A 50 GHz GaAs FET MIC transmitter/receiver using hermetic miniatureprobe transitions

A very compact 50-GHz-band transmitter/receiver for a video link is described. The RF assemblies used in the system consist of 25/50-GHz frequency doublers, a 25-GHz dielectric-resonator oscillator, and a 25-GHz FM modulator. The circuits make extensive use of microwave integrated circuit (MIC) technology with all GaAs FETs as active elements. The frequency doublers exhibit a minimum conversion loss of 2.6 dB and a maximum output power of 11 dBm. The modulator is highly frequency stabilized by the dielectric resonator. Recently developed miniature probe microstrip-to-waveguide transitions permit the MIC assemblies to be installed compactly in hermetically sealed packages. Design considerations and experimental data for the transition are presented. Using these technologies a transmitting power of 10 dBm and a receiver noise figure of 13 dB have been obtained     

Pressure carbonization of pitch/phenolic resin mixtures

Phenolic resins and the benzene-soluble fraction of a coal tar pitch were mixed in a solvent (pyridine) and carbonized at 600° C in a gold tube under a pressure of 30 MPa. Yields, optical textures and graphitizabilities of the carbons were studied. Large carbon yields (>80%) were obtained from sealed tubes under pressure (closed system). In open tubes under pressure (open system), only slight improvements in carbon yields were observed. As the resin content in the starting mixtures increased, the optical texture of the resultant carbons decreased from coarse mosaic to isotropic through intermediates with a gradual decrease in size of mosaic units. These intermediate optical textures occurred with a wider range of resin content under pressure than under atmospheric pressure, especially from closed systems. Changes in structural parameters of the carbons after the 2800° C treatment corresponded to the changes in optical texture with resin content.     

TiO2 thin films using organic liquid materials prepared by Hot-Wire CVD method

TiO₂ thin films prepared by Hot-Wire CVD method have been studied as a protecting material of transparent conducting oxide (TCO) against atomic hydrogen exposures for the fabrications of Si thin film solar cells. It was found that electrical conductivity of the films at room temperature reached a value of 0.4 S/cm. This value is 2-3 orders of magnitude higher than that of TiO₂ films prepared by RF magnetron sputtering and electron-beam evaporation methods in our previous works. The conductivity improvement seems to be partly due to the enlargement of TiO₂ crystallites.     

A Nifedipine Coground Mixture with Sodium Deoxycholate. II. Dissolution Characteristics and Stability

Nifedipine is a poorly water soluble drug that demonstrates low bioavailability. In a previous study, a coground mixture of nifedipine with sodium deoxycholate (DCNa), a bile salt, immediately produced colloidal particles when dispersed in water. In this study, the effect of the weight fraction of DCNa, grinding time, dissolution media, and storage conditions on colloidal particle formation in solution was investigated. The coground mixture was prepared with a vibration rod mill, and its solid state was characterized using powder X-ray diffraction. A laser diffraction particle size analyzer was used to determine the particle size distribution curve in water. The size of particles formed in solution decreased with an increase in the weight fraction of DCNa and grinding time. A nifedipine-DCNa (1 : 2 w/w) mixture coground for 30 min was used in the experiments. Colloidal particle formation from the coground mixture was also observed in dissolution media of water and a pH 6.8 buffer solution at 37°C. Most precipitates passed through a filter with a pore size of 0.8 μm, but the particle size distribution in water was different from that in the pH 6.8 buffer solution. DCNa exhibited not only micellar solubilization for drug crystals, but also a retarding effect on drug crystal growth in a supersaturated solution. The latter effect could serve to form colloidal particles in solution. When stored under 75% relative humidity at 40°C for 1 month, the amorphous coground mixture crystallized, and the particle size in water markedly increased. Therefore, the weight fraction of DCNa, grinding time, dissolution media, and humidity during storage influence the dissolution characteristics of nifedipine from a coground mixture.     

