Synthesis,characterization, and DFT Raman study of pure and Mn-doped LiTaO3 nanofibers

Pure and Mn-doped lithium tantalate nanofibers, with Mn concentrations of 1%, 2.5%, and 5%, were synthesized by the electrospinning method. The morphology, microstructure, and crystal structure of as-spun and annealed composite nanofibers were characterized by scanning electron microscopy, X-ray diffraction, and transmission electron microscopy. Raman spectroscopy has shown to be a powerful tool to detect either local variations or changes of the whole structure. Position and width of one Raman line can be used as markers of a structural change. Some vibrational modes are especially associated with the site of Li or Ta ions and so, they can be affected by the introduction of dopant ions. Any damages or local changes in the microstructure can be detected by a line broadening. With the use of Raman spectroscopy, the sites where Mn ions enter the doped structures were established by recording the shift and broadening of peaks in Mn-doped structures with respect to pure lithium tantalate. Thus it was proven that Mn ions enter the Li sites for low Mn concentration and, on the other hand, for higher concentrations, the dopant substitutes Li and Ta sites. First-principles calculations were performed within the density functional theory, including lattice-dynamic calculations of the phonon modes at the zone center (Γ point), for the pure structure, to find the irreducible representation of the modes.     

Fatigue crack initiation and damage characterization in Brazilian test specimens for adhesive joints

The present study is focused on the fatigue failure initiation at bimaterial corners by means of a configuration based on the Brazilian disc specimens. These specimens were previously used for the generalized fracture toughness determination and prediction of failure in adhesive joints, carried out under static compressive loading. Under static loading, local yielding effects might affect the asymptotic two-dimensional linear elastic stress representation under consideration. Fatigue loading avoids this fact due to the lower load levels used. The present tests were performed using load control; video microscopy and still cameras were used for monitoring initiation and crack growth. The fatigue tests were halted periodically and images of the corner were taken where fatigue damage was anticipated. Damage initiation and subsequent crack growth were observed in some specimens, especially in those which presented brittle failure under static and fatigue tests. These analyses allowed the characterization of damage initiation for a typical bimaterial corner that can be found in composite to aluminium adhesive lap joints.     

The L467F-F508del Complex Allele Hampers Pharmacological Rescue of Mutant CFTR by Elexacaftor/Tezacaftor/Ivacaftor in Cystic Fibrosis Patients: The Value of the Ex Vivo Nasal Epithelial Model to Address Non-Responders to CFTR-Modulating Drugs

Loss-of-function mutations of the CFTR gene cause cystic fibrosis (CF) through a variety of molecular mechanisms involving altered expression, trafficking, and/or activity of the CFTR chloride channel. The most frequent mutation among CF patients, F508del, causes multiple defects that can be, however, overcome by a combination of three pharmacological agents that improve CFTR channel trafficking and gating, namely, elexacaftor, tezacaftor, and ivacaftor. This study was prompted by the evidence of two CF patients, compound heterozygous for F508del and a minimal function variant, who failed to obtain any beneficial effects following treatment with the triple drug combination. Functional studies on nasal epithelia generated in vitro from these patients confirmed the lack of response to pharmacological treatment. Molecular characterization highlighted the presence of an additional amino acid substitution, L467F, in cis with the F508del variant, demonstrating that both patients were carriers of a complex allele. Functional and biochemical assays in heterologous expression systems demonstrated that the double mutant L467F-F508del has a severely reduced activity, with negligible rescue by CFTR modulators. While further studies are needed to investigate the actual prevalence of the L467F-F508del allele, our results suggest that this complex allele should be taken into consideration as plausible cause in CF patients not responding to CFTR modulators.     

