Solutions to a combined problem of excessive hydrogen sulfide in biogas and struvite scaling.

The Woodman Point Wastewater Treatment Plant (WWTP) in Western Australia has experienced two separate problems causing avoidable maintenance costs: the build-up of massive struvite (MgNH4PO4. 6H2O) scaling downstream of the anaerobic digester and the formation of hydrogen sulfide (H2S) levels in the digester gas to levels that compromised gas engine operation and caused high operating costs on the gas scrubber. As both problems hang together with a chemical imbalance in the anaerobic digester, we decided to investigate whether both problems could be (feasibly and economically) addressed by a common solution (such as dosing of iron solutions to precipitate both sulfide and phosphate), or by using separate approaches. Laboratory results showed that, the hydrogen sulfide emission in digesters could be effectively and economically controlled by the addition of iron dosing. Slightly higher than the theoretical value of 1.5 mol of FeCl3 was required to precipitate 1 mol of dissolved sulfide inside the digester. Due to the high concentration of PO4(3-) in the digested sludge liquor, significantly higher iron is required for struvite precipitation. Iron dosing did not appear an economic solution for struvite control via iron phosphate formation. By taking advantage of the natural tendency of struvite formation in the digester liquid, it is possible to reduce the risk of struvite precipitation in and around the sludge-dewatering centrifuge by increasing the pH to precipitate struvite out before passing through the centrifuge. However, as the Mg2+/PO4(3-) molar ratio in digested sludge was low, by increasing the pH alone (using NaOH) the precipitation of PO4(3-) was limited by the amount of cations (Ca2+ and Mg2+) available in the sludge. Although this would reduce struvite precipitation in the centrifuge, it could not significantly reduce PO4(3-) recycling back to the plant. For long-term operation, maximum PO4(3-) reduction should be the ultimate aim to minimise PO4(3-) accumulation in the plant. Magnesium hydroxide liquid (MHL) was found to be the most cost-effective chemical to achieve this goal. It enhanced struvite precipitation from both, digested sludge and centrate to the point where more than 95% PO4(3-) reduction in the digested sludge was achieved.     

Phosphorus‐containing polyaryloxydiphenylsilanes with high flame retardance arising from a phosphorus–silicon synergistic effect

Polyaryloxydiphenylsilanes were prepared from phosphorus‐containing diols and diphenydichlorolsilane through solution polymerization. With a stoichiometric imbalance in feed monomers, the resulting polymers exhibited moderate melting points and good processing properties. The polymers prepared showed initial decomposition temperatures above 340 °C, excellent thermal stability, high char yields at 850 °C and very high limited oxygen index values of 56–59. The polymers' char yields and their (P + Si) contents showed linear relationships. © 2003 Society of Chemical Industry     

Solid phase crystallization of amorphous silicon on glass by thin film heater for thin film transistor (TFT) application

A new process for solid phase crystallization (SPC) of amorphous silicon (a-Si) using thin film heater is reported. With this localized Ti silicide thin film heater, we successfully crystallized 500 Å-thick a-Si in a few minutes without any thermal deformation of glass substrate. The size of crystallized silicon grain was abnormally big (30-40 μm). Polycrystalline thin film transistors (TFT) fabricated using this unique thin film heater showed better mobility than those of conventional ones by furnace annealing.     

Inhibition effect of carbon dioxide on the oxidation of hydrogen over a platinum foil catalyst

This paper investigates the catalytic ignition of the H₂/O₂/CO₂ mixture on platinum in a stagnation flow at atmospheric pressure experimentally and numerically. We measure the ignition temperatures of the gas mixtures flowing towards resistively heated platinum with various composition ratios and various diluent gases of N₂, Ar and CO₂. Compared with N₂ or Ar, the CO₂ dilution shows higher ignition temperature by about 50 K, even at the same composition ratio. The ignition temperature increase is proportional to the dilution ratio. Through the numerical simulation, it is illustrated that higher ignition temperature is caused by the adsorption of CO₂ and following dissociation on platinum surface, which was to date considered negligible in catalytic combustion.     

A New Approach for Built‐in Self‐Test of 4.5 to 5.5 GHz Low‐Noise Amplifiers

This paper presents a low‐cost RF parameter estimation technique using a new RF built‐in self‐test (BIST) circuit and efficient DC measurement for 4.5 to 5.5 GHz low noise amplifiers (LNAs). The BIST circuit measures gain, noise figure, input impedance, and input return loss for an LNA. The BIST circuit is designed using 0.18 μm SiGe technology. The test technique utilizes input impedance matching and output DC voltage measurements. The technique is simple and inexpensive.     

General expression for pdf of a sum of independent exponential random variables

In order to evaluate exactly the performance of some diversity schemes, the probability density function (pdf) of a sum of independent exponential random variables (r.v.'s) must be known. This paper proposes a simple method to find it by using characteristic function., The resultant pdf is successfully applied to formulate the closed-form BER expression of 2 Tx-J Rx transmit diversity as well as the outage probability of repetition coding.     

Extended adaptive RBF equaliser for overcoming co-channelinterference

The authors investigate the problem of nonlinear adaptive equalisation in the presence of intersymbol interference, additive white Gaussian noise and co-channel interference. An extended radial basis function (RBF) network is proposed, in which regression weights are used in the output layer and the hidden unit is defined to have the Gaussian formula with the Mahalanobis distance. It is shown by simulation that the proposed structure gives reduced computational complexity without performance degradation, compared to that of the conventional RBF equaliser     

Fast locking delay-locked loop using initial delay measurement

A delay-locked loop (DLL) architecture capable of incorporating fast locking and low jitter features simultaneously is reported. A test chip was fabricated in a 0.6 μm CMOS process to prove its functionality. The proposed DLL can align the internal clock to the external reference clock within two cycles and maintain its locking state with the aid of feedback operation     

CMV colitis masquerading as colon cancer--an unusual presentation of acquired immunodeficiency syndrome

To determine whether there is any correlation between sudden decrease in barometric pressure and onset of labor, a non-experimental, retrospective study at a 948-bed tertiary care hospital was done. Pregnant patients of 36 weeks gestation or more who presented with spontaneous onset of labor during the 48 hours surrounding the 12 occurrences of significant drop in barometric pressure in 1992 were included in the study. Significantly more occurrences of onset of labor were identified in the 24 hours after a drop in barometric pressure than were identified in the 24 hours prior to the drop in barometric pressure (P < 0.05). Therefore, the overall number of labor onsets increased in the 24 hours following a significant drop in barometric pressure.     

Large-scale simulation studies in image pattern recognition

Many obstacles to progress in image pattern recognition result from the fact that per-class distributions are often too irregular to be well-approximated by simple analytical functions. Simulation studies offer one way to circumvent these obstacles. We present three closely related studies of machine-printed character recognition that rely on synthetic data generated pseudo-randomly in accordance with an explicit stochastic model of document image degradations. The unusually large scale of experiments - involving several million samples that makes this methodology possible have allowed us to compute sharp estimates of the intrinsic difficulty (Bayes risk) of concrete image recognition problems, as well as the asymptotic accuracy and domain of competency of classifiers