60 GHz band 64 QAM/OFDM terrestrial digital broadcasting signaltransmission by using millimeter-wave self-heterodyne system

This paper describes the first time experimental studies on 60-GHz band transmissions of terrestrial digital broadcasting signals (ISDB-T) with 64-QAM modulations on coded orthogonal frequency division multiplexing (COFDM) format. It has been a very difficult experiment to accomplish because it requires very stable and low phase-noise oscillators in the millimeter-wave band. The use of our proposed millimeter-wave self-heterodyne system, overcame this problem without using a stable oscillator, and provided a bit error rate (BER) of less than 10^-6 without any forward error correction. We also discuss the relationship between the carrier-to-noise power ratio and the BER obtained, and demonstrate that the penalty of the required CNR for our experimental system is less than 1 dB compared to the results of a back-to-back BER test     

Effects of light guides and optical filters for a high density lead glass counter

Effects of various light guides on energy resolution, position dependence of the output pulse and the hadron suppression factor were studied for a high density lead glass counter with particles of energies between 1 GeV and 16 GeV. The best hadron suppression factor was obtained for a configuration with a plastic light guide and a short wave cutoff filter at little expense to energy resolution. The energy resolution is worse at high energy and is dependent on the hit position of an incident particle for a BK7 light guide.     

EVALUATION ON LIMITATION OF LINEAR ELASTIC FRACTURE MECHANICS FOR SMALL FATIGUE CRACK GROWTH

Abstract— The growth characteristics of small fatigue cracks were investigated under rotary bending in a high tensile strength steel, and the critical crack length above which linear elastic fracture mechanics (LEFM) is applicable was evaluated systematically from the results of the present study and previous studies in which two steels having different microstructures and strengths were used. It is found that the critical crack length extends over two regions each exhibiting different growth mechanisms. These regions of microstructurally small cracks and mechanically small cracks are found to be a unique function of the microstructural unit size and the yield strength of the materials, respectively. Therefore, using these relationships, it is possible to estimate the critical crack length for a given material.     

Fermi surface of NbO

Studies of the dHvA effect have been made on NbO single crystals grown by a zone melting techniques and 13 separate frequency branches ranging from 5.2×10⁶ G to 1.2×10⁸G have been observed. To understand the origin of the dHvA frequencies, we have made a self-consistent band structure calculation. Most experimental frequencies are found to be assigned to the extremal orbits on the calculated Fermi surfaces. There is good qualitative agreement between experiment and calculation, but some quantitative discrepancies still exist. We also report some physical properties, i.e., electrical resistivity, superconducting transition temperature, and electronic specific heat, of this high-quality NbO crystal.     

Millimeter-Wave Radiometer for the Measurement of Stratospheric ClO Using a Superconductive (SIS) Receiver Installed in the Southern Hemisphere

A new sensitive radiometer for atmospheric minor constituents has been developed by Nagoya University and the National Institute for Environmental Studies (NIES). The instrument equipped low-noise superconducting (SIS) mixer with a system noise temperature of ≈200K (SSB) at 204GHz. The SIS mixer is operated in a single side band mode with a side band ratio grater than 10dB by adjusting the two tunable backshorts of the mixer. Since any additional SSB filters are not necessary, we can simplify the quasi-optical system and reduce the standing waves which makes difficult to achieve a flat spectral baseline. We installed the observation system at Las Campanas Observatory, Chile in December 1999, and started the test observation from 2000 October. We have detected significant ClO emission at 204.3 GHz with an actual observation time of only 4 hours. This is the first detection of the ClO at 40km altitude from the mid-latitude region of the southern hemisphere. The Nagoya-NIES system has enabled continuous monitoring of ClO in the stratosphere with a time resolution of 4 or 5 hours.     

Molded micro- and mesoporous carbon/silica composite from rice husk and beet sugar

A molded carbon/silica composite with high micro- and mesoporosity, as well as a high bulk density, was fabricated by activating a disk-molded precursor made from carbonized rice husk (RH) and beet sugar (BS) at 875 °C in CO₂. The pore structure of the RH- and BS-based carbon/silica composite (RBC) was analysed in relation to the bulk density. An activation time of 2.0 h provided the largest BET specific surface area (1027 m²/g) and total pore volume (0.68 cm³/g) and a low bulk density (0.54 g/cm³). An RBC that was first activated for 1 h was immersed again in BS syrup and then activated in CO₂ for 1 h. This two-step activation process provided both a high bulk density (0.69 g/cm³) and a highly textured structure (BET specific surface area, 943 m²/g; total pore volume, 0.56 cm³/g). The immersion in BS syrup was useful for improving the texture without reducing the bulk density, in comparison to one-step activation for 1.0 h. The suspension of the RBCs was basic because of the residual inorganic compounds of potassium and calcium. However, the basicity of the suspension was alleviated by washing the RBCs with water.