The depositional environment of zinc, lead and cadmium in reservoir sediments

Despite low water retention dams and intervening reservoirs, reservoirs located downstream from a lead-zinc mining and milling area contain relatively higher concentrations of zinc, lead and cadmium than reservoirs in other areas. These metals are also concentrated in reservoir bottom sediments relative to surrounding soils. The zinc and lead content closely correlates to depth of water, organic content and percentage of clay-sized sediments. Zinc is preferentially weathered and transported from its source relative to lead. A model is developed in which the zinc and lead are transported by ionic and/or organo-metallic solution into reservoirs. Because of the relatively long residency time of water in reservoirs, the zinc and lead in the water is removed by clay minerals. Most of the zinc and lead content of the sediments is shown to be associated with sediments of specific gravity between 2·0 and 2·9. The efficiency of these reservoirs as a sink for zinc and lead results in the removal of an average 0·3 ppm zinc and 0·04 ppm lead from waters passing through Fort Gibson Reservoir.     

The effect of temperature on the removal of non-ionic surfactants during small-scale activated-sludge sewage treatment—I. Comparison of alcohol ethoxylates with a branched-chain alkyl phenol ethoxylate

The degree of biodegradability of three non-ionic surfactants has been assessed using small-scale activated-sludge sewage treatment plants. The effect of temperature on biodegradability was studied by operation at 15°, 11° and 8°C.The two alcohol ethoxylate surfactants tested were well degraded at all three operating temperatures. The alkyl phenol ethoxylate surfactant tested was well degraded at 15°C but at lower temperatures the biodegradability was dependent on concentration. At 5 mg 1⁻¹, greater than 90 per cent removal was achieved but at 20 mg 1⁻¹ the degree of removal fluctuated between 40 and 95 per cent at 11°C and between 20 and 80 per cent at 8°C.The present results have been compared with those obtained using the same surfactants in community trials at a small sewage works employing biological filtration. Although a similar temperature effect was observed with the alkyl phenol ethoxylate, the biodegradabilities obtained in the laboratory were consistently greater than those obtained at the sewage works, perhaps because of the constant conditions of the laboratory test.     

Paleonutritional analysis of the pre-Hispanic population from Fuerteventura (Canary Islands)

In this study, from histological and chemical perspectives, we analyse the human remains belonging to the pre-Hispanic inhabitants from Fuerteventura (one of the Canary Islands) and compare the results with those obtained on a sample of pre-Hispanic inhabitants from Gran Canaria (Canary Islands). We observe that trabecular bone mass was normal in the samples from Fuerteventura except for an elderly woman; this result is in sharp contrast with the decreased bone mass observed in the population from Gran Canaria. The pre-Hispanic population from Fuerteventura showed lower bone strontium, Sr/Ca ratio, and bone barium, but slightly higher bone copper, than that from Gran Canaria. All these data indicate a greater consumption of marine products by the population of Fuerteventura. The high prevalence of osteoporosis observed in the population from Gran Canaria may be interpreted as a consequence of protein-calorie malnutrition, a condition which seemed to be not so prevalent in the population of Fuerteventura.     

Comparative analysis and performance of load bearing characteristics of biogas and gasoline-fuelled electric generator

ABSTRACT

This research demonstrates a simplified purification of biogas from hybrid waste and conversion of a single cylinder spark ignition engine to use biogas. The scrubbed gas obtained showed 95% methane enriched biogas. The carburettor of the gasoline engine was modified with a tri-fuel carburettor to suit the input specimen fuel fed to the modified 2.5 kVA, 230 V, and 50 Hz reciprocating engine to generate power. Results showed that 1 kg of compressed biogas ran for 46 min with a load capacity of 1800 W on the 2.5 kVA modified generator, while a litre of gasoline ran for 72 min under the same loading capacity. A comparative assessment of the load bearing characteristics was conducted. Load condition exceeding 1000 W resulted in a voltage output drop of 14.25% on biogas while a small change in voltage of 0.06% occurred for loading conditions between 100 and 1000 W. There was 8.5% decrease in engine speed while operating on biogas with little or no change on gasoline. Maximum torque of 5 and 3.5 Nm at 1800 W electric loading was experienced for gasoline and biogas. Finally, the BSFC for gasoline and biogas at 15% loading condition was maximum at 2000 and 2400 kg/kWh, respectively.     

Structural analysis of assemblages of thin-walled members

A matrix method for the analysis of structural systems composed of thin-walled members is presented. The matrix displacement analysis includes the effects of thin-walled non-uniform torsion theory, cross-section asymmetry, eccentric restraint as well as joint types peculiar to thin-walled members. The method is used for a prediction of the elastic behaviour of a set of representative test frames. The test frames were pitched-roof portals constructed from channel sections bent about their major-axis and supported by eccentric restraints simulating purlins and girts.     

Sensory evaluation of drinking water by consumer panels

The human senses play an important role in assessing the quality of food and of the environment. Particularly the chemical senses of taste and smell determine the pleasantness of foods and drinks and may provide a warning mechanism for the presence of more or less toxic contaminants. Even after the recent rapid development of powerful analytical techniques the human nose can easily detect trace amounts of chemicals at levels manytimes lower than the analytical detection limits.Although taste and odour assessment of drinking water has been practized inmany waterworks laboratories by small panels, relatively unreliable results were obtained and such sensory data played up till now only a minor role in the management of the water treatment plant. More sophisticated and reliable methods for sensory water quality evaluation are discussed. Special attention is given to the characteristics of the human senses of taste and smell, to which the methodology of sensory assessment should be better adapted. High numbers of observations on a sample are generally needed, for which purpose the use of large panels has to be realized. In this respect the help of large consumer panels is an alternative for the presently often used small laboratory groups. As an example the preliminary results of a large ongoing experiment of sensory water quality assessment by 2 consumer panels of 100 persons each in the Rotterdam area are discussed. Drinking water quality is judged at the consumer homes every week. The experiment started September 1979 and will be continued for one year.     

The direct measurement of ppm levels of uranium in soils using high-resolution Ge(Li) gamma-ray spectroscopy

The direct determination of ²³⁸U in various soil samples was done by measuring the 63.3-keV transition from the decay of the first daughter ²³⁴Th. Potential errors resulting from the chemical non-equilibrium of ²³⁸U with its daughters are thus avoided. The method sensitivity is 1 ppm compared to the 35 ppm obtainable by employing the 1001-keV gamma ray. A Ge(Li) gamma-ray spectrometer is the only analytical tool required. Examples are offered that demonstrate the usefulness of the technique for routine, inexpensive environmental monitoring of uranium. The technique also has the capability of providing information on the ²³⁸U/²³⁵U isotopic ratio.     

Dynamic modelling and control applications in water quality maintenance

The purpose of this paper is to develop and illustrate a unified, systematic approach to problems of water quality management. In order to achieve this a water quality system is defined as the following group of component features: the abstraction, purification, and supply of potable water from a river: consumer effluent, rainfall-runoff from an urban land surface, and the sewer network; the wastewater treatment plant: the river itself. A systems analysis approach to the study of the dynamic and control aspects of the system is discussed, with particular reference to the practical limitations of instrumentation and technology. In an attempt to blend the theory with the practice recent studies on the dynamic modelling and control of parts of the water quality system are reviewed. Special attention is paid to the practical application of techniques of system identification and parameter estimation. Finally, piecing together several individual results, it is possible to give a good indication of the manner in which control studies should be directed in the near future.