these properties. An untypical behavior of the excess heat capacities at the lowest measuring temperatures resulting from the critical behavior of the isobaric heat capacity is observed. No clear anomalies for the excess volumetric properties are detected.     

Large Deflection Stability of Slender Beam-Columns with Semirigid Connections: Elastica Approach

The large-deflection elastic analysis of slender beam-columns of symmetrical cross sections with semirigid connections under end loads (forces and moments) including the effects of out-of-plumbness is developed in a classical manner. The classical theory of the “Elastica” and the corresponding elliptical functions are utilized in the proposed method which can be used in the large-deflection stability analysis of slender beam-columns with rigid, semirigid, and simple connections under any combination of end loads (conservative and nonconservative). The proposed method consisting of a closed-form solution of the Elastica can also be utilized in the large deflection analysis of beam-columns whose connections suffer from flexural degradation or, on the contrary, flexural stiffening. The main limitation of the Elastica is that only flexural strains are considered (the effects of axial and shear strains are neglected). Therefore results from the proposed method are theoretically exact from small to very large curvatures and transverse and longitudinal displacements for plane beam-columns under bending actions. The large-deflection analysis of a beam-column with flexible connections at both ends becomes a complex problem requiring the simultaneous solution of at least two highly nonlinear equations with elliptical integrals. The solution of this problem becomes even more complex when the end connections are nonlinear or the direction of the applied end load changes (like “follower” loads). The validity and effectiveness of the proposed method and equations are verified against available solutions of very large deflection elastic analysis of beam-columns. Four comprehensive examples are included for verification and easy reference.     

Benchmarking System for Evaluating Management Practices in the Construction Industry

This paper presents the results obtained for the initial application of a management evaluation system whose objective is to provide a continuous improvement tool for construction companies through benchmarking management practices. The outlined system seeks to support a benchmarking system that has been recently established in the Chilean construction industry by incorporating qualitative management aspects in addition to performance indicators. Different analyses were made to determine trends in the sector and to establish correlations between qualitative aspects coming from surveys and quantitative aspects coming from performance indicators. Thirteen construction companies participated in the initial application of the benchmarking system. A correlation analysis found that safety performance was strongly related to companies having superior planning and control, quality management, cost control, and subcontractor management policies. A factor analysis found that central office priorities focus on strategic management policies having longer-term competitive impact, while site management emphasizes tactical management dimensions having short-term impact. There is scope to elevate the profile of continuous improvement initiatives to strategic significance at the central office level.     

Utilization Bounds for EDF Scheduling on Real-Time Multiprocessor Systems

The utilization bound for earliest deadline first (EDF) scheduling is extended from uniprocessors to homogeneous multiprocessor systems with partitioning strategies. First results are provided for a basic task model, which includes periodic and independent tasks with deadlines equal to periods. Since the multiprocessor utilization bounds depend on the allocation algorithm, different allocation algorithms have been considered, ranging from simple heuristics to optimal allocation algorithms. As multiprocessor utilization bounds for EDF scheduling depend strongly on task sizes, all these bounds have been obtained as a function of a parameter which takes task sizes into account. Theoretically, the utilization bounds for multiprocessor EDF scheduling can be considered a partial solution to the bin-packing problem, which is known to be NP-complete. The basic task model is extended to include resource sharing, release jitter, deadlines less than periods, aperiodic tasks, non-preemptive sections, context switches, and mode changes.