Hydrothermal products of the C3MS2-C12A7-MgO system

The autoclave products of reduced steel-slag of an electronic furnace mainly containing C₃MS₂ phase were detected. The hydrothermal products of this slag included calcio-chondrodite, brucite, and hydrogarnet phases. When suitable (CaO + MgO)/SiO₂ molar ratios were chosen, C₃MS₂ can react with SiO₂ to produce calcium silicate hydrates tobermorite, xonotlite, gyrolite, and truscottite phases with different saturated water vapor pressures. The phase brucite was present along with tobermorite, whereas phases Mg-xonotlite, Mg-gyrolite, and Mg-truscottite can rarely coexist with brucite. Hydrogarnet phase disappeared when Mg-truscottite was formed.     

A new batch solvent-extraction pilot plant

Summary and Conclusions A new improved batch solvent extraction plant and its versatility of design have been described. Data have been given on the cost and initial test operations. The performance of the plant has been tested, and its value as a research tool has been demonstrated by the production of free gossypol and meals low in gossypol for use in research. Simplicity of operation is borne out by the fact that only one operator is needed. A limited number of detail drawings of the plant are available on written request from the Southern Regional Research Laboratory. Presented at the fall meeting, American Oil Chemists’ Society, Nov. 2–4, 1953, in Chicago, Ill. One of the laboratories of the Southern Utilization Research Branch, Agricultural Research Service, U. S. Department of Agriculture.     

Irradiation of poly(vinyl chloride) with H2 plasma. II

Poly(vinyl chloride) films blended with plasticizers, stabilizers, and fillers are irradiated with a beam of H₂ plasma. The polymer partially loses its solubility in cyclohexanone. The viscosity of the soluble part decreases in the initial stages and then increases on further irradiation. Crosslinking was followed by dehydrochlorination and discoloration of the polymer. The electrical conductivity was measured as a function of the irradiation dose and time. The plasticizers enhanced the action of plasma while the stabilizers and fillers reduced it.     

Tensile behavior of glass fiber-reinforced acetal polymer

The tensile stress-strain behavior of glass fiber-reinforced polyacetal resin was investigated for various fiber concentrations, fiber length distributions, and finishing agents. The polyacetal fiber blends change considerably in strength and elongation at break when treated with ammonium chloride, but otherwise similar specimens still follow a common stress-strain curve to a point shortly before failure. As the mean fiber length decreases, the modulus and tensile strength fall, but the elongation at break remains almost unchanged. The observed tensile behavior is discussed in terms of a simplified model, which assigns the fibers to two categories: a fraction α parallel to the applied load, and the remainder distributed in a plane perpendicular to the load axis. By fitting this model to the stress-strain curves, two other constants of each system are derived: a length-dependent efficiency factor β for parallel fibers, whose magnitude agrees with the predictions of Rosen and his co-workers, and a factor γ which expresses the constraint of the matrix resin by the “transverse” fibers. The behavior of γ is consistent with Tsai's theory of the transverse modulus of laminates, if a reasonable amount of fiber–fiber contact is assumed. In terms of this model, possible interpretations of the behavior under repeated loading and the mechanism of tensile failure are presented.     

The electrochemistry of nitrate-amide melts: Reactions of nickel and copper in nitrate-amide melts

Copper and nickel may be electrodeposited from their ions in solution in nitrate-amide melts at room temperature. In the ammonium nitrate-acetamide-urea melt at 23°C, the reduction to the metal competes with the corrosion reaction at low rates and with the reduction of the ammonium and nitrate ions of the melt at high current densities. Two distinct types of nickel complexes are found in solution. The nickel complex formed by the corrosion reaction is bound by at least one ammonia ligand. Nickel complexes formed by dissolving the halide in the melt show evidence of coordination by less strongly bounding ligands, probably by amides. Similarly, the visible spectra of copper chloride in solution suggest that the cupric ions are coordinated primarily by amides. The copper corrosion reaction produces a complex with a spectra distinctly different from that of cupric chloride in solution. The shift in absorption maxima suggests that the copper complex formed by the corrosion reaction has at least one ammonia ligand in the coordination sphere.     

