文献计量视角下健康人力资本研究动态分析

通过文献计量方法从样本选取、研究动态分析、主题分布三方面对健康人力资本发展现状及热点问题进行总结.研究结果表明,自2004年开始该领域所属学科种类和期刊源日益丰富,并形成合著度较高的核心作者群体,健康人力资本研究成为人力资本领域的研究热点,健康人力资本与经济增长或收入的关系、健康人力资本指标体系的构建和居民健康人力资本收入效应的测算等问题都成为当前和未来的研究重点.     

3-三氟甲基-5,6,7,8-四氢-1,2,4-三唑[4,3-α]吡嗪盐酸盐的合成

乙二胺与氯乙酸乙酯经取代、环合反应制得2-哌嗪酮,2-哌嗪酮与Boc酸酐进行氨基保护反应后,再与五硫化二磷进行硫代反应制得4-(N-叔丁氧羰基)-2-哌嗪硫酮,其与三氟乙酰肼经取代、环合、脱叔丁氧羰基成盐,得标题化合物,总收率为45.7%(以氯乙酸乙酯计)。为磷酸西他列汀中间体的工业化生产提供了一条较理想的工艺路线。     

基于Bayes方法的Al-Mg-Mn合金断裂韧度研究

基于Bayes方法研究了Al-5.2Mg-0.7Mn-0.20Sc-0.1Zr合金的平面应变断裂韧度。结果表明,Al-5.2Mg-0.7Mn-0.20Sc-0.1Zr合金热轧板在L-T和T-L取向KIC值分别为32.66和32.03 MPa·m1/2,平面应变断裂韧度各向异性差别较小。     

超高效液相色谱串联质谱法测定烟草中的噁霉灵残留

为降低烟草中噁霉灵检测中的基质干扰，提高检测灵敏度和和稳定性，通过试验建立了以QuEChERS为样品前处理方法、液相色谱串联质谱仪为检测仪器的烟草中噁霉灵残留检测方法。样品加水浸润后，经丙酮提取、盐析试剂包除水、石墨化炭黑除杂后，采用Agilent ZORBAX 300SB-C8液相色谱柱（2.1 mm×100 mm，1.8 μm）分离，甲醇-水程序洗脱，ESI雾化，串联质谱MRM检测。结果发现，该方法在0.0025~0.0500 mg/L范围内线性良好，决定系数r²=0.9996，定量检测限1.06 μg/L，回收率在90.8%~92.0%之间，相对标准偏差为5.1%。运用该方法测定烟草中的噁霉灵，操作简单，检测精度高，满足CORESTA对烟草农残检测的要求。     

视频侦查中人像智能分析应用及算法优化

人像智能分析指的是对视频或录像中的人像进行结构化和可视化分析,对目标人物进行性别、年龄、发型等特征的智能识别,这项技术在视频侦查中有极高的应用价值。人像识别早期的算法是通过人工提取特征,通过学习低级视觉特征来针对不同属性进行分类学习,这种基于传统方法的模型表现常常不尽如人意。在计算机视觉领域,通过海量图像数据学习的神经网络比传统方法有更丰富的信息量和特征可以被提取。文章尝试通过深度学习技术训练神经网络模型对行人进行检测和识别,对于衣着不同的行人进行智能识别,具有更好的鲁棒性,提升了视频人像识别的准确率,拓展了人工智能技术在身份识别领域的应用。     

Transesterification of Palm-based Methyl Palmitate into Esteramine Catalyzed by Calcium Oxide Catalyst

