The Solutions for Adjustment and Reconstruction of Water-Drive Surface Systems in the Old Areas of Daqing Oilfield

Introduction 　　Owing to long-time running, more facilities including stations, pipelines, vessels have become corrosive and aged ,some process has grown old, it has exert more burden for the maintenance and repair.Simultaneously, the fluid production rate, oil production rate and water injection rate has changed greatly so that the inflicts and problems from the established surface systems will become more obvious. Energy cost of production and running has increasing continuously. Capacity has been unbalance in systems and areas. 　　……     

关于粒子加速器人身辐射安全联锁系统设计原则的建议

本文讨论了在粒子加速器上的联锁系统设计中应遵循的一些原则,其中建立隔离区、“失效导致安全(Fail-safe)”,使用“硬件”、“多重联锁”、设置急停开关等是最重要的。     

Environmental-stress-screening using degradation measurements

ESS (environmental stress screening) has been extensively used to reduce infant mortality by precipitating defects. The existing ESS plans precipitate defects by stressing all products for specified durations. The plans usually require long screen durations to allow nearly all defective items to fail, and thus generate excessive aging effects on good items. For some products, failures are defined in terms of performance characteristics exceeding their critical values. This paper describes the principles of using degradation measurements of performance characteristics to screen the products. In an ESS, the performance characteristics of defective items degrade considerably faster than those of good ones, yielding a bimodal distribution of the characteristics. As screen duration increases, the 2 modes of the distribution shift apart. It is possible to find a tightened critical value to weed out the defective items before they fail. This paper, based on these principles, further designs the optimal 2-level screen plans which minimize a segment of life-cycle cost and which simultaneously meet the reliability requirement. The minimum cost is achieved by choosing optimal part-level and unit-level screen durations and tightened critical values of parts. A numerical example is followed by discussion. Because the ESS regime of this paper allows defective parts to be screened out before they fail, the developed optimal ESS plans can reduce life-cycle cost, shorten part-level screen duration, and alleviate aging effects on good products     

Guest Editorial

The UK-China Research Network on Intelligent Automation, Computing and Manufacturing has been established since September 2004 by grants from the Engineering and Physical Sciences Research Council (EPSRC) of the UK and the National Natural Science Foundation of China. The initiative of the network is motivated by the last visit of the UK Science Minister Lord Sainsbury to China to open the first UK-China Hi-Tech Forum and by the current EPSRC initiative to set up specific network programmes in collaboration with partners in China.     

A network management architecture for robust packet routing in meshoptical access networks

We describe an architecture for an optical local area network (LAN) or metropolitan area network (MAN) access. The architecture allows for bandwidth sharing within a wavelength and is robust to both link and node failures. The architecture can be utilized with an arbitrary, link-redundant mesh network (node-redundancy is necessary only to handle all node failures), and assumes neither the use of a star topology nor the ability to embed such a topology within the physical mesh. Reservation of, bandwidth is performed in a centralized fashion at a (replicated) head end node, simplifying the implementation of complex sharing policies relative to implementation on a distributed set of routers. Unlike a router, however, the head end does not take any action on individual packets and, in particular, does not buffer packets. The architecture thus avoids the difficulties of processing packets in the optical domain while allowing for packetized shared access of wavelengths. We describe the route construction scheme and prove its ability to recover from single link and single node failures, outline a flexible medium access protocol and discuss the implications for implementing specific policies, and propose a simple implementation of the recovery protocol in terms of state machines for per-link devices     

用硫酸铁铵容量法测定钛精矿中二氧化钛含量

样品在过氧化钠熔融、水浸取及盐酸酸化后，在盐酸和硫酸介质中，隔绝空气，用金属铝将钛(Ⅳ)还原至钛(Ⅲ)，以硫氰酸盐为指示剂，用硫酸铁铵标准溶液滴定。     

首钢外购焦炭质量恶化后的高炉生产实践

针对焦炭质量劣化的状况，高炉操作以活跃炉缸为主，从上下部调剂入手，采取疏导煤气、控制合理的实际风速和鼓风动能、缓解焦炭在高温区的粉化等措施，有效地改善了高炉的顺行状况，并逐步恢复高炉指标。     

Cooling and Solidification of Melted Drops in an Immiscible Cooling Medium

The cooling and solidification of melted drops during their movement in an immiscible cooling medium is widely employed for granulation in the chemical industry, and a study of these processes to provides a basis for the design of the granulation tower height and the temperature of the cooling medium is reported. A physical model of the cooling and solidification of the drop is established and the numerical calculation is performed. The influences of the key factors in the solidification, i.e., Bi number, drop diameter, temperature of the cooling medium, etc. are presented. The cooling and solidification during wax granulation in a water‐cooling tower and during urea granulation in an air‐cooling tower (spraying tower) are described in detail. Characteristics of the solidification and temperature distribution within the particle at different times are shown. The model and calculations can be used for structure design of the granulation tower and optimization of the operation parameters.