Preparation of Protein-Stabilized β-Carotene Nanodispersions by Emulsification–Evaporation Method

This work was initiated to prepare protein-stabilized β-carotene nanodispersions using emulsification–evaporation. A pre-mix of the aqueous phase composed of a protein and hexane containing β-carotene was subjected to high-pressure homogenization using a microfluidizer. Hexane in the resulting emulsion was evaporated under reduced pressures, causing crystallization and precipitation of β-carotene inside the droplets and formation of β-carotene nanoparticles. Sodium caseinate (SC) was the most effective emulsifier among selected proteins in preparing the nanodispersion, with a monomodal β-carotene particle-size distribution and a 17-nm mean particle size. The results were confirmed by transmission-electron microscopy analysis. SC-stabilized nanodispersion also had considerably high ζ-potential (−27 mV at pH 7), suggesting that the nanodispersion was stable against particle aggregation. Increasing the SC concentration decreased the mean particle size and improved the polydispersity of the nanodispersions. Nanodispersions prepared with higher β-carotene concentrations and higher organic-phase ratios resulted in larger β-carotene particles. Although increased microfluidization pressure did not decrease particle size, it did improve the polydispersity of the nanodispersions. Repeating the microfluidization process at 140 MPa caused the nanodispersions to become polydisperse, indicating the loss of emulsifying capacity of SC due to protein denaturation.     

Informational Entropy: a Failure Tolerance and Reliability Surrogate for Water Distribution Networks

Evolutionary algorithms are used widely in optimization studies on water distribution networks. The optimization algorithms use simulation models that analyse the networks under various operating conditions. The solution process typically involves cost minimization along with reliability constraints that ensure reasonably satisfactory performance under abnormal operating conditions also. Flow entropy has been employed previously as a surrogate reliability measure. While a body of work exists for a single operating condition under steady state conditions, the effectiveness of flow entropy for systems with multiple operating conditions has received very little attention. This paper describes a multi-objective genetic algorithm that maximizes the flow entropy under multiple operating conditions for any given network. The new methodology proposed is consistent with the maximum entropy formalism that requires active consideration of all the relevant information. Furthermore, an alternative but equivalent flow entropy model that emphasizes the relative uniformity of the nodal demands is described. The flow entropy of water distribution networks under multiple operating conditions is discussed with reference to the joint entropy of multiple probability spaces, which provides the theoretical foundation for the optimization methodology proposed. Besides the rationale, results are included that show that the most robust or failure-tolerant solutions are achieved by maximizing the sum of the entropies.     

Use of cascade reduction potential for selective precipitation of Au,Cu, and Pb in hydrochloric acid solution

Optimization of reduction potential for electroseparation was studied for the recovery of gold, copper, and lead from acidic solution. A linear sweep voltammetric method enabled us to determine characteristic reduction potentials for each metal and the kinetics of the metal deposition indicated by current-voltage curves. In order to precipitate the metal species sequentially, reduction potentials were examined for the individual and mixed solutions of Au(III), Cu(II), and Pb(II). The three metals were reasonably well isolated from the mixed solutions such as Cu(II)/ Pb(II) and Au(III)/Cu(II)/Pb(II) in the order of the corresponding reduction potentials, in particular, the mass transfer controlled reduction potentials, obtained from linear sweep voltammetry (LSV) measurement.     

聚氨酯丙烯酸酯紫外光固化PVC涂料的研制

通过对涂料不同组分的种类及配比进行调节,制备不同配方的PVC清漆。在测试附着力、硬度、耐温、耐水性能的基础上,优化涂料配方,并配制出性能优异的PVC清漆涂料。     

Preparation,characterization, and adsorption properties for metal ions of a novel chelating resin containing sulfoxide and diethylene glycol

A novel chelating resin containing sulfoxide and diethylene glycol, poly{4‐vinylbenzyl‐[2‐2‐(hydroxyethyl)ethoxyl]sulfoxide} (PVESO) was synthesized using chloromethylated polystyrene (PS‐Cl) as material. Its structure was characterized by elemental analysis, infrared spectra, and scanning electron microscopy (SEM). The adsorption capacities of the resin for Hg²⁺, Ag⁺, Cu²⁺, Zn²⁺, and Pb²⁺ at various pH values were determined. The maximum adsorption capacities for Hg²⁺ and Ag⁺ were 1.56 and 0.75 mmol g^?1 respectively. The resin had high selectivity for Hg²⁺ and Ag⁺ over the pH range 1.0–7.0. The adsorption capacities for Hg²⁺ and Ag⁺ under competitive condition were also determined by batch experiment method. In addition, the adsorption kinetics of the resin towards Hg²⁺ at different temperatures was also investigated. The results showed that the adsorption rate was governed by film diffusion at 20°C and 25°C, by particle diffusion at 30°C and 35°C. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 102: 6054–6059, 2006     

