Electrodeposition of yellow bronze from acidic sulfate baths containing polyether laprol and micromolar additives of halides

The composition of yellow bronze coatings deposited from acidic sulfate solutions added with polyether laprol and the electrodeposition conditions are studied by voltammetry and XPS. It is found that halides in rather low (micromolar) concentrations affect significantly the partial electrodeposition processes. Chlorides increases cathodic polarization, widen the current window of the yellow bronze electrodeposition, and favor the increase in tin content of the coatings. Bromides narrow the current window, lower the tin content in the coatings, and hinder the yellow bronze surface oxidation. Iodides inhibit the copper electroreduction markedly, which makes the yellow bronze deposition practically impossible. Original Russian Text ? Z. Mockus, S. Kanapeckaité, V. Jasulaitiené, A. Survila, 2006, published in Zashchita Metallov, 2006, Vol. 42, No. 5, pp. 526–531.     

Chromosome comparison between populations of the collared peccary, Tayassu tajacu, raised in captivity

The collared peccary (Tayassu tajacu) is widely distributed over the American continent, being found from the south of the USA to the north of Argentina. In Brazil, it is spread all over the country, being one of the potential species to be raised in captivity. Therefore, the cytogenetic techniques could be a potential tool for reproductive monitoring of animals raised in captivity, mainly when destined for commercial purposes. This study had the objective of determining the chromosome number of two populations raised in captivity and characterizing them by GTG banding. For this purpose, an analysis was made of mitotic metaphases obtained from lymphocyte cultures made from blood samples of 11 animals, six of which from the Northeast and five from the North of Brazil. The results of this analysis showed the same karyotype pattern for the species (2n=30 chromosomes and NF=48), besides corresponding to the South American pattern of the species, i.e., without a translocation between autosomes 1 and 8, chromosome X acrocentric, and no differences were found between the two populations studied. However, chromosomal polymorphisms were observed compared to data from the literature on populations from North and South America.     

Towards a new definition of EPOC parameters for anionic electrochemical catalysts: case of propene combustion

The electrochemical promotion of catalysis (EPOC) of propene combustion was investigated using Pt sputtered thin film on an O²⁻ conductor, 8 mol% Y₂O₃-stabilized-ZrO₂ (YSZ). In order to separate the influence of the thermal migration of the O²⁻ oxide ions from the electrolyte to the catalyst surface and the impact of an electrical polarization on the catalytic activity, several light-off experiments (cool down and heat up procedures) were successively performed under different polarizations, i.e. OCV, +2 and −2 V. These experiments have clearly shown that the presence of O²⁻ (thermally or electrochemically induced) inhibits the catalytic activity of the platinum for the propene deep oxidation. These results demonstrate the importance to define a normalized rate enhancement ratio, ρ _n , from a reference value of the catalytic rate corresponding to a Pt surface state free of O²⁻ ions.     

Sheet molding compound characterization using spiral flow

Sheet molding compound (SMC) is a fiber‐reinforced polymeric composite. It is often used in automotive, marine, and industrial applications over other materials because of its high strength to density ratio, resistance to corrosion, and low cost. There is a demand in the SMC industry to be able to characterize SMC processability. This is particularly true for heavy truck body panels, one of the fastest growing applications of SMC. Because of their large size and high strength requirement, the molding forces have a major influence in the molding cycle. Also because of the long flow paths involved, the ability of the paste to carry glass needs to be properly characterized when developing new SMC materials. In this article, we demonstrate the benefits of using spiral flow as a processability tester. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

Inspection and Process of Tension of Cables of General Rafael Urdaneta Bridge

In 1997 and 1999, inspection works were carried out in the 384 cable stays of the six central piers of General Rafael Urdaneta Bridge, located in Maracaibo, Venezuela. Inspection indicated the presence of water and significant settlings in the sockets of the cables and corrosion along each cable and socket. The tension of the cables was also measured, and differences of up to 30% in the tension of the cables of some of the 24 groups corresponding to the six central piers (four groups of 16 for each pier) were found. The results suggested the need to retension the cables. This paper shows the outcome of the inspection and indicates the procedure and results of the process of retension, finished in July 2000.     

