Flow cytometric and microscopic evaluation and effect on fertility of abnormal chromatin condensation in bovine sperm nuclei

The techniques of Feulgen staining, acridine orange staining, and a sperm chromatin structure assay using acridine orange and flow cytometry were compared for selective examination of bovine sperm nuclei. Twenty frozen semen samples were simultaneously analysed by all three methods. The prevalence of abnormally condensed DNA and its relationship to other semen traits were determined in ejaculates from 70 bulbs presented for routine examination for breeding soundness and in frozen semen from 348 bulls evaluated over five years. A breeding trial with 118 beef heifers using semen from six bulls with different degrees of nuclear abnormalities was performed to assess the importance of the defects with respect to fertility. The results indicate that few spermatozoa with abnormal DNA condensation are found in normal semen, but the incidence increases with disturbance of spermatogenesis. However, high numbers of abnormally condensed nuclei were found in the absence of an increase in other defects. This nuclear defect might be at least partially of epididymal origin; it can lower fertility and can be compensated for by increasing the numbers of normal spermatozoa in the insemination dose. The percentage of abnormally condensed sperm nuclei as detected by Feulgen staining was significantly correlated with that detected by microscopy after acridine orange staining and by the sperm chromatin structure assay. We therefore consider the Feulgen technique to be a valuable tool for assessing the nuclear integrity of bovine spermatozoa.     

Impact of the floating-point precision and interpolation scheme on the results of DNS of turbulence by pseudo-spectral codes

In this paper we investigate the impact of the floating-point precision and interpolation scheme on the results of direct numerical simulations (DNS) of turbulence by pseudo-spectral codes. Three different types of floating-point precision configurations show no differences in the statistical results. This implies that single precision computations allow for increased Reynolds numbers due to the reduced amount of memory needed. The interpolation scheme for obtaining velocity values at particle positions has a noticeable impact on the Lagrangian acceleration statistics. A tri-cubic scheme results in a slightly broader acceleration probability density function than a tri-linear scheme. Furthermore the scaling behavior obtained by the cubic interpolation scheme exhibits a tendency towards a slightly increased degree of intermittency compared to the linear one.     

The Swedish approach to research and development in fire protection

Current Research Activities

The Swedish approach to research and development in fire protection     

(S)-Reutericyclin: Susceptibility Testing and In Vivo Effect on Murine Fecal Microbiome and Volatile Organic Compounds

We aimed to assess the in vitro antimicrobial activity and the in vivo effect on the murine fecal microbiome and volatile organic compound (VOC) profile of (S)-reutericyclin. The antimicrobial activity of (S)-reutericyclin was tested against Clostridium difficile, Listeria monocytogenes, Escherichia coli, Enterococcus faecium, Staphylococcus aureus, Staphylococcus (S.) epidermidis, Streptococcus agalactiae, Pseudomonas aeruginosa and Propionibacterium acnes. Reutericyclin or water were gavage fed to male BALBc mice for 7 weeks. Thereafter stool samples underwent 16S based microbiome analysis and VOC analysis by gas chromatography mass spectrometry (GC-MS). (S)-reutericyclin inhibited growth of S. epidermidis only. Oral (S)-reutericyclin treatment caused a trend towards reduced alpha diversity. Beta diversity was significantly influenced by reutericyclin. Linear discriminant analysis Effect Size (LEfSe) analysis showed an increase of Streptococcus and Muribaculum as well as a decrease of butyrate producing Ruminoclostridium, Roseburia and Eubacterium in the reutericyclin group. VOC analysis revealed significant increases of pentane and heptane and decreases of 2,3-butanedione and 2-heptanone in reutericyclin animals. The antimicrobial activity of (S)-reutericyclin differs from reports of (R)-reutericyclin with inhibitory effects on a multitude of Gram-positive bacteria reported in the literature. In vivo (S)-reutericyclin treatment led to a microbiome shift towards dysbiosis and distinct alterations of the fecal VOC profile.     

Analytical studies on the temperature distribution in spiral plate heat exchangers: Straightforward design formulae for efficiency and mean temperature difference

The temperature distribution in spiral plate heat exchangers has been calculated numerically to obtain the efficiency and the logarithmic mean temperature difference (LMTD) correction factors F as a function of the number of transfer units N, the number of turns n, and the heat capacity rate ratio C. It has been found that the LMTD correction factors, when plotted against the number of transfer units per turn N/n, fall approximately on a single curve. That curve for balanced countercurrent operation (C = −1) can be very closely represented by the simple formula F = (n/N)tanh(N/n). From that simple analytic representation of our numerical results it was concluded that a simpler physical model might exist to represent the overall behaviour of a spiral plate heat exchanger equally well. In fact, a countercurrent cascade of n cocurrent heat exchangers does result exactly in the above-mentioned formula for the LMTD correction factor. From that model the F-factors for other heat capacity rate ratios C (−1 < C 0) can also be calculated and they are in sufficient agreement with the numerical results.     

Energieinformatik

Due to the increasing importance of producing and consuming energy more sustainably, Energy Informatics (EI) has evolved into a thriving research area within the CS/IS community. The article attempts to characterize this young and highly dynamic field of research by describing current EI research topics and methods and provides an outlook of how the field might evolve in the future. It is shown that two general research questions have received the most attention so far and are likely to dominate the EI research agenda in the coming years: How to leverage information and communication technology (ICT) to (1) improve energy efficiency, and (2) to integrate decentralized renewable energy sources into the power grid. Selected EI streams are reviewed, highlighting how the respective research questions are broken down into specific research projects and how EI researchers have made contributions based on their individual academic background.     

Infrared heated μ-blistering,a new fabrication technology for HARMST

Polymeric replication technologies such as injection moulding or hot-embossing have gained wide acceptance in the microtechnological community, microthermoforming of thin polymer foils, also called μ-blistering, still remains relatively unknown. Although the general potentials of the µ-blistering have already been pointed out, little work has been carried out addressing its capability for high aspect ratio microstructuring. In the scope of this work we therefore demonstrate the feasibility of μ-blistering to obtain aspect ratios for free standing structures of up to 7 within a process cycle time of <4 min. The presented processing technology uniquely combines manufacturing of macro-, micro- and even nanoscopic feature sizes in a single process.     

Hierarchical opacity optimization for sets of 3D line fields

The selection of meaningful lines for 3D line data visualization has been intensively researched in recent years. Most approaches focus on single line fields where one line passes through each domain point. This paper presents a selection approach for sets of line fields which is based on a global optimization of the opacity of candidate lines. For this, existing approaches for single line fields are modified such that significantly larger amounts of line representatives are handled. Furthermore, time coherence is addressed for animations, making this the first approach that solves the line selection problem for 3D time‐dependent flow. We apply our technique to visualize dense sets of pathlines, sets of magnetic field lines, and animated sets of pathlines, streaklines and masslines.