2A12铝合金化学铣切加工工艺探讨

为了精确加工2Al2铝合金,探讨了化铣时间和温度对其化铣速率及表面粗糙度的影响,采用现代技术对化铣工件的力学性能进行了测试与分析.结果表明:延长非化铣部位保护胶固化时间并使保护部位向非加工面位移3～5 mm可很好地解决未化铣区域的腐蚀问题;随化铣时间的延长,化铣速率降低,且化铣温度与化铣速率呈现正相关性;化铣表面的粗糙度随化铣时间的延长而增加,随化铣温度的升高呈先减小后增加的趋势;化铣后材料的抗拉强度和屈服强度均有所提高.     

Formation of a protective layer against corrosion on Mg alloy via alkali pretreatment followed by vanillic acid treatment

Although Mg alloy possesses high specific strength, low density, and good biocompatibility, poor corrosion resistance hinders its further applications. In the present study, an innovative protective layer against corrosion was prepared on the AZ31 Mg alloy via alkali pretreatment followed by vanillic acid treatment. The alkali pretreatment supplied –OH for the AZ31 Mg alloy surface to react with vanillic acid. The vanillic acid treatment played a crucial role in enhancing the corrosion resistance due to the excellent ability to act as a barrier and retard aqueous solution penetration, which effectively isolated the underlying Mg alloy from the corrosive environment. The corrosion current density of alkali and vanillic acid-treated Mg alloy (AZ31V) almost showed two orders of magnitude lower values in comparison with that of the AZ31 Mg alloy, and the corrosion potential of AZ31V Mg alloy increased from −1.41 to −1.25 V. The immersion tests proved that there was no occurrence of severe corrosion. Hence, the alkali pretreatment and vanillic acid treatment may represent a promising method to improve the corrosion resistance of Mg alloy.     

Tensor Q-rank: new data dependent definition of tensor rank

Machine Learning - Recently, the $${ Tensor}~{ Nuclear}~{ Norm}~{ (TNN)}$$ regularization based on t-SVD has been widely used in various low tubal-rank tensor recovery tasks. However, these models...     

Transformation of the reabsorption characteristics of lignite treated by low and high temperature drying process

Abstract

The reabsorption characteristics of the lignite treated by low and high temperature drying process were addressed in the paper. The information about the moisture form, functional groups, effective water-filled porosities and equilibrium moisture content of the lignite before and after the drying process was investigated using Differential scanning calorimetry (DSC), Fourier transform infrared (FTIR) spectroscopy, nuclear magnetic resonance (NMR) spectroscopy and a self-made reabsorption device, respectively. The results show that the low drying temperature (140, 190, 230?°C, 10?min, N₂) has little impact on the effective water-filled porosities of the resulted samples, whereas it has a great influence on the main oxygen-containing functional groups, which amount firstly decreases and then increases with the drying temperature increasing. In the case of the lignite samples dried under high-temperature (600, 700, 800?°C, 30?s, N₂), the amount of the effective water-filled porosity of the sample decreases and the amount of oxygen-containing functional groups increases as the temperature increasing. The reabsorption capability of the high temperature dried sample is much lower than that of the sample treated under low drying temperature. The reabsorption characteristics of the low-temperature dried samples are affected by the amount of the oxygen-containing functional groups, while the effective water-filled porosity is main factor for the lignite samples derived from high temperature drying process. Moreover, the work gives a good evidence that the high-temperature drying process is an effective choose for lignite upgrading.     

脱硫活性焦水洗再生过程实验研究

对5种活性焦水洗再生前后的脱硫性能进行实验研究，通过比表面积（BET）、X射线光电子能谱（XPS）方法表征水洗再生工艺对活性焦孔隙结构和表面化学性质的影响，揭示影响活性焦水洗再生性能的关键因素。结果表明:活性焦脱硫硫容的大小和水洗再生率的高低没有直接关系；微孔比表面积较大的活性焦脱硫性能较好，中大孔孔容较大的活性焦水洗再生率较高，同时具备较大的微孔比表面积和中大孔孔容结构的活性焦适宜水洗再生工艺；活性焦表面极性含氧官能团含量越高水洗再生效果越好；活性焦AC5经过6次水洗再生循环，微孔中的硫酸经过多次累积后可以被水洗出，稳定再生率保持在45%~50%，最适用于活性焦水洗再生工艺。     

大庆长垣以东地区深层天然气输导特征及成藏

大庆长垣以东地区深层天然气输导通道主要由断裂、不整合面和砂体构成。该区砂体横向分布不稳定，物性差，不是天然气侧向长距离运移的输导通道，但可以起到衔接输导作用。输导通道时该区天然气成藏与分布起到了重要控制作用，主要表现在断裂将天然气输导致上覆不同储集层中聚集成藏。不整合面和砂体将天然气输导到四周古隆起上聚集成藏。沿断裂输导的天然气形成以断层为主的构造气藏。沿不整合面和砂体输导的天然气形成以地层及岩性为主的气藏。沿断裂输导运移聚集的天然气在剖面上呈串多层分布，沿不整合面和砂体输导运移聚集的天然气在平面上呈环状分布。     

并行组合扩频系统中混沌序列优选的研究

在结合并行组合扩频通信基础上，研究系统中的Logistic—Map混沌扩频序列优选准则。仿真结果表明，Logistic—Map混沌扩频序列可以提供数量众多的适于并行组合扩频通信系统的扩频序列族。