The technology for transesterification reactions between methyl esters and alcohols is well established by using classical homogeneous alkaline catalysts, which provide high conversion of methyl esters to specialty or nonindigenous esters. However, in certain products where the purity of the esters is of concern, the removal of homogeneous catalysts after the completion of the reaction is a challenge in terms of production cost and water footprint. Therefore, a study to investigate the potential of heterogeneous catalysts was conducted on reactions between methyl palmitate and triethanolamine. The degree of basicity and active surface area of calcium oxide (CaO), zinc oxide (ZnO), and magnesium oxide (MgO) were first characterized by using temperature-programmed desorption (TPD-CO₂) and Brunauere–Emmett–Teller (BET), respectively. Among the metal oxides investigated, the CaO catalyst showed the best catalytic activity toward the transesterification process as it gave the highest conversion of methyl palmitate and yielded fatty esteramine compositions similar to the conventional homogeneous catalyst. The optimum transesterification condition by using the CaO catalyst utilized a lower vacuum system of approximately 200 mbar, which could minimize a considerable amount of energy consumption. Furthermore, low CaO dosage of 0.1% was able to give a conversion of 94.5% methyl ester and formed esteramine at 170 °C for 2 h. Therefore, the production of esterquats from esteramine may become more economically feasible through the methyl ester route by using the CaO catalyst, which can be recycled three times.     

Single-Crystalline TiO2(B) Nanobelts with Unusual Large Exposed {100} Facets and Enhanced Li-Storage Capacity

The {100} facet of single-crystalline TiO₂(B) is an ideal platform for inserting Li ions, but it is hard to be obtained due to its high surface energy. Here, the single-crystalline TiO₂(B) nanobelts from H₂Ti₃O₇ with nearly 70% {100} facets exposed are synthesized, which significantly enhances Li-storage capacity. The first-principle calculations demonstrate an ab in-plane 2D diffusion through the exposed {100} facets. As a consequence, the nanobelts can significantly accommodate Li ions in LiTiO₂ formula with specific capacity up to 335 mAh g⁻¹, which is in good agreement with the electrochemical characterizations. Coating with conductive and protective poly(3,4-ethylenedioxythiophene)-poly(styrenesulfonate), the cut-off discharge voltage is as low as 0.5 V, leading to a capacity of 160.7 mAh g⁻¹ after 1500 cycles with a retention rate of 66% at 1C. This work provides a practical strategy to increase the Li-ion capacity and cycle stability by tailoring the crystal orientation and nanostructures.     

水文序列相依变异识别的RIC定阶准则——以自回归模型为例

水文过程相依性是水文变异的主要表现形式之一,应用自回归模型对其进行拟合时合理确定模型阶数是一个难点问题。本文在分析AIC和BIC准则的基础上,提出了一种以原序列与其相依成分的相关系数作为拟合度指标,同时借用信息熵形式的函数式,作为模型不确定性度量指标的自回归模型定阶准则(简称RIC准则)。以AR(1)、AR(2)、AR(3)和AR(4)模型为例进行统计试验,将不同序列长度下该准则的定阶准确率与其他定阶准则进行比较,试验结果表明,RIC准则对于上述模型均具有较好的适应性,且定阶准确率远高于AIC准则,其中对于前三阶模型RIC准则优于BIC准则,但四阶模型略低于BIC准则。RIC准则的优势是可以同时满足模型定阶、相依程度分级与模型检验的需求,将其应用于实测水文序列分析,结果显示,该准则能较准确地识别自回归模型的阶数,且符合提出的"相依有变异而残差无变异的最小阶数"的检验标准。     

面源红外诱饵对抗红外制导导弹干扰策略研究

面源红外诱饵使用的过程中,合理有效的干扰策略是干扰红外制导导弹的关键,针对这一问题,通过理论分析与仿真模拟相结合得到面源红外诱饵对抗红外制导导弹的干扰策略。首先以红外成像制导导弹为例,介绍红外制导导弹的仿真模型,然后将攻击过程分为锁定前与锁定后,以命中率为评价指标,得到两个阶段下的最佳干扰策略,包括诱饵的最佳释放时机、释放间隔以及载机应采取的机动动作等。     

平原地区地表水资源量计算方法的探讨

用地面分类法和等值线图法两种不同方法计算汕头市地表水资源量,并通过计算成果的比较分析,探讨平原地区地表水资源量的计算方法。