A new amperometric biosensor for fructose determination based on epoxy-graphite-TTF-TCNQ-FDH-biocomposite

In this work a novel amperometric biosensor for fructose determination in solutions was developed. The device was constructed by the incorporation of a tetrathiofulvalene-tetracyanoquinodimethane organic conducting salt and fructose dehydrogenase enzyme, include in a polymeric matrix of epoxy resin and graphite powder. Because of the electrocatalytic function of the salt, the direct transfer of the electron between the reduced prosthetic group (PQQH₂) of the enzyme and the transducing material, was verified at a low working potential (150 mV vs. Ag/AgCl), where the interfering reactions were minimized. The response time at 90% of the steady state value was less than 20 s. The current response was directly proportional to the D-fructose concentration from 0.01 to 0.3 mmol/l with a detection limit of 0.005 mmol/l (signal/noise of 3) and a sensitivity of 1.9985 μA/mmol. The biosensor sensitivity diminishes when its surface is not polished between successive determinations, and remains constant (rsd=1.85, n=10) when the surface is polished between determinations. The effects of temperature and pH on the biosensor response were studied and analyzed; also the properties of the enzyme (Km _ap, I _max, Q₁₀) were determinate in this work. The biosensor was used to determine fructose in high fructose syrups and there were not significant differences between these results and those obtained by HPLC (p≤0.05). During 4 months, in intermittent determinations the biosensor kept 100% of its original sensitivity and after 18 months stored at 4°C, it only lost 32% of its sensitivity. The simplicity, low working potential, high stability and good performance of this biosensor shows a great potential for its use in the fructose determination.     

Experimental Investigation of the Recovery of Soaked Paper Using Evaporative Freeze Drying

The aim of this article is to develop an experiment and a procedure to investigate the restoration of water-damaged paper and archival materials using freeze drying in order to allow a reproducible test and comparison of the influence of different operating conditions on drying time and restored paper quality. Firstly, a reproducible method for the preparation of soaked samples simulating water-damaged paper has been developed. Then, the samples have been freeze-dried in a laboratory-scale apparatus that allowed monitoring the temperature as well as the weight of the samples. The technique of evaporative freezing, which reduces the drying time required, has been used in this case. An innovative procedure for the visualization of the progress of the drying process has been validated, thus allowing the validation of a simple phenomenological model of the time evolution of the ice core volume; in addition, data on the residual moisture of the dried paper sheets in different zones have been given. Finally, optimization of this particular drying process by using simple or more sophisticated approaches has been discussed.     

Karyotype description of Pomacea patula catemacensis (Caenogastropoda, Ampullariidae), with an assessment of the taxonomic status of Pomacea patula.

Mitotic chromosomes of the freshwater snail Pomacea patula catemacensis (Baker 1922) were analyzed on gill tissue of specimens from the type locality (Lake Catemaco, Mexico). The diploid number of chromosomes is 2n = 26, including nine metacentric and four submetacentric pairs; therefore, the fundamental number is FN = 52, No sex chromosomes could be identified. The same chromosome number and morphology were already reported for P. flagellata, i.e., the other species of the genus living in Mexico. The basic haploid number for family Ampullariidae was reported to be n = 14 in the literature; so, its reduction to n = 13 is probably an apomorphy of the Mexican Pomacea snails. Lanistes bolteni, from Egypt, also shows n = 13, but its karyotype is much more asymmetrical, and seems to have evolved independently from P. flagellata and P. patula catemacensis. The nominotypical subspecies, P. patula patula (Reeve 1856), is a poorly known taxon, whose original locality is unknown. A taxonomical account is presented here, and a Mexican origin postulated as the most parsimonious hypothesis.     

Genotoxic effect of Physalis angulata L. (Solanaceae) extract on human lymphocytes treated in vitro

Physalis angulata L (Solanaceae) is a medicinal plant from North of Brazil, whose different extracts and infusions are commonly used in the popular medicine for the treatment of malaria, asthma, hepatitis, dermatitis and rheumatism. However, the genotoxic effects of P. angulata on human cells is not well known. The main purpose of the present study was to evaluate the in vitro genotoxic effects of aqueous extract of P. angulata using the comet assay and the micronucleus assay in human lymphocytes provided from 6 healthy donors. Treatments with P. angulata extracts were performed in vitro in order to access the extent of DNA damage. The comet assay has shown that treatments with P. angulata at 0.5, 1.0, 2.0, 3.0 and 6.0 microg/mL in culture medium were genotoxic. Lymphocytes treated with P. angulata at the concentrations of 3.0 and 6.0 microg/mL in culture medium showed a statistically significant increase in the frequency of micronucleus (p<0.05), however, the cytokinesis blocked proliferation index (CBPI) was not decreased after P. angulata treatment. In conclusion, the present work demonstrated the genotoxic effects of P. angulata extract on human lymphocytes in vitro.     

Development of intelligent multisensor surveillance systems with agents

Intelligent multisensor surveillance systems consist of several types of sensors, which are installed on fixed and mobile devices. These components provide a huge quantity of information that has to be contrasted, correlated and integrated in order to recognize and react on special situations. These systems work in highly dynamic environments, with severe security and robustness requirements. All these characteristics imply the need for distributed solutions. In these solutions, scattered components can decide and act with some degree of autonomy (for instance, if they become isolated), or cooperate and coordinate for a complete tracking of special situations. In order to cope with these requirements and to better structure the solution, we have decided to design surveillance system control as a multiagent system. This is done by applying an agent-orientated methodology, which is assessed with concrete scenarios.