The essential oil and methanol extract of Satureja hortensis were tested for antifungal activity against Aspergillus flavus in vitro on Petri plates and liquid culture, and under storage conditions. The oil showed strong antifungal activity based on the inhibition zone and minimal inhibitory concentration values against the pathogen on Petri plates assays. The very low concentrations of them also reduced wet and dry mycelium weight of pathogen fungus in liquid culture. When the oils at 25, 12.5 and 6.25 microl/mL concentrations were applied to lemon fruits before seven days of pathogen inoculation on storage conditions, the decay on fruits caused by the pathogen could be prevented completely. The results in this study showed that the essential oil of S. hortensis had strong antifungal activity against pathogen fungi tested. So, the essential oil of S. hortensis could be used for management of this pathogen as a potential source of sustainable eco-friendly botanical fungicides. 相似文献
In this study, the fire performance and decay resistance of solid wood and plywood treated with quaternary ammonia compounds (didecyl dimethyl ammonium chloride (DDAC) and didecyl dimethyl ammonium tetrafluoroborate (DBF)) were compared with the performance of untreated control specimens and specimens treated with common fire retardants ((monoammonium phosphate (MAP), diammonium phosphate (DAP) and ammonium sulphate (AS)). Test specimens were treated with 1% and 4% (% m/v) aqueous solutions of the chemicals. The fire performance tests were the fire tube test (ASTM E 69) which measures mass losses in the specimens and the cone calorimeter test (ASTM E 1354) which measures mass loss, heat release rate, time for sustained ignition, effective heat of combustion, and specific extinction area. The results from the cone calorimeter tests were used to estimate the flame spread index (FSI) in the Steiner tunnel test (ASTM E 84). Heat release rates of the specimens treated with MAP, DAP, and AS were lower than those of both DDAC and DBF-treated specimens and the untreated control specimens. Compared with the untreated specimens, higher heat release rates were observed for the specimens treated with the quaternary ammonia compounds, DDAC and DBF. The estimates for the FSI for DDAC and DBF were for values equal to or higher than for the untreated control specimens. At higher concentration levels, MAP, DAP and AS were effective in decreasing initial contribution of heat release to potential fire. Decay resistance tests were done according to AWPA E 10 standard method using one brown-rot fungus and one white rot-fungus. Decay resistance tests revealed that solid wood specimens treated with DDAC and DBF showed resistance against the fungi tested, however, MAP, DAP and AS did not provide complete protection. While DBF and DDAC increased resistance of plywood specimens, high mass losses in plywood specimens treated with MAP, DAP and AS were obtained. 相似文献
The object of this work, a study of the junction recombination velocity limiting the short circuit (Sfsc) of a silicon solar cell under magnetic field in the dynamic frequency regime is presented. From the continuity equation, the density of minority Charge carrier’s in the base and the photocurrent are determined. The study of this photocurrent, according to the junction recombination velocity, allows us to determine the junction recombination velocity limiting the short circuit. The photocurrent density is studied as a function of the junction recombination velocity for different modulation frequencies. From the variation profile of the photocurrent density as a function of the junction recombination velocity, a technique for determining junction recombination velocity initiating the short-circuit situation is presented.
International Journal of Computer Vision - We identify two issues as key to developing effective face recognition systems: maximizing the appearance variations of training images and minimizing... 相似文献
In this work, sulfur-doped graphene-coated electrodes are prepared by cyclic voltammetry in different potential ranges and different cycles (from 10 to 50) for selective modification of electrodes by different functional groups. The prepared electrodes are characterized by spectroscopic, microscopic and electrochemical methods. In scanning electron microscopic analysis, formation of graphene layers and their porous structure have been determined. Electrochemical impedance spectroscopic and cyclic voltammetric analyses are also used in electrochemical characterization of the electrodes. Then, the prepared sulfur-doped graphene-coated electrodes by using cyclic voltammetry in one-step and low cost are used as electrode materials of supercapacitor for the first time in the literature. Since the mesoporous structure of the electrodes prepared in lower potential ranges increases, specific capacitance of the electrodes increases from 74 to 1833 mF cm−2 with 10 mA cm−2 current density. This result shows that specific capacitances of prepared electrodes are higher than those of the electrodes prepared with metal-doped in the literature. 相似文献
