1.6 Tbit/s (40/spl times/40 Gbit/s) DPSK transmission over 3/spl times/100 km of TeraLight fibre with direct detection

By transmitting 40 channels over 300 km of TeraLight fibre, it is shown that optical differential phase shift keying can be used in 100 GHz-spaced 40 Gbit/s systems, with direct detection and a simple receiving filter. Chromatic dispersion tolerance around 300 ps/nm is also measured, compared to 70 ps/nm for NRZ.     

Origin of the threshold voltage instability in SiO/sub 2//HfO/sub 2/ dual layer gate dielectrics

The magnitude of the V/sub T/ instability in conventional MOSFETs and MOS capacitors with SiO/sub 2//HfO/sub 2/ dual-layer gate dielectrics is shown to depend strongly on the details of the measurement sequence used. By applying time-resolved measurements (capacitance-time traces and charge-pumping measurements), it is demonstrated that this behavior is caused by the fast charging and discharging of preexisting defects near the SiO/sub 2//HfO/sub 2/ interface and in the bulk of the HfO/sub 2/ layer. Based on these results, a simple defect model is proposed that can explain the complex behavior of the V/sub T/ instability in terms of structural defects as follows. 1) A defect band in the HfO/sub 2/ layer is located in energy above the Si conduction band edge. 2) The defect band shifts rapidly in energy with respect to the Fermi level in the Si substrate as the gate bias is varied. 3) The rapid energy shifts allows for efficient charging and discharging of the defects near the SiO/sub 2//HfO/sub 2/ interface by tunneling.     

Characterisation of K, Na, and Li birnessites prepared by oxidation with H2O2 in a basic medium. Ion exchange properties and study of the calcined products

Birnessites containing Na, K or Li in the interlayer have been prepared by oxidation of Mn(II) cations with H₂O₂ in a basic medium with different alkaline cation/Mn molar ratios. The solids prepared have been characterised by elemental chemical analysis, powder X-ray diffraction, thermal analyses (differential thermal analysis and thermogravimetric analysis), FT-IR spectroscopy and surface texture assessment by adsorption of N₂ at –196°C. Crystalline birnessites are obtained for A/Mn ratios (A = K, Li) larger than 3.4, but MnO(OH) has been also identificed when such a ratio is smaller than 3.4. Ion exchange is topotactic, but is not complete for exchanging Na, K, or Mg for pre-existing Li. The solids are stable up to 400°C, and formation of spinels and solids with tunnel structures is observed at this temperature. Li-containing birnessites are transformed to LiMn₂O₄ spinel at 400°C, and co-crystallization of bixbyte (Mn₂O₃) is observed at higher temperatures. Bixbyte and cryptomelane are formed at 500°C for the K-containing birnessites.     

An analytical method for the calculation of static characteristicsof linear step motors for control rod drives in nuclear reactors

An analytical method for calculating static characteristics of linear dc step motors (LSM) is described. These multiphase passive-armature motors are now being developed for control rod drives (CRD) in large nuclear reactors. The static characteristics of such LSM is defined by the variation of electromagnetic force with armature displacement and it determines motor performance in its standing and dynamic modes of operation. The proposed analytical technique for calculating this characteristic is based on the permeance analysis method applied to phase magnetic circuits of LSM. Reluctances of various parts of phase magnetic circuit is calculated analytically by assuming probable flux paths and by taking into account complex nature of magnetic field distribution in it. For given armature positions stator and armature iron saturations are taken into account by an efficient iterative algorithm which gives fast convergence. The method is validated by comparing theoretical results with experimental ones which shows satisfactory agreement for small stator currents and weak iron saturation     

Long-wavelength infrared photoinduced switching of a resonanttunneling diode using the intersubband transition

Voltage switching induced by long-wavelength infrared light from a CO₂ laser was observed using a double-barrier resonant tunneling diode (RTD) biased in the bistable region and the intersubband transition (IT) between the quantum confined states. Possible optoelectronic and all-optical switching applications involving hysteresis are proposed and discussed     

The effects of glycol methacrylate as a dehydrating agent on the dimensional changes of liver tissue

The dimensional changes of liver sections during the course of processing with glycol methacrylate (GMA) or with ethanol are described. Tissue processing with ethanol served as a control. During prolonged processing steps (24 h each), linear shrinkage of tissue specimens dehydrated with GMA at room temperature was 13.2%. Subsequent infiltration with GMA resulted in trivial swelling, and polymerization in slight shrinkage (2.3%). In comparison, processing with cold GMA resulted in shrinkage during dehydration (about 10.8%), a slight swelling in pure GMA, followed by shrinkage during polymerization (2.2%). Short routine processing schedules resulted in similar shrinkage/swelling patterns, although precise values differed slightly. In all experiments, ethanolic dehydration resulted in smaller dimensional tissue changes than did GMA dehydration. The dimensional changes of tissue sections during stretching on water, mounting and drying compensated for the major part of the shrinkage manifested during processing.     

PMMA tacticity and alumina powder dispersion stability

Summary Sedimentation experiments and X-ray photoelectron spectroscopy (XPS or ESCA) analyses have been used to study the effect of poly(methylmethacrylate) (PMMA) tacticity on aluminum oxide powder dispersion stability in a common solvent medium. The relative trends from sedimentation densities, and from surface analyses after solvent washing show that (PMMA) adsorption is greatest with isotactic polymer, where isotactic>atactic>syndiotactic adsorption. These results suggest that surface adsorption and hence dispersion stability can be influenced by polymer chain configuration as well as by chain conformation.     

Two-electrode DFB laser filter used as a wide tunable narrow-bandFM receiver: tuning analysis, characteristics and experimental FSK-WDMsystem

Characteristics of a two-electrode DFB laser filter are studied both theoretically and experimentally. Using a matrix analysis of spontaneous emission, a continuous tuning range of 6.7 Å is achieved by changing both net field gains of the two electrodes. A total discontinuous tuning range of over 10 nm comprising alternating mode jumps and continuous tuning range of 4 Å are measured experimentally. The laser filter presents a FWHM bandwidth of 5 GHz which depends on the optical input power. In addition, it is demonstrated that a DFB laser filter can act as a frequency discriminator/photodetector, i.e., a narrow-band FM receiver, with a uniform bandwidth of 1.5 GHz. Using the two-electrode DFB laser for both transmitter and receiver, a two-channel FSK-WDM transmission system utilizing the discontinuous tuning range is reported. The advantage of such a device is the simplicity as compared to the heterodyne technique