Site‐Selective Iron(III) Chloride‐Catalyzed Arylation of 4‐Aryl‐4‐methoxy‐2,5‐cyclohexadienones for the Synthesis of Polyarylated Phenols

The iron(III) chloride‐catalyzed Friedel–Crafts arylation of 4‐aryl‐4‐methoxy‐2,5‐cyclohexadienones, which were easily prepared by the phenyliodine(III) diacetate (PIDA)‐mediated oxidation of 4‐arylphenols in methanol, proceeded site‐selectively to form meta‐terphenyl (2,4‐diarylphenol) derivatives in good yields. The subsequent PIDA‐mediated oxidation and iron(III) chloride‐catalyzed Friedel–Crafts arylation of the resulting products gave the corresponding 2,4,6‐triarylphenol derivatives. The present method provides useful highly substituted polyarylated compounds.

     

Double-stimuli responsive O/W emulsion gel based on a novel amidoamine surfactant

A heat-induced O/W emulsion gel that undergoes a phase transition from sol to gel on heating was formed from the addition of aqueous HCl to a toluene solution of a long-chain amidoamine derivative (C18AA). The heat induced O/W emulsions are highly sensitive to temperature, and the sol-gel transition temperature could be simply controlled by adjusting the C18AA concentration. Interestingly, the sol-gel transition of the O/W emulsions was also very sensitive to pH. Thus, we have successfully prepared a novel double-stimuli responsive gel based on O/W emulsions consisting of C18AA and HCl.     

Decomposition kinetics and recycle of binary hydrogen‐tetrahydrofuran clathrate hydrate

Decomposition kinetics and recycle of hydrogen–tetrahydrofuran (H₂–THF) clathrate hydrates were investigated with a pressure decay method at temperatures from 265.1 to 273.2 K, at initial pressures from 3.1 to 8.0 MPa, and at stoichiometric THF hydrate concentrations for particle sizes between 250 and 1000 μm. The decomposition was modeled as a two‐step process consisting of H₂ diffusion in the hydrate phase and desorption from the hydrate cage. The adsorption process occurred at roughly two to three times faster than the desorption process, whereas the diffusion process during formation was slightly higher (ca. 20%) than that during decomposition. Successive formation and decomposition cycles showed that occupancy seemed to decrease only slightly with cycling and that there were no large changes in hydrate structure due to cycling. Results provide evidence that the formation and decomposition of H₂ clathrate hydrates occur reversibly and that H₂ clathrate hydrates can be recycled with pressure. © 2010 American Institute of Chemical Engineers AIChE J, 2011     

Characterization of doped single-wall carbon nanotubes by Raman spectroscopy

Single-wall carbon nanotubes were grown by thermal chemical vapor deposition using either boron- or nitrogen-containing feedstocks or both. Carrier doping was evidenced by hardenings of the G band in Raman spectra, and the estimated carrier concentration reached ∼0.4%. In the G′ and D band spectra, a doping-induced component was observed at the high- or low-energy side of the original one. However, the appearance of the new component did not always coincide with the carrier doping. The doped SWCNTs often show radial breathing mode peaks in the off-resonance region, indicating a defect-induced modification of absorption spectrum.     

Single-step synthesis and characterization of single-walled carbon nanohorns hybridized with Pd nanoparticles using N2 gas-injected arc-in-water method

Single-walled carbon nanohorns (SWCNHs) hybridized with palladium (Pd) nanoparticles were synthesized by a single-step gas-injected arc-in-water method (GI-AIW) with a Pd wire inserted inside the anode hole. In the arc zone, carbon and Pd were vaporized simultaneously, leading to the formation of hybrid material of SWCNHs and Pd nanoparticles due to effective quenching. Based on TEM and CO chemisorption analyses, Pd nanoparticles were found to be embedded inside SWCNH aggregates. The size of Pd nanoparticles, determined by X-ray diffraction, was in the range of 3–6 nm when Pd wires with diameters of 0.1 and 0.3 mm were used. Using a Pd wire with a diameter larger than 0.5 mm results in larger Pd nanoparticles which tend to be exposed to the outer surface of the hybrid material. According to thermogravimetric analyses, the weight fraction of Pd nanoparticles is increased by increasing the Pd wire diameter although the yield of Pd nanoparticles decreased. SWCNHs hybridized with dispersed Pd nanoparticles, synthesized with 0.1 mm Pd wire, exhibited strong anti-oxidation resistance with a highly graphitic structure.     

Light scattering studies on crystallization in polyethylene terephthalate

The light scattering from the spherulites of polyethylene terephthalate grown near the glass transition temperature has been investigated. The Hv scattering profiles can be reproduced by the sum of the ideal spherulite scattering with the distribution of spherulite radius and the isotropic scattering from randomly oriented crystallites. The ratio of optical anisotropies in the isotropic scattering to the ideal spherulite scattering is obtained by the method established to eliminate the effects of the number density of spherulites and the coefficient depending on the experimental conditions. It is found that the anisotropy ratio is almost independent of the crystallization time and of temperature above 106 °C, while it is larger at a crystallization temperature of 103 °C. The spherulitic structure is discussed in terms of the anisotropy ratio.     

采用MAMMOS技术的高密度光记录

MAMMOS(Magnetic Amplifying Magneto－ Optical System:磁畴扩大磁光系统 )是实现高密度磁光盘的有效方法。不仅能得到不依赖于磁畴长度的较大的读出信号振幅,而且还能实现超出光学系统衍射极限的分辨率。过去,为实现磁畴的复印与扩大,要对记录膜面施加垂直方向的外部磁场。而现在得知,同时施加垂直磁场和水平方向的磁场,可大幅度地提高微小磁畴的读出特性。确认采用施加水平磁场的方法,在λ =635 nm, NA=0.55的条件下, 0.15μ m的连续磁畴也能获得 BER=2× 10－ 4的读出效果。