Hydrodynamic characteristics of a FCC regenerator

The hydrodynamic and gas mixing characteristics have been determined in a FCC regenerator (0.48 m I.D.x3.4 m high) with FCC particles. Solids holdup in the dense bed decreases with increasing gas velocity, but it increases in the freeboard region. The bubble/void fraction increases with an increase along the bed height at a given gas velocity and increases with increasing gas velocity at a constant bed height. Backmixed tracer gas at the wall region is higher than that at the center region of the bed. The gas backmixing coefficient decreases with increasing gas velocity.     

Soap‐free emulsion copolymerization of perfluoroalkyl acrylates in the presence of a reactive surfactant

Soap‐free emulsion copolymerization of perfluoroalkyl acrylate (FA)/methyl methacrylate (MMA)/n‐butyl acrylate (n‐BA) was carried out in the presence of sodium 2‐acrylamide‐2‐methyl propanesulfonate (AMPSNa) as a reactive surfactant and potassium persulfate (KPS) as an initiator. An analysis of the effects of concentration of AMPSNa, KPS, FA as well as polymerization temperature on the kinetic features (rate of polymerization) and colloidal characteristics (mean particle diameter, particle disperse index, particle numbers, and surface charge density) was followed. NMR, FTIR, AFM, and fluorine‐selective electrode analysis were used to characterize the composition and morphology of the FA copolymers. Both AFM analysis and contact angle measurements strongly implied that the fluorinated segments migrated to the outmost surface and created films with lower surface energy. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 104: 2438–2444, 2007     

新型聚丙烯接枝物的制备及应用

为制备强韧的共混材料,利用熔融接枝法研制了含有两种接技单体的新型聚丙烯接枝物,讨论了第二单体在接枝过程中的作用,并将其应用于尼龙6/聚丙烯(PA6/PP)共混体系,获得了使分散相粒径更细小、界面更模糊的增容效果。     

庙宇平坝防洪治理方案研究

庙宇平坝地处大溪河右岸支流庙宇沟上游山间盆地内,仅靠一条人工开凿的排洪洞和天然消坑排泄洪水,过流能力不足致使每年都遭受洪涝灾害。根据庙宇平坝地形条件及防洪现状,复核现有排洪设施泄流能力,分析存在的问题,结合庙宇平坝地形条件及区内实际情况,采取整个消水洞的扩建及进口前100 m的河道支护,从而提高泄洪能力,降低庙宇平坝水位,有效减少洪水淹没历时及淹没深度。     

Formation of Polymeric Lewis Acid–Lewis Base Complexes with Well-defined Organoboron Polymers

The binding of Lewis bases to organoboron polymeric Lewis acids has been studied and the parameters that determine the complexation equilibrium have been investigated, which include (i) the strength of the individual Lewis acids and Lewis bases, (ii) concentration, and (iii) temperature. While the strongly Lewis acidic borane polymers poly(4-bis(pentafluorophenyl)borylstyrene) (PS-BPf) and poly(4-(di-2-thienylboryl)styrene) (PS-BTh) form isolable complexes with strong Lewis bases such as 4-t-butylpyridine (^tPy), a temperature dependent equilibrium is established with weaker bases such as THF. Similarly, the weakly Lewis acidic boronate polymer poly(4-diethoxyborylstyrene) (PS-BOEt) undergoes a temperature dependent equilibrium with the strong Lewis base 4-dimethylaminopyridine (DMAP), while poly(4-pinacolatoborylstyrene) (PS-BPin) does not significantly bind to pyridine bases. Decomplexation of PS-BTh· ^t Py is achieved by treatment with the stronger Lewis acid, B(C₆F₅)₃, thereby confirming the reversible nature of the polymeric Lewis acid–base adducts. This paper is dedicated to Professor Ian Manners in gratitude of his guidance throughout the years and recognition of his scientific accomplishments