Microstructural studies of aluminium-silicon alloy reinforced with alumina fibres

The microstructure of an alumina fibre reinforced Al-7wt% Si alloy has been investigated. It was shown that the Al-Si eutectic structure which characterized this alloy was markedly changed by the presence of the fibres, with coarsening of silicon particles and a reduction in primary aluminium grain size. The coarse silicon particles exhibited twinning but no orientation relationship with the aluminium. Fine silicon precipitates were also present and these had a cube-cube orientation relationship with the aluminium lattice. Lath-like intermetallics, FeSiAl₅ and FeSi₂Al₄ with monoclinic and tetragonal structures, were identified which existed in equilibrium and had the epitaxial relationship (001)_mono//(001)_tet and [100]_mono//[100]_tet. The iron was a contaminant introduced in the course of composite fabrication.Dislocations were a common feature of the aluminium matrix, with a typical density of 4×10⁷mm^–2. Nevertheless, dislocation hardening of the metal matrix was not detected. No evidence of Mg₂Si precipitates in the metal matrix was found, but the small addition (0.2wt%) of magnesium to the alloy was discovered to segregate at the fibre-aluminium interface. This segregation was believed to result in improved wettability of the two constituents, encouraging the formation of a strong fibre-matrix bond, and producing desirable properties of the composite in the transverse direction.     

卡尔曼滤波算法在MEMS热式风速风向传感器中的应用

针对MEMS热式风速风向传感器在实际使用过程中因噪声问题导致输出不稳定的现象,本文首次采用了卡尔曼(Kalman)滤波算法对本征白噪声进行滤波处理,从而优化传感器的输出性能.本文分别通过理论分析和仿真模拟证明了Kalman滤波算法的可行性.实验结果表明,通过调节相关参数,Kalman滤波算法在滤波效果、响应速度及误差上均优于传统的加权滑动均值滤波算法.除此之外,在消耗较少资源的前提下,Kalman滤波算法可以有效减少本征白噪声的干扰,且调节空间较大,可以适应不同的应用需求.     

物流中心选址问题的二元语义决策方法

为了有效避免语言评价中信息的损失和扭曲,从而提高物流中心选址的准确性,在层次分析法中引入三角模糊数,将各评价指标量化,提出一种二元语义决策选址方法.给出二元语义评价的方法与步骤,并通过物流中心选址的算例分析说明该方法的合理性.     

基于不完全信道信息的D2D功率分配算法

针对蜂窝与终端直通(Device-to-device,D2D)混合网络中的不完全信道状态信息(Channel state information,CSI),提出了一种基于不完全CSI的最优功率分配算法。利用拉格朗日乘数法推导出了最优功率分配解的闭式表达式。相对于传统的最大发送功率分配方案,该最优解受信道信息误差的影响较小,具有较好的鲁棒性。仿真结果表明,本文算法可以节约发送功率,并得到更大的接收信噪比。     

一维炉系统的测试实验

一维炉是一种研究煤的热解燃烧和结渣等方面的实验系统,可用于模拟电厂煤粉的燃烧特性。以元宝山褐煤为燃料,介绍了一维炉的结构和功能,并对系统的可靠性进行了验证,利用烟气分析仪及热重分析仪对燃烧后的尾部烟气及灰渣进行了分析测定。结果表明:尾部烟气含氧量与灰渣可燃部分剩余量均在理论计算值的误差允许范围内,说明一维炉密封良好,系统内各部分正常运行,对维炉的调试和研究具有一定的参考意义。     

Influence of static pre-loading on the dynamic bending strength of concrete with particle element modeling

Experimental tests show that static pre-loading has a significant effect on the dynamic strength of concrete.Based on meso-scale particle element model,numerical simulations of dynamic bending tests with pre-loading are performed.Complete stress–strain relationships are then obtained.Significant increase in dynamic strength is found when the pre-loadings are imposed within the elastic limit of concrete.However,when the imposition of pre-loadings reaches the plastic or softening range,dynamic strengths may gradually decrease along with the increase in pre-loadings.The distribution of energy components and the failure modes are discussed to explain the mechanisms of the phenomena.     