High oxide ion conduction in sintered oxides of the system Bi2O3-Y2O3

The ionic conduction in sintered Bi₂O₂-Y₂O₃ was investigated by measuring the conductivity and the emf of an oxygen concentration cell using the specimen tablet as electrolyte. The face centred cubic phase in this system was found to show high oxide ion conduction accompanied by a little electronic conduction when exposed to air. This phase was stable with a composition of 25 ～ 43 mol % Y₂O₃ over a wide range of temperatures, and the oxide ion conductivity increased with decrease in Y₂O₃. The conductivities of (Bi₂O₃)_0.75 (Y₂O₃)_0.25 were 1.6×10^?1 Ω^?1 cm^?1 at 700°C and 1.2×10^?2 Ω^?1 cm^?1 at 500°C values which are many times higher than those of stabilized zirconia (ZrO₂)_0.90(Y₂O₃)_0.10 at corresponding temperatures. Specimens containing less than 25 mol % Y₂O₃ showed a phase transition at 700 ～ 580°C and the conductivities decreased remarkably below these temperatures. High oxide ion conduction in the fcc phase is attributed to the migration of oxide ion vacancies which were present in an appreciable amount.     

Sex pheromone communication in the nematode,Rhabditis pellio

Both males and females ofRhabditis pellio release pheromones that attract the opposite sex prior to copulation. A quantitative bioassay for the female-produced pheromone was designed, based on male movement toward a pheromone source placed at one end of a 10-mm strip of bacterial material maintained on nutrient agar in a petri plate. Females produced pheromone from the age at which they attained the adult stage (3 days following hatching from the egg) and maintained a relatively constant production level until at least the ninth day of life. Similarly, males became responsive to the female pheromone by the third day and remained responsive through the ninth day, although the time required for the males to migrate toward a female pheromone source increased with increasing age. No daily rhythm of pheromone responsiveness by males or pheromone production by females was observed when the nematodes were conditioned to a 1212 h light-dark cycle.     

Anodic film studies on nickel under high rate transpassive dissolution conditions

Coulometry and Auger Electron Spectroscopy (AES) were employed to study thickness and composition of anodic films formed on nickel under high rate transpassive dissolution conditions. Nickel anodes were polarized at constant current densities up to 30 A/cm² in alkaline nitrate electrolytes of different nitrate and hydroxyl ion concentration using a flow channel cell with a constant electrolyte flow velocity of 10m/sec. Results show that with increasing current density film thickness goes through a maximum. Nitrogen is detected at the apparent film metal interface in the current region where metal dissolution occurs. No correlation between anodic film thickness and dissolution efficiency is found. The data, together with previous observations, suggest that high rate transpassive dissolution takes place from film free sites.     

High ionic conduction in tetragonal solid solution of the system La2O3-MgF2

LaOF-type tetragonal solid solution was found in the system La₂O₃–MgF₂. This phase showed higher anionic conduction than the previously reported cubic solid solution in the system La₂O₃–CaF₂. Electrolysis by Tubandt's method showed that fluoride ion conduction was dominant in this solid solution. The fluoride ions were considered to be easily substituted by oxide ions through cathode reaction in the oxygen atmosphere.     

OXYGEN TRANSFER IN HORIZONTAL PIPELINE AERATORS WITH NOZZLES

Horizontal pipeline and tubular loop aerators are of interest for fermentation and waste water treatment and are ideally suited for continuous processing. A major drawback is that these pipeline contactors invariably operate in the “elongated bubble and plug” regime in which the mass transfer rate is low. This article evaluates the performance of a horizontal pipeline aerator fitted with nozzles equispaced along its length to enhance mass transfer rates by promoting turbulence and augmenting effective interfacial area. Such devices can also be advantageously used in long pipe lines as in the case of treating waste while it is being transported. Pressure drop and overall liquid-side mass transfer coefficient data are reported as functions of liquid (water) and gas flow rates and nozzle size and spacing. It is shown that for all the conditions studied, k_La = 0.026(ΔP/L)^1.036 and that the pressure gradient is given by a simple correlation, provided an empirical parameter which characterises a nozzle is known. Preliminary investigations on the effect of surfactant ad the presence of suspended solids (size 75 μm) on mass transfer coefficient are also reported. Very high values of power dissipation can be achieved in such aerators without mechanically moving parts and high values of mass transfer coefficient can be realized.