粉末涂层抗冲击缺陷分析

讨论了粉末静电涂装中出现的涂层抗冲击试验缺陷，通过设计实验寻找造成该缺陷的原因，揭示了产生涂层起皱和脱离基材的原因是钢板与磷化液之间的匹配性差。通过提高磷化液的游离酸酸度解决了该问题。从理论上推出了游离酸与附着力之间可能的关系：游离酸影响磷化膜与基材的结合力，或影响形成的磷化膜的形态。     

Electrical properties and positron annihilation study of (Ba<Subscript>1−<Emphasis Type="Italic">x</Emphasis></Subscript>Ho<Subscript><Emphasis Type="Italic">x</Emphasis></Subscript>)TiO<Subscript>3</Subscript> ceramics

DC resistivity, dielectric constant, dielectric loss and positron annihilation spectra of (Ba_1−x Ho _x )TiO₃ ceramics have been measured as a function of holmium concentration x. It has been found that the DC resistivity of (Ba_1−x Ho _x )TiO₃ is strongly dependent on the Ho content: it decreases three orders of magnitude and reaches a minimum at x = 0.4%. Doping with 0.6% holmium increases the permittivity of BaTiO₃ by approximately three times (from ∼1,300 to ∼4,000), with only a slight increase in the corresponding dielectric loss. The local electron density and defect concentration estimated using positron annihilation technique conforms well to the features found in the dielectric and resistivity measurements. The results have been discussed in terms of a mixed compensation model.     

Nutrient removal performance of an anaerobic–anoxic–aerobic process as a function of influent C/P ratio

The laboratory scale anaerobic–anoxic–aerobic (A²O) process fed with synthetic brewage wastewater was designed to investigate the effects of changing feed C/P ratio on the performance of biological nutrient removal (BNR) processes. In the experiment, the influent chemical oxygen demand (COD) concentration was kept at approximately 300 mg L^?1 while the total phosphorus concentration was varied to obtain the desired C/P ratio. Results showed that when the C/P ratio was lower than 32, phosphorus removal efficiency increased as C/P ratio increased linearly, while when the C/P ratio was higher than 32, the P removal efficiency was maintained at 90–98%, and effluent P concentration was lower than 0.5 mg L^?1. However, regardless of the C/P ratio, excellent COD removal (90% or higher) and good total nitrogen removal (75–84%) were maintained throughout the experiments. It was also found that very good linear correlation was obtained between COD uptake per unit P released in the anaerobic zone and C/P ratio. In addition, the P content in the wasted activated sludge increased with the decrease in the C/P ratio. Based on the results, it was recommended that the wastewater C/P ratio and its effects be incorporated into BNR design and operational procedures, appropriate C/P ratios were used to achieve the effluent treatment goals. Copyright © 2005 Society of Chemical Industry     

大港油田关家堡地区不同含油层系气测解释方法探讨

大港油田关家堡地区油气藏特征复杂，不同含油层系油气显示特征不同，气测录井解释符合率相对较低。针对这一情况，通过分析关家堡地区明化镇组、馆陶组和沙河街组的地质和气测显示特征，结合试油结论，提出不同含油层系相应的气测录井解释方法——TR与Wh（湿度比）气测解释法和三角形图板法，归纳总结了全烃及组分在不同层系的变化规律。应用实例表明，效果较好，对于复杂油气藏多层系油气层的解释评价具有一定的借鉴作用。     

及时利用过喷粉末的涂装装置

对比了典型进口及国产粉末喷涂设备对过喷粉末的利用情况，介绍了一种获得实用新型专利权的涂装装置。该装置综合了进口及国产设备的优点，具有很高的性价比。     

升深2-17井络合铝聚合物充气钻井液现场试验

为加快徐加固子深层天然气的勘探开发步伐，缩短深层气井的建井周期，在升深2-17井进行了充气钻井试验。介绍了络合铝聚合物充气钻井液技术的现场应用概况及效果以及井漏的发生与处理过程、钻井液起泡的解决措施。在现场试验过程中，络合铝聚合物钻井液性能稳定，具有较强的抑制性和较好的流变性能，流性指数控制在0．7左右，具有良好的携屑和稳定井壁能力，而且粘度较低，基本上控制在33～52s之间，满足了现场充气和脱气的需要；该钻井液抗温可达180℃，润滑性能较好，在钻井过程中无粘卡显示，在深井欠平衡井眼稳定方面取得了较好的效果；在不同的气液比条件下，可以在0．83～1．08g／cm。之间实现对当量密度的调节;与常规钻井工艺相比，充气钻井可以使机械钻速提高30％～50％；在钻进过程中实现了充气和点火同时进行，达到了欠平衡钻井工艺技术的要求，为进一步开展气体钻井打下了良好的基础。     

一种基于数字电视系统的数据传输技术研究

数字电视是较为成熟和先进的信息传输技术，详细介绍一种通过数字电视系统传输数据的方法。     

真空技术在污水处理中的若干典型应用

介绍了真空技术在污水处理中的几种典型应用，真空结晶法在以分离污水中具有结晶性能的固体溶剂；真空过滤脱水用于初沉池和消化池污泥脱水，真空浮选法通过制造负压条件加速浮选过程；还有真空搅拌、真空脱气等等。这些足以说明真空技术在污水处理乃至环境保护中占有重要的一席之地。     

安全:爆破工程永恒的主题——2001年重大拆除爆破工程回顾

通过对2001年我国重大拆除爆破工程的回顾,认为在提高大面积毫秒非电起爆网络可靠性,控制爆破震动、扬尘、噪声等环境影响,与机械清理配合,实现快速施工等方面取得了进展与突破;对几起爆破安全事故进行了初步分析.为保证拆除爆破工程安全,在加强理论研究、开展技术创新、建立科学有序的管理制度等方面提出了建议意见.     

溶胶-凝胶法制备疏水型SiO-2气凝胶

以正硅酸乙酯 (TEOS)为硅源 ,用三甲基氯硅烷 (TMCS)为疏水试剂 ,通过溶胶 凝胶法在室温下制备出疏水型SiO2 气凝胶。用傅立叶变温红外 (FT IR)、扫描电镜 (SEM)、透射电镜 (TEM)和吸水性能对疏水型SiO2气凝胶的结构和性能进行了研究