High throughput electrochemical screening and dissolution monitoring of Mg–Zn material libraries

A combinatorial study on Mg–Zn material libraries obtained by thermal evaporation is performed in order to investigate the effect of alloying magnesium on the electrochemical behaviour and dissolution rate of zinc in borate buffer of pH 7.4. The surface morphology of the graded samples is complex and subject to a detailed discussion, whereas the crystal composition revealed Mg, MgZn₂ and Zn exclusively.Open circuit potential measurements and potential sweeps along the graded samples are combined with downstream zinc detection and revealed several strongly non linear dependencies between electrochemical features and magnesium content. While the chemical dissolution rate of zinc by the electrolyte was found to reflect the film stoichiometry except in the regions of high surface roughness, the open circuit potential revealed a local minimum around 20 at.% magnesium accompanied by a maximum in the current plateau during the anodic sweep and a high thickness of the native oxides present prior to electrochemical experiments. All compositions showed passive like behaviour during anodic sweeps with high plateau current densities (200–350 μA cm⁻²) originating from slow but constant oxide dissolution as supported by XPS analysis of the surface before and after contact with the electrolyte.     

Bifunctional electrodes for unitised regenerative fuel cells

The effects of different configurations and compositions of platinum and iridium oxide electrodes for the oxygen reaction of unitised regenerative fuel cells (URFC) are reported. Bifunctional oxygen electrodes are important for URFC development because favourable properties for the fuel cell and the electrolysis modes must be combined into a single electrode. The bifunctional electrodes were studied under different combinations of catalyst mixtures, multilayer arrangements and segmented configurations with single catalyst areas. Distinct electrochemical behaviour was observed for both modes and can be explained on the basis of impedance spectroscopy. The mixture of both catalysts performs best for the present stage of electrode development. Also, the multilayer electrodes yielded good results with the potential for optimisation. The influence of ionic and electronic resistances on the relative performance is demonstrated. However, penalties due to cross currents in the heterogeneous electrodes were identified and explained by comparing the performance curves with electrodes composed of a single catalyst. Potential improvements for the different compositions are discussed.     

Reduced fibroblast adhesion and proliferation on plasma-modified titanium surfaces

Soft tissue complications are clinically relevant problems after osteosynthesis of fractures. The goal is to develop a method for reduction of fibroblast adhesion and proliferation on titanium implant surfaces by plasma polymerisation of the organo-silicon monomer hexamethyldisiloxane (HMDSO). HMDSO was deposited under continuous wave conditions in excess oxygen (ppHMDSO surface) and selected samples were further modified with an additional oxygen plasma (ppHMDSO + O₂ surface). Surface characterization was performed by scanning electron microscopy, profilometry, water contact angle measurements, infrared reflection absorption spectroscopy and X-ray photoelectron spectroscopy. In our experimental setup the mechanical properties, roughness and topography of the titanium were preserved, while surface chemistry was drastically changed. Fibroblast proliferation was assessed by alamarBlue assay, cell morphology by confocal microscopy visualization of eGFP-transducted fibroblasts, and cell viability by Annexine V/propidium iodide assay. Both modified surfaces, non-activated hydrophobic ppHMDSO and activated hydrophilic ppHMDSO + O₂ were able to dramatically reduce fibroblast colonization and proliferation compared to standard titanium. However, this effect was more strongly pronounced on the hydrophobic ppHMDSO surface, which caused reduced cell adhesion and prevented proliferation of fibroblasts. The results demonstrate that plasma modifications of titanium using HMDSO are valuable candidates for future developments in anti-adhesive and anti-proliferative coatings for titanium fracture implants.