Calculation of temperature field near stagnation point in explosive welding

0IntroductionResearch of temperature field near stagnation pointquantificationally is of great importance to control the qual-ity of explosive welding. If the temperature at the weldinginterface is too high the material will melt in excess andthe metal plates can not be welded well and if the tempera-ture is too lowthe plates can not be well-knit. At the sametime to calculate the heat behavior in the flow field of ex-plosive welding quantificationally is the basis to analyze themetallurgic eff…     

BNi—2钎焊条的真空吸铸工艺

研究了ＢＮｉ－２钎焊条真空吸铸原理，并由试验得出：当ＢＮｉ－２合金加热到１５００℃，真空控制阀门开口为φ６ｍｍ以上，真空度５０ｋＰａ，铸型预热温度５００℃，并用φ内２ｍｍ×５００ｍｍ石英管进行真空吸铸时，吸铸高度可达到４０ｃｍ以上。     

In-plane anisotropy of 1545 aluminum alloy sheet

1　INTRODUCTIONThe in plane anisotropy of mechanical proper ties brings the limitation to the use of alloy sheet.At the same time, during the material processing,the difficulties of contour machining will also be in creased. For this reason, when designing high performance aluminum alloy sheets, the in planeanisotropy is an important performance parameterthat must be considered. Studies have shown thatminor Sc and Zr in the Al Mg Mn alloy can refinegrains of cast ingot, inhib…     

钪系阴极基体的研究

采用氧化钪与钨机械混合、氧化钨与钪盐水溶液固液掺杂法制备了氧化钪-钨基体，采用扫描电镜及原位俄歇电子能谱方法研究了基体中钪的分布及阴极基体的抗离子轰击性能。结果表明，采用液固法制备的烧结体，氧化钪分布均匀，这样的结构有利于钪的扩散和补充，原位俄歇轰击实验结果表明，阴极基体具有良好的耐高温和耐离子轰击性。     

冷硬树脂砂在球墨铸铁和铸钢件上的应用

介绍了冷硬树脂砂在该厂球墨铸铁和铸钢件上的应用。     

Effect of surface free energy of ceramic glaze on oil droplet shape and its behavior in water

A super-hydrophilic functional ceramic was prepared by adjusting the chemical components of ceramic glaze. Effect of surface flee energy of ceramic glaze on oil droplet shape and its behavior in water were studied. The results show that water can spread on ceramic surface with high surface free energy, and oil droplet can aggregate rapidly and separate from the ceramic surface in water. For the ceramic with lower surface free energy, the polar shares are dependant on its easy-cleaning property. The higher the polar shares, the better the easy-cleaning property, and the easier the droplet separates from the ceramic surface in water.     

200kA预焙槽强化电流过程中发生电解质粘度增加的实践探讨

通过分析200kA预焙槽在强化电流条件下电解质粘度增大的原因及对电解生产的影响,提出了规范电解生产作业制度及处理电解质粘度过大的建议,以实现降低工人劳动强度,达到工艺参数优化和提高电流效率的目的。     

Stress corrosion behavior of pipeline steel(X52)welded joint

The resistance of pipeline steel joint welded by submerged arc welding to stress corrosion cracking (SCC) at its different regions in boiling mixed nitrate solution and in H_2S saturated solution at room temperature is examined by the constant-load tension method. The result shows that when tested in nitrate, the weld metal may be the weakest link of the joint if the welding material doesn't match well. The resistance to SCC of the joint in H_2S is very low, especially at the bond and coarse grain zone and is closely dependent on the metallurgical quality of base metal.     

挤压后硼酸铝晶须增强铝复合材料表面的腐蚀特征

利用原于力显微镜观察了挤压态Al18B4O33 w／pure Al复合材料早期腐蚀过程中表面形貌的变化特征．研究了沿与挤压方向成不同角度截取的Al18B4O33 w／pure Al复合材料在3．5％NaCl溶液中的腐蚀规律．结果表明：晶须与基体的界面是腐蚀易于发生的地方．点蚀首先在晶须的端部产生，随后沿着晶须与基体的界面扩展．挤压后沿与挤压方向成不同角度截取的Al18B4O33 w／pure Al复合材料表面腐蚀坑的深度存在差别．