Dithering and its effects on sigma-delta and multistage sigma-delta modulation

The spectrum of the quantization error in a dithered sigma-delta modulator is derived under the constraint that the dithering signal does not cause overload. The results apply to DC, sinusoidal, and more general quasi-stationary signals. It is shown in the case of a simple sigma-delta modulation that no-overload dithering can smooth the error spectrum and can make the quantization error asymptotically uncorrelated with the input. It does not, however, make the quantization error white. In the case of multistage sigma-delta modulation with the appropriate dithering, the quantization error becomes white, even for a system with only two stages. The signal-to-quantization-noise ratio (SQNR) is derived for sigma-delta and multistage sigma-delta oversampled analog-to-digital conversion with additive dithering. Simulation results, are presented to support the theoretical analysis.<>     

Three orthogonal polarisation DRA-monopole ensemble

A dual feed HE/sub 11/spl delta// mode dielectric resonator antenna (DRA) loaded monopole antenna ensemble is described. The two antennas were unaffected by co-location, having coupling less than -25 dB at 2.33 GHz, making the ensemble capable of radiating all three orthogonal linear polarisations. The dielectric resonator antenna had an input impedance bandwidth of 1.9%, while the monopole gave 56%. This small volume ensemble antenna is suitable for mobile communications terminals.     

A 10 b, 20 Msample/s, 35 mW pipeline A/D converter

This paper describes a 10 b, 20 Msample/s pipeline A/D converter implemented in 1.2 μm CMOS technology which achieves a power dissipation of 35 mW at full speed operation. Circuit techniques used to achieve this level of power dissipation include digital correction to allow the use of dynamic comparators, and optimum scaling of capacitor values through the pipeline. Also, to be compatible with low voltage mixed-signal system environments, a switched capacitor (SC) circuit in each pipeline stage is implemented and operated at 3.3 V with a new high-speed, low-voltage operational amplifier and charge pump circuits. Measured performance includes 0.6 LSB of INL, 59.1 dB of SNDR (Signal-to-Noise-plus-Distortion-Ratio) for 100 kHz input at 20 Msample/s. At Nyquist sampling (10 MHz input) SNDR is 55.0 dB. Differential input range is ±1 V, and measured input referred RMS noise is 220 μV. The power dissipation at 1 MS/s is below 3 mW with 58 dB of SNDR     

Weighted universal image compression

We describe a general coding strategy leading to a family of universal image compression systems designed to give good performance in applications where the statistics of the source to be compressed are not available at design time or vary over time or space. The basic approach considered uses a two-stage structure in which the single source code of traditional image compression systems is replaced with a family of codes designed to cover a large class of possible sources. To illustrate this approach, we consider the optimal design and use of two-stage codes containing collections of vector quantizers (weighted universal vector quantization), bit allocations for JPEG-style coding (weighted universal bit allocation), and transform codes (weighted universal transform coding). Further, we demonstrate the benefits to be gained from the inclusion of perceptual distortion measures and optimal parsing. The strategy yields two-stage codes that significantly outperform their single-stage predecessors. On a sequence of medical images, weighted universal vector quantization outperforms entropy coded vector quantization by over 9 dB. On the same data sequence, weighted universal bit allocation outperforms a JPEG-style code by over 2.5 dB. On a collection of mixed test and image data, weighted universal transform coding outperforms a single, data-optimized transform code (which gives performance almost identical to that of JPEG) by over 6 dB.     

Receiver array calibration using disparate sources

We present a new array calibration procedure for over-the-horizon (OTH) radar, using disparate sources. Unlike previous array calibration methods, which require a specific type or class of sources for calibrating the array, the method we propose can use combinations of single-mode, multimode, and near-field sources; each source with either known or unknown DOAs (directions-of-arrival). Multidimensional MUSIC is exploited for time-invariant DOA sources, while single-snapshot techniques are used for sources that have time-varying DOAs. A nonlinear separable least-squares solution to the array calibration problem is used to estimate the array coupling matrix and sensor positions. Simulation results indicate that good estimates are obtained for the unknown parameters and further the array sidelobe levels and bearing errors are significantly reduced when these estimated parameters are used in array processing. The algorithm performance was also compared with the Cramer-Rao lower bound and found to be statistically efficient     

固定无线接入点到多点系统中时分双工与频分双工之对比

利用点到多点架构的宽带固定无线系统采用微波和毫米波频段.本文分析了TDD与FDD应用在该系统中的差异,讨论了选择TDD而非FDD的动机,也论述了FDD赞同者所持的观点.     

移动WiMAX的发展现状

基于IEEE 802.16-2004及ETSI HiperMAN空中接口标准的WiMAX,正在被证明是一个高性价比的替代有线和DSL服务的固定无线技术.150多次的WiMAX试验及在五大洲的部署,清楚地证明了世界范围内对WiMAX作为固定无线服务技术的接受程度.     

Filtering of colored noise for speech enhancement and coding

Scalar and vector Kalman filters are implemented for filtering speech contaminated by additive white noise or colored noise, and an iterative signal and parameter estimator which can be used for both noise types is presented. Particular emphasis is placed on the removal of colored noise, such as helicopter noise, by using state-of-the-art colored-noise-assumption Kalman filters. The results indicate that the colored noise Kalman filters provide a significant gain in signal-to-noise ratio (SNR), a visible improvement in the sound spectrogram, and an audible improvement in output speech quality, none of which are available with white-noise-assumption Kalman and Wiener filters. When the filter is used as a prefilter for linear predictive coding, the coded output speech quality and intelligibility are enhanced in comparison to direct coding of the noisy speech     

Design and analysis of an improved smartcard‐based remote user password authentication scheme

With the fast development of the Internet and the telecommunication technologies, internet users are carrying out various electronic transactions over internet by means of the authentication protocols. To ensure efficient and robust online transaction, security of authentication protocol turns out to be a great concern nowadays. As a result, smartcard‐based password authentication and session key agreement scheme receives significant attention in recent years. In the literature, various authentication schemes have been proposed by the cryptographic research community. Recently, Li et al. analyze some security weaknesses of the authentication scheme of Chen et al. and propose an enhancement based on the discrete logarithm problem and computational Diffie–Hellman problem. This paper further cryptanalyzes the scheme of Li et al. and identifies various security loopholes and then constructs a modified authentication scheme as a remedy. The security and efficiency evaluations demonstrate that our scheme has more security features and low computation costs than the related schemes. Copyright © 2014 John Wiley & Sons, Ltd.     

关于倾斜界面转换点的确定

对于倾斜界面，转换波的叠加非常复杂。转换波的转换点坐标不仅取决于界面的倾角，而且取决于界面的倾向。要实现倾斜界面转换波的共转换点道集抽取和转换波叠加，必须确定转换点位置。倾斜界面转换点坐标是一个关于炮检距、震源到界面的垂直距离，横纵波速度比和界面倾角的函数。文中导出确定倾斜界面转换点的两个方程，即四次方程和迭代方程；并且讨论了界面倾角对转换点的影响。计算结果表明，利用迭代方程来转换点位置非常有效且