Non-Fourier heat conduction in a thin gold film heated by an ultra-fast-laser

Based on the dual-phase-lagging(DPL)heat conduction model,the Cattaneo-Vernotte(CV)model and the improved CV model we investigate the one-dimensional heat conduction in gold films with nano-scale thickness exposed to an ultra-fast laser heating.The influence of system parameters on the temperature field is explored.We find that for all the non-Fourier heat conduction models considered in this work,a larger Knudsen number normally leads to a higher temperature.For the DPL model,the large ratio of the phase lag of temperature gradient to the phase lag of heat flux reduces the maximum temperature and shortens the time for the system to reach its steady state.The CV model and the improved CV model lead to the similar thermal wave behavior of the temperature field,but the thermal wave speeds for these two models are different,especially for large Knudsen numbers.When the phase lag of temperature gradient is smaller,the difference between the DPL model and the improved CV model is not significant,but for the large phase lag of temperature gradient the difference becomes quite significant,especially for the large Knudsen number.In addition,the effect of the surface accommodation coefficient,which is a parameter in the slip boundary condition,on the temperature field of the gold film heated by ultra-fast laser pulses is investigated based on the DPL model.     

Effects of coagulation bath temperature on structure and performance of poly （vinyl butyral） hollow fiber membranes via thermally induced phase separation

Poly （vinyl butyral） （PVB） hollow fiber membranes were fabricated via thermally induced phase separation （TIPS）. The effects of coagulation bath temperature （CBT） on the structure and performance of membranes were investigated in detail. The morphologies of the membranes were studied by scanning electron microscopy （SEM）, the performances of water permeability, rejection, breaking strength and elongation were measured, respectively. The results indicate that all the membranes have the asymmetric morphology and the thickness of the skin layer decreases and the pore size of the outer layer increases with the increase of CBT. The permeability of membranes prepared at air gap 1.0 cm and take-up speed 0.253 m/s increases from 1.047×10-7 to 5.909×10-7 m3/（m2·s-kPa） with the CBT increasing from 20 ℃ to 40℃, and sharply increases to 35.226×10 7 m3/（m2.s.kPa）once the CBT arrives at 50 ℃. While the carbonic ink rejections have no significant decrease, totally exceed 98%, but that of acid-maleic acid copolymer greatly decreases with the increase of CBT. Both the breaking strength and elongation decrease with the increase of CBT.     

Bioleaching of pyrrhotite by Sulfobacillus thermosulfidooxidans

The bioleaching of pyrrhotite was investigated using Sulfobacillus thermosulfidooxidans.The effects of pH,pulp concentration,inoculation amount,external addition of ferrous and ferric ions were examined.The pH is found to exert a profound effect on the leaching process for controlling the bacterial activity and precipitation of ferric ions mainly as jarosite.The results show that low pulp content increases the leaching rate of iron.The inoculation amount from 1×107 cell/mL to 1×108 cell/mL has positive effects on the leaching rate.The results also imply that addition of ferrous sulfate（1 g/L） is required for the bacteria to efficiently drive the extraction of iron,however,the leaching efficiency has no obvious enhancement when 2 g/L ferrous sulfate was added.Comparatively,addition of ferric sulfate（2 g/L） significantly inhibits the bioleaching process.At the end of bioleaching,jarosite and sulfur are observed on the surface of pyrrhotite residues by using XRD and SEM.With the passivation film formed by jarosite and sulfur,the continuous iron extraction is effectively blocked.     

智能投币机在城市公交上使用的改进分析

通过鱼骨图的方法对现有智能公交投币机存在识别率偏低的问题进行了分析,提出在智能投币机中采用闭式五角叶轮或增加硬币预处理部分,对现有的智能公交投币机进行改进,使智能公交投币机的硬币辨识率得到提高.