Validation of a Cleanroom Compliant Sonication-Based Decellularization Technique: A New Concept in Nerve Allograft Production

Defects of the peripheral nervous system are extremely frequent in trauma and surgeries and have high socioeconomic costs. If the direct suture of a lesion is not possible, i.e., nerve gap > 2 cm, it is necessary to use grafts. While the gold standard is the autograft, it has disadvantages related to its harvesting, with an inevitable functional deficit and further morbidity. An alternative to autografting is represented by the acellular nerve allograft (ANA), which avoids disadvantages of autograft harvesting and fresh allograft rejection. In this research, the authors intend to transfer to human nerves a novel technique, previously implemented in animal models, to decellularize nerves. The new method is based on soaking the nerve tissues in decellularizing solutions while associating ultrasounds and freeze–thaw cycles. It is performed without interrupting the sterility chain, so that the new graft may not require post-production γ-ray irradiation, which is suspected to affect the structural and functional quality of tissues. The new method is rapid, safe, and inexpensive if compared with available commercial ANAs. Histology and immunohistochemistry have been adopted to evaluate the new decellularized nerves. The study shows that the new method can be applied to human nerve samples, obtaining similar, and, sometimes better, results compared with the chosen control method, the Hudson technique.     

Mechanical behavior of cold-water fish gelatin gels crosslinked with 1,4-butanediol diglycidyl ether

In this work, chemical crosslinking with 1,4-butanediol diglycidyl ether (BDDGE) is used as strategy to enhance mechanical performance of fish gelatin (FG) gels in order to meet the properties' range of mammalian gelatin physical gels. Joint analysis of free amino groups, swelling ratio, and total soluble material indicates that crosslinking degree increases with increasing FG concentration and it is favored by a 0.2 BDDGE/FG ratio. Increasing crosslinking degree enhances gel indentation strength and shear modulus (μ) while decreases fracture toughness (G_IC). Measured μ and G_IC values lies within the range exhibited by mammalian gelatin physical gels, but the relationship between these parameters is opposite. This is due to the different fracture mechanisms occurring in chemically crosslinked and physical gels.     

Supervised Multivariate Analysis of Hyper-spectral NIR Images to Evaluate the Starch Index of Apples

Fruit maturity indexes are crucial in harvest time determination and commercial context. The harvest time of apples, matching the desired commercial characteristics, is assessed through starch–iodine test in practice. Fruit halves are dipped into iodine solution and patterns are visually evaluated by experts comparing them to reference charts. Aim of the work was to study the relationships of near infrared (NIR) spectral images (1,000–1,700 nm), starch/starch-free patterns visually assessed and RGB color images. Spectral images of 88 Golden Delicious Klon B apples were sampled at seven different maturity stages. Partial least-squares discriminant analysis (PLSDA) technique was used on hyper-spectral NIR images to classify single pixels using its NIR reflectance spectrum. The response variable (i.e. the classification for each pixel) was identified through the matching of single pixel obtained with the color images, segmented in two classes (starch and starch-free), and the NIR hyper-spectral matrix. Mean hyper-spectral classification obtained through PLSDA modeling on individual apple correctly classified 80.81% of the total pixels, while the unique model, i.e. a single model including all the fruits, resulted in 66.33%. In the latter case, the relationship with the RGB classification showed high values (Pearson correlation coefficient r = 0.95). The present work shows the feasibility of NIR imaging spectroscopy as a tool for apple fruit maturity determination, avoiding expert’s subjective interpretation by traditional starch index assignments.     

Composition of phospholipid fraction in raw chicken meat and pre-cooked chicken patties: influence of feeding fat sources and processing technology

The effect of dietary lipid sources (animal fat, AF vs. vegetable oil, VO) was investigated on the phospholipid (PL) fraction of raw chicken meat and pre-cooked chicken patties. PL classes were determined on extracted lipids by high-performance liquid chromatography (HPLC) connected with an evaporative light-scattering detector (ELSD). The HPLC-ELSD method showed good intraday repeatability (less than 5% for different PL) and limits of detection ranging from 0.006 mg/mL (phosphatidylethanolamine) to 0.045 mg/mL (sphingomyelin). Diet did not consistently influence PL in chicken breast. A significant difference was assessed in meat batter where total PL were at levels of 349.0 and 388.2 mg/100 g of product in batter from broilers fed AF and VO diet, respectively. Cooking oil absorption caused an important decrease in PL (lower than 300 mg/100 g of product in pre-fried patties). Diet was an effective means to control the PL fatty acid profile in chicken, particularly the levels of polyunsaturated fatty acids (PUFA). In minced breast and thigh and meat batter from birds fed a VO-supplemented diet, the relative amount of PUFA was 46, 81 and 28% higher than that determined in the corresponding samples obtained from broilers fed an AF-based diet.