Development of a biodegradable sirolimus-eluting stent coated by ultrasonic atomizing spray

In this study, poly(D,L lactic-co-glycolic acid) (PLGA) was used as a drug carrier to generate two types of stents loaded with different concentrations of sirolimus. These stents were prepared by ultrasonic atomizing spray coating. Ultrasonic atomizing spray nozzle uses a low-pressure air/gas to produce a soft, highly focused beam of small spray drops. An isolated hypotube delivers liquid to the nozzle's atomizing surface while air/gas, delivered through the nozzle orifice at a fixed low pressure, shapes the atomized drops into a very precise, targeted spray. The stent was moved both in the traverse direction and rotated during the spraying process. The morphology of the sirolimus-eluting stents was examined by scanning electron microscopy (SEM) which indicated that the coating was very smooth and uniform. The coating was found to have the ability to withstand the compressive and tensile strains imparted without cracking during the stent inflation process. Release profile of sirolimus was measured by high performance liquid chromatography (HPLC). The release behavior of sirolimus from the stent surface had a two phase release profile with a burst release period of about 2 days, followed by a sustained and slow release phase. The mass loss behavior of PLGA appeared linear throughout most of the degradation period. At 28 days, neointimal formation was found to be significantly decreased for both sirolimus-eluting stents as compared to bare-metal stents (BMS). Assessment of vascular healing revealed an absence of increased inflammation in both sirolimus-eluting stents. Inflammation is commonly observed in drug-eluting stents (DES) with nonbiodegradable polymeric coatings. Taking these results into account, these novel sirolimus-eluting stents may be good candidates to resolve in-stent restenosis.     

Selective Coloration of Melanin Nanospheres through Resonant Mie Scattering

Black melanin inks are prepared to selectively exhibit colors under strong light, inspired by human hair. High absorbance of melanin suppresses multiple scattering, causing resonant Mie scattering predominant. Various colors can be developed as the resonant wavelength dictated by nanosphere diameter. Therefore, the melanin inks can be used to encrypt and selectively disclose multicolor patterns for anticounterfeiting applications.     

Improvement in transdermal drug delivery performance by graphite oxide/temperature-responsive hydrogel composites with micro heater

Transdermal drug delivery system (TDDS) was prepared with temperature-responsive hydrogel. The graphite was oxidized and incorporated into hydrogel matrix to improve the thermal response of hydrogel. The micro heater was fabricated to control the temperature precisely by adopting a joule heating method. The drug in hydrogel was delivered through a hairless mouse skin by controlling temperature. The efficiency of drug delivery was improved obviously by incorporation of graphite oxide due to the excellent thermal conductivity and the increased interfacial affinity between graphite oxide and hydrogel matrix. The fabricated micro heater was effective in controlling the temperature over lower critical solution temperature of hydrogel precisely with a small voltage less than 1 V. The cell viability test on graphite oxide composite hydrogel showed enough safety for using as a transdermal drug delivery patch. The performance of TDDS could be improved noticeably based on temperature-responsive hydrogel, thermally conductive graphite oxide, and efficient micro heater.     

An in vivo Evaluation of Ultra-fine Grained Titanium Implants

The present work focuses mainly on an in vivo evaluation of ultra fine grained titanium(UFG-Ti) obtained by severe plastic deformation(SPD).The SPD on commercially produced Grade 2 titanium(Cp-Ti) resulted in the refinement of the grain size by several orders of magnitude.Polished surfaces having similar roughness from both UFG-Ti and Cp-Ti were prepared.In vitro test revealed the presence of fibronectin,which was involved in the attachment of the cells to the substrate.Phase contrast micrographs showed the...     

Experiment and simulation on the performance of an autocascade refrigeration system using carbon dioxide as a refrigerant

The main purpose of this study is to investigate the performance of an autocascade refrigeration system using zeotropic refrigerant mixtures of R744/134a and R744/290. One of the advantages of this system is the possibility of keeping the highest pressure of the system within a limit by selecting the composition of a refrigerant mixture as compared to that in the vapor compression system using pure carbon dioxide. Performance test and simulation have been carried out for an autocascade refrigeration system by varying secondary fluid temperatures at evaporator and condenser inlets. Variations of mass flow rate of refrigerant, compressor power, refrigeration capacity, and coefficient of performance (COP) with respect to the mass fraction of R744 in R744/134a and R744/290 mixtures are presented at different operating conditions. Experimental results show similar trends with those from the simulation. As the composition of R744 in the refrigerant mixture increases, cooling capacity is enhanced, but COP tends to decrease while the system pressure rises.

