Calculation of the standard heat capacities of crystalline oxides in the Fe-O-Ti system

Our earlier experimental studies of the solid-phase reduction of disseminated lump ores demonstrate that an oxide lattice transforms into a metal lattice via the saturation of the oxide crystal lattice by charged oxygen vacancies. Low-charge metal cations appear in the oxide crystal lattice, and they are related to oxygen vacancies by the condition of local electrical neutrality. As oxygen vacancies are accumulated (i.e., during reduction), the number of oxygen vacancy-low charge cation complexes in the initial oxide increases. The total composition of the oxide phase in the range of a crystal lattice of a certain type changes continuously from the initial oxide to the end product of reduction, i.e., to the lower oxide or a metal. Therefore, it is necessary to determine the thermal characteristics of not only all possible stoichiometric compounds in the M-O system but also MO_x oxides of variable compositions. Equations for calculating the standard heat capacities of complex stoichiometric oxides and oxides of variable compositions in the Fe-O-Ti system are derived using a mathematical model developed earlier, and these characteristics are calculated.     

Synthesis of minerals using alternative energy sources

A technology for the synthesis of synthetic minerals (using the example of spinels) using a low-temperature plasma flame is developed. The diagnostic properties of spinels are identified.     

Low temperature and strain rate dependence of fracture stress and fracture toughness on thin Fe40Ni40B20 amorphous ribbon

The fracture stress and the critical stress intensity factor of the Fe₄₀Ni₄₀B₂₀ amorphous metallic ribbons 20 μm thick were measured in the temperature range 4.2–300 K and at deformation rates from 3.3×10⁻⁶ to 1.25×10⁻³ m⁻¹ with the aim to obtain more information on the condition for the onset and development of the inhomogeneous plastic deformation and fracture.     

Simple approach to analysis of switched-capacitor circuits with nonideal op-amps

A possible method for the simulation of nonideal op-amps with a finite gain and bandwidth by means of an equivalent SC circuit, containing ideal components, is presented. The approach is extended by the case of an op-amp with non-switched input SC building blocks.     

Effect of the magnetic-flux variations on SQUID stability

The oscillation dynamics of a nonhysteretic, one-contact superconducting quantum interferometer under low-frequency modulation of an external magnetic flux has been studied. It is shown that even in the case of adiabatic, equilibrium, and nonhysteretic operation modes of a superconducting ring enclosed by a weak link, there can appear chaotic oscillations. The conditions of chaos arising have been considered analytically and numerically; mechanisms and destruction scenarios of periodic oscillations have been studied. The stochastic instability could impose limitations on the increase in sensitivity of nonhysteretic SQUIDs, which was earlier predicted to be high enough.     

Copper(II) removal from aqueous solutions by fly ash

The removal of Cu(II) by adsorption on fly ash has been found to be concentration, pH and temperature dependent. The kinetics of adsorption indicates the process to be diffusion controlled. The Langmuir constants have been calculated at different temperatures, and the adsorption has been found to be endothermic (ΔH = 15.652 kcal mol^?1). The maximum removal is observed at pH 8.0, and variation in adsorption with pH has been explained on the basis of surface ionisation and complexation.     

Deoxidation with silicon and the control of oxide inclusions in electrical steels

The oxygen solubility in Fe-Si melts in equilibrium with SiO₂ at 1873 K has been determined in a concentration range of 0.1–70 wt % Si. Model alloys are melted in quartz crucibles in an argon atmosphere. The oxygen content in analytical samples is determined by the inert-gas reducing-fusion method after careful sample preparation. The results obtained have been processed using a thermodynamic model that can calculate the oxygen activity and solubility in Fe-Si melts up to 100 wt % Si. The effects of the heating rate and the silicon content on the carbon concentration in carbonyl iron and Fe-Si alloys are studied using the inert-gas reducing-fusion method in the temperature range 1673–2373 K. Oriented electrical steels are investigated using fractional gas analysis. The main forms of oxygen in these steels are found to be silicates, Al₂O₃, and MgAl₂O₄.     

板载电源模块--开放式与封闭式的选择

目前,分布式电源架构被广泛用于通信和计算设备中,该电源架构经常采用板载电源(BMP)模块,在尽可能靠近负载点的地方进行电源变换.