The flow downstream of a pair of circular cylinder in a side-by-side arrangement normal to the free stream is known to exhibit intermittently bistable structure for the range of G/D = 1.2–2.2 where G is the center-to-center distance between the cylinders and D is the diameter of the cylinder. Eventually, the wake downstream of one of the two cylinders can be wider or narrower than the one downstream of the other cylinder depending on the direction of gap-flow deflection. In the present study, such an asymmetric flow behavior downstream of two side-by-side cylinders, which were vertically located in shallow water, was passively controlled with a splitter plate with a length of L (1?L/D?5). The center of splitter plate was just coincided with the mid-height of the gap between centers of the cylinders. The investigations were carried out in a water channel using dye visualization and particle image velocimetry, PIV for qualitative and quantitative measurements, respectively. The diameter of the cylinder, D was 40 mm while the depth of water was 20 mm so that the shallow flow condition was provided through the experiments. The Reynolds number, Re based on D was 5000 and the cylinder’s center to center spacing to the cylinder diameter ratio (G/D ) was equal to 1.25. The results demonstrated that the deflection of the wake and thereby the bistability of the wake was considerably prevented with the presence of the splitter plate for L/D?3 which resulted in two well symmetric, stable wakes having approximately the same order of magnitudes of vortex shedding frequencies around the cylinders. 相似文献
As e-commerce expands, more and more products are offered online to attract internet consumers’ interest. These products are then shipped to consumers’ home by a drop-shipper. Drop-shipping seems to be a good option to sell products in addition to physical stores. Furthermore, both types of products, either sold in store or on Internet can be returned by consumers, with often a higher return ratio for those purchased on Internet. To model these two sales channel and the interactions between them, we consider a News-Vendor (NV) managing both a physical store and an online sale channel that can be fulfilled by a drop-shipping option. We also consider the possibility of reselling products that are returned by consumers during the selling season. The concavity of the expected profit is proven and the optimality condition is obtained. Promising results are obtained from a numerical analysis. In particular, we show that the expected profit can be 14.4% less than the optimal expected profit if the return effect is ignored. Using drop-shipping option can reduce the optimal store inventory by 31.2% and if the NV has no drop-shipping option, the expected profit can be 9% less. 相似文献
Objective: This study aimed to design and characterize an inhalable dry powder of ciprofloxacin or levofloxacin combined with the mucolytics acetylcysteine and dornase alfa for the management of pulmonary infections in patients with cystic fibrosis.Methods: Ball milling, homogenization in isopropyl alcohol and spray drying processes were used to prepare dry powders for inhalation. Physico-chemical characteristics of the dry powders were assessed via thermogravimetric analysis, differential scanning calorimetry (DSC), Fourier transform infrared spectroscopy (FT-IR), X-ray diffractometry and scanning electron microscopy. The particle size distribution, dissolution rate and permeability across Calu-3 cell monolayers were analyzed. The aerodynamic parameters of dry powders were determined using the Andersen cascade impactor (ACI).Results: After the micronization process, the particle sizes of the raw materials significantly decreased. X-ray and DSC results indicated that although ciprofloxacin showed no changes in its crystal structure, the structure of levofloxacin became amorphous after the micronization process. FT-IR spectra exhibited the characteristic peaks for ciprofloxacin and levofloxacin in all formulations. The dissolution rates of micro-homogenized and spray-dried ciprofloxacin were higher than that of untreated ciprofloxacin. ACI results showed that all formulations had a mass median aerodynamic diameter less than 5?μm; however, levofloxacin microparticles showed higher respirability than ciprofloxacin powders did. The permeability of levofloxacin was higher than those of the ciprofloxacin formulations.Conclusion: Together, our study showed that these methods could suitably characterize antibiotic and mucolytic-containing dry powder inhalers. 相似文献
This study compares time series and machine learning models for inflation forecasting. Empirical evidence from the USA between 1984 and 2014 suggests that out of sixteen conditions (four different inflation indicators and four different horizons), machine learning models provide more accurate forecasting results in seven conditions and the time series models are better in nine conditions. Moreover, multivariate models give better results in fourteen conditions, and univariate models are better only in two conditions. This study shows that machine learning model prevails against time series models for the core personal consumption expenditure (core-PCE) inflation forecasting, and the time series model (ARDL) is better for the core consumer price (core-CPI) index inflation forecasting in all horizons.
In the Multi-Agent Programming Contest 2017 the TUBDAI team of the Technische Universität Berlin is using the complex multi-agent scenario to evaluate the application of two frameworks from the field (multi-)robot systems. In particular the task-level decision-making and planning framework ROS Hybrid Behaviour Planner (RHBP) is used to implement the execution and decision-making for single agents. The RHBP framework builds on top of the framework Robot Operating System (ROS) that is used to implement the communication and scenario specific coordination strategy of the agents. The united team for the official contest is formed by volunteering students from a project course and their supervisors. 相似文献