Résumé

The main purpose of this study is to investigate the performance of an autocascade refrigeration system using zeotropic refrigerant mixtures of R744/134a and R744/290. One of the advantages of this system is the possibility in keeping the highest pressure of the system within a limit by selecting the composition of a refrigerant mixture as compared to that in the vapor compression system using pure carbon dioxide. Performance test and simulation have been carried out for an autocascade refrigeration system by varying secondary fluid temperatures at evaporator and condenser inlets. Variations of mass flow rate of refrigerant, compressor power, refrigeration capacity, and coefficient of performance (COP) with respect to the mass fraction of R744 in R744/134a and R744/290 mixtures are presented at different operating conditions. Experimental results show similar trends with those from the simulation. As the composition of R744 in the refrigerant mixture increases, cooling capacity is enhanced, but COP tends to decrease while the system pressure rises.     

PECVD制备氢化非晶硅薄膜的氢含量研究

采用等离子增强化学气相沉积工艺在硅片上制备a-Si:H薄膜,用傅里叶变换红外光谱仪测试薄膜的红外光谱吸收峰。研究了衬底温度、工艺压强和氢气稀释比对a-Si:H薄膜中氢含量的影响。结果表明,随着衬底温度升高,氢含量显著减小;压强增大时,氢含量也增大;氢气稀释比增大,氢含量反而减小。选择适当的工艺参数,可以控制a-Si:H薄膜的氢含量,从而改善a-Si:H薄膜性能和微结构。研究结果对低温多晶硅制造工艺也有一定的指导意义。     

Characteristics of transparent ZnO based thin film transistors with amorphous HfO2 gate insulators and Ga doped ZnO electrodes

Coplanar type transparent thin film transistors (TFTs) have been fabricated on the glass substrates. The devices consist of intrinsic ZnO, Ga doped ZnO (GZO), and amorphous HfO₂ for the semiconductor active channel layer, electrode, and gate insulator, respectively. GZO and HfO₂ layers were prepared by using a pulsed laser deposition (PLD) and intrinsic ZnO layers were fabricated by using an rf-magnetron sputtering. The transparent TFT exhibits n-channel, enhancement mode behavior. The field effect mobility, threshold voltage, and a drain current on-to-off ratio were measured to be 14.7 cm²/Vs, 2 V, and 10⁵, respectively. High optical transmittance (> 85%) in visible region makes ZnO TFTs attractive for transparent electronics.     

Shift and scale‐invariant correlation for pattern recognition based on the bidimensional empirical mode decomposition with noise robustness

Abstract

A novel filter is proposed to improve the noise robustness and discrimination capability for shift and scale invariant pattern recognition. This filter is a combination of mellin radial harmonic filter (RHF) and the bidimensional empirical mode decomposition. The basic principle of this method is to make use of partial reconstructions of the image by the relevant intrinsic mode functions corresponding to the most important structures of the image. A criterion is proposed to determine the proper number of intrinsic mode functions to be discarded for denoising by discussing the characteristic of the noise. The proposed filter provides a wider allowable scale change of the object. Within this range, the correlation peak intensity is relatively uniform even in the case of noise. This proposed filter has been tested experimentally to confirm the result from numerical simulations for cases with and without additive white Gaussian noise.     

The effect of substrate temperature on Al-doped ZnO characteristics for organic thin film transistor applications

The influence of substrate temperature on the structural, electrical, and optical properties of aluminum-doped zinc oxide (AZO) films fabricated by radio frequency (RF) magnetron sputtering was investigated. The AZO films were deposited at various substrate temperatures, and the effect of AZO gate electrode conductivity on organic thin film transistor (OTFT) performance was examined. While an increase in the substrate temperature from 100 °C to 300 °C led to an improvement in crystallinity, substrate temperatures over 300 °C caused degradation of the electrical and surface properties. We fabricated OTFTs using AZO films prepared at various substrate temperatures and obtained good device performance. Thus, the performance of an OTFT can be determined by the conductivity of the AZO gate electrode.     

Heat-Killed Enterococcus faecalis EF-2001 Induces Human Dermal Papilla Cell Proliferation and Hair Regrowth in C57BL/6 Mice

Minoxidil is the most widely used treatment for hair growth, but has been associated with several side effects. In this study, we investigated the effects of heat-killed Enterococcus faecalis EF-2001 on hair loss prevention and regrowth using human dermal papilla cells and male C57BL/6 mice. To examine the effects of EF-2001, we used minoxidil as the positive control. In the in vitro experiments, EF-2001 treatment (75–500 μg/mL) led to the proliferation of human dermal papilla cells in a concentration-dependent manner. In the in vivo experiment, the topical application of 200 µL EF-2001 on the dorsal surface of C57BL/6 male mice led to hair growth. Changes in hair regrowth were examined by visual comparison and hematoxylin and eosin staining of skin sections. We also determined the expression levels of marker genes (Wnt) and growth factors (fibroblast growth factor, insulin growth factor 1, and vascular endothelial growth factor) in the skin tissues of the back of each mouse using a quantitative polymerase chain reaction. EF-2001 accelerated the progression of hair regrowth in mice and promoted hair-follicle conversion from telogen to anagen, likely by increasing the expression levels of growth factors and marker genes.