Ion implantation doping of OMCVD grown GaN

Doping by ion implantation using Si, O, Mg, and Ca has been studied in single crystal semi-insulating and n-type GaN grown on a-sapphire substrates. The n-and p-type dopants used in this study are Si and O; Mg and Ca, respectively. Room temperature activation of Si and O donors has been achieved after 1150°C annealing for 120 s. The activation of Mg and Ca acceptors is too low to measure at both room temperature and 300°C. Using higher doses to achieve a measurable p-type conduction increases the amount of damage created by the implantation. Rutherford back scattering measurements on this material indicate that the damage is still present even after the maximum possible heat treatment. Secondary ion mass spectrometry measurements have indicated a redistribution in the measured profiles of Mg due to annealing.     

Fast‐scale bifurcation in power‐factor‐correction buck‐boost converters and effects of incompatible periodicities

In this paper, we derive the discrete‐time model for the power‐factor‐correction (PFC) buck‐boost converter in terms of a stroboscopic switching map. Fast‐scale instability is analysed through a fold diagram, which exposes the periodicity of the operation as well as the locations of the critical phase angles of the line voltage at which instability begins to occur along a half‐line cycle. The asymmetrical locations of the critical phase angles along a half‐line cycle is explained in terms of ‘under‐developed’ bifurcation. Border collision bifurcations are observed and analysed in detail. Copyright © 2006 John Wiley & Sons, Ltd.     

Structure and Magnetic Properties of LaCo_(13-X)M_X Intermetallic Compounds

ＳｔｒｕｃｔｕｒｅａｎｄＭａｇｎｅｔｉｃＰｒｏｐｅｒｔｉｅｓｏｆＬａＣｏ＿（１３－Ｘ）Ｍ＿ＸＩｎｔｅｒｍｅｔａｌｌｉｃＣｏｍｐｏｕｎｄｓＷＵＪｉａｎＭｉｎ；ＬＩＦｅｎｇ；ＴＡＩＬｉＣｈｉａｎｄＺＨＥＭＧＱｕｎＳｔｒｕｃｔｕｒｅａｎｄＭａｇｎｅｔｉｃＰ...     

短毫米波和亚毫米波接收机的发展现状

本文概述了短毫米和亚毫米波接收机的发展现状，介绍了接收机的重要组成部件：混频器、振荡器和放大器的发展水平以及毫米波单片集成电路的现状，给出了接收机的最新性能指标。     

CALCULATION ON TWO-PHASE FLOW TRANSIENTS AND THEIR EXPERIMENTAL RESEARCH

From basic equations of gas-liquid, solid-liquid, solid-gas two-phase flow, the calculating method on flow transients of two-phase flow is developed by means of characteristic method. As one example, a gas-liquid flow transient is calculated and it agrees well with the experimental result. It is shown that the method is satisfactory for engineering demand.     

新型处理药剂（EP-110）处理各种重金属离子的实验研究

各行各业生产过程中会产生大量废水,重金属离子污染物是其中的重要控制指标,传统的处理方法不能完全解 决这类污染。本文通过大量的实验数据,对新型的处理药剂(EP-110)处理各种重金属离子的性能做了全面的测试、分析,并 提出了使用方法。     

一种可调节电流的电流型PWM直流转换器

介绍一种用于驱动发光二极管(LED)的可调节电流的电流型PWM直流转换器.该直流转换器由于接有一个外接电阻,可以通过调节外接电阻的大小来调节输出电流.输出电流调节范围在5～40mA之间.主要分析了电路的输出电流调节功能,和这种输出电流可变的电流型PWM直流转换器的电流和电压反馈环的反馈实现原理.并简要介绍了这种带电流调节功能的PWM直流转换器的工作原理,最后给出了电路在输出不同电流时使用HSPICE软件对反馈参考电压,PWM锁存器输出波形的仿真结果.     

Effects of potential and heat treatment on phase transition of alumina dielectric layer

The characteristics and growth behaviors of alumina dielectric layer formed by anodic oxidation were investigated. The aluminum oxide layer anodized at 400 V was predominantly amorphous alumina, but at the applied potentials more than 500 V, amorphous and crystalline γ-alumina were existed in anodic oxide layer and the ratio of γ-alumina increased with the increasing applied potential. During the heat treatment at 600^°C or higher temperature, amorphous alumina layer was transformed into the crystalline γ-alumina. The phase transition of anodic amorphous alumina into crystalline depends on anodic applied potentials and heat-treatment temperatures.     

Synthesis and characterization of a novel proton‐exchange membrane for fuel cells operating at high temperatures and low humidities

The synthesis of a p‐toluidine/formaldehyde (PTF) resin was performed, and the effects of the molar ratio of the individual monomers and the polymerization conditions on the structure of the PTF resin were studied. Fourier transform infrared and ¹³C‐NMR spectra were used to characterize the PTF. Wide‐angle X‐ray diffraction patterns revealed the crystalline structures of various PTFs. Polarized optical microscopy revealed that the molar ratio of the monomers had a strong effect on the crystalline morphologies. A longer polymerization time turned out a polymer with a higher intrinsic viscosity and molecular weight, which led to differences in the proton conductivity. All of the PTFs showed a higher proton conductivity than a commercial Nafion membrane at 90–100°C and 0% relative humidity. The proton conductivity of the PTF series could be improved by sulfonation with sulfuric acid and could be maintained after blending with polyurethane. Pure methanol could be used as a fuel source because of the insolubility and nonwetting properties of PTF in methanol to increase the output current density for a PTF membrane electrode assembly. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 2008     

Scaling laws and internal structure for characterizing electrospun poly[(R)-3-hydroxybutyrate] fibers

Using chloroform/dimethylformamide (CF/DMF) co-solvent, electrospinning of poly[(R)-3-hydroxybutyrate] (PHB) solutions was carried out at ambient temperature. The effects of the applied voltage (V), flow-rate (Q), and solution viscoelastic properties on the Taylor cone, electrified jet, and fiber morphology were investigated. In addition, the electric field developed by the needle-plate electrode configuration was calculated using a finite element analysis to reveal the tip-to-collector (H) effect. Among the processing parameters (V, Q and H), it was found that Q played a key role in determining the jet diameter (d_j) and electrospun fiber diameter (d_f), and scaling laws existed between them, i.e., d_j-Q^0.61 and d_f-Q^0.33. The diameter reduction ratios of D_o/d_j (D_o is the needle diameter) and d_j/d_f were measured as 50-120 and 5-10, respectively; it suggested that major jet stretching took place in the straight electrified jet region, and further chain orientation could be gained by the subsequent process of jet whipping. By changing PHB concentrations from 5 to 15 wt%, the solution viscosity (η_o) was increased from 100 to 4900 cP, whereas the surface tension and solution conductivity remained unchanged; it provided a good model solution to exclusively reveal the η_o effect on the electrospinning process. Our results showed that the η_o-dependence of d_j and d_f also followed simple scaling laws: d_j-η_o^0.06, and d_f-η_o^0.39, with a prefactor depending on the processing variables, mainly the flow-rate. Regardless of the PHB concentrations used, the obtained PHB fibers showed a similar crystallinity fraction of ca. 0.63 and possession of major α-crystals together with a small amount of β-crystals with zigzag chain conformation.