A new lateral MOS-gated thyristor with controlling base-current

A new lateral MOS-gated thyristor, called the Base-Current-Controlled Thyristor, is described. This device is designed so that most holes at the on-stage reach the P base through the floating P⁺ region adjacent to the P base and the on-state MOSFET. At the turn-off stage, the interruption of the hole current to the P base due to switching off the above MOSFET occurs simultaneously with the conventional turn-off operation. The concept of this device is verified experimentally by using the fabricated lateral device with the external MOSFET. This device exhibits a better trade-off relation between the on-state voltage and the turn-off time compared uith the conventional MOS-gated thyristor     

Series equivalence/operation of current-controlled boost-typesingle-phase voltage source converters for bidirectional power flow

Single-phase voltage source power converters (VSCs) under consideration are AC-DC current-controlled boost-type power converters with bidirectional power-handling capability. Equivalence between two series-connected two-level power converters and a single three-level power converter is considered here. Further considered is the series operation of three-level power converters. Simulation results and experimental verification for both are provided. Economical configurations of three-level power converters leading to multilevel waveforms are presented thereafter     

A wafer level monitoring method for plasma-charging damage usingantenna PMOSFET test structure

A novel monitoring method for plasma-charging damage is proposed. This method performs a quick and accurate evaluation using antenna PMOSFET. It was found that not only hot-carrier (HC) lifetime but transistor parameters such as initial gate current and substrate current were changed according to the degree of plasma-charging damage. However, the present work suggests that monitoring the shift of drain current after a few seconds of HC stress is a more accurate method to indicate plasma-charging damage. The monitoring method using the present test structure is demonstrated to be useful for realizing highly reliable devices     

Reduction of sodium-accelerated oxidation of silicon nitride ceramics by aluminium implantation

Norton NBD 200 silicon nitride ceramics were implanted with sodium to a dose of 7.0×10¹⁵cm^-2 at 72 keV (1 at% peak sodium content at 100 nm). The sodium-implanted samples were further implanted with aluminium to 7.3×10¹⁵cm^-2 at 87 keV (1 at% peak aluminium content at 100 nm). The implanted and unimplanted samples were oxidized in 1 atm dry oxygen at 1100 and 1300°C for 2–6 h. Profilometry and scanning electron microscopy measurements indicated that sodium implantation led to up to a two-fold increase in the oxidation rate of silicon nitride. The sodium effect was effectively neutralized when aluminium was co-implanted. The opposite effects of sodium and aluminium on the oxidation resistance of silicon nitride can be attributed to their different roles in modifying the structure and properties of the oxide formed. This revised version was published online in November 2006 with corrections to the Cover Date.     

Water sorption of glycol-modified cross-linked gelatin-based hydrogels

The water sorption behaviour of several cross-linked gelatin-based systems were investigated and compared. The systems were gelatin, gelatin/ethyleneglycol, gelatin/polyoxypropylenediamine, and gelatin/polyethylene oxide. For all the systems, an increased water gain was obtained by raising the concentration of the second component, while the swelling was reduced by an increase of the cross-linking density. This revised version was published online in November 2006 with corrections to the Cover Date.     

`Minting' electronic cash

Electronic equivalents of traditional cash payment systems are being launched worldwide. Electronic cash can combine the benefits of traditional cash with those of payment by debit and credit card, while circumventing both their shortcomings. As with traditional cash, electronic cash should have high acceptability and be suitable for low value payment from person to person. With the possible exception of online payment platforms such as the Internet, it is preferred that payments be verifiable offline, without the bank's involvement, for reasons of cost effectiveness and speed. To facilitate electronic cash payments over the phone and the Internet, physical proximity of payer and payee should not be necessary. Moreover, electronic cash should offer privacy of payments. In particular, payments by an honest payer should be untraceable, and information about transaction content should remain privy to payer and payee. Yet a payer ought to always be able to trace the payee; traceability suits electronic cash and is as open to extortion, money laundering, and bribery as a check or wire transfer. Lastly, as with payments by debit and credit card, electronic cash should be convenient to store and transport, while protecting users against loss, theft, and accidental destruction     

Wavelength selection for low-saturation pulse oximetry

Conventional pulse oximeters are accurate at high oxygen saturation under a variety of physiological conditions but show worsening accuracy at lower saturation (below 70%). Numerical modeling suggests that sensors fabricated with 735 and 890 nm emitters should read more accurately at low saturation under a variety of conditions than sensors made with conventionally used 660 and 900 nm band emitters. Recent animal testing confirms this expectation. It is postulated that the most repeatable and stable accuracy of the pulse oximeter occurs when the fractional change in photon path lengths due to perturbations in the tissue (relative to the conditions present during system calibration) is equivalent at the two wavelengths. Additionally, the penetration depth (and/or breadth) of the probing light needs to be well matched at the two wavelengths in order to minimize the effects of tissue heterogeneity. At high saturation these conditions are optimally met with 660 and 900 nm band emitters, while at low saturation 735 and 890 nm provide better performance     

Thick-layer glycerin-containing bichromated gelatin for recording volume holograms

A thick-layer light-sensitive material consisting of glycerin-containing bichromated gelatin has been prepared and used to record real-time volume holograms with 0.44 μm helium-cadmium laser radiation. The thickness of the layers is 400–600 μm. The holographic sensitivity of the material is 1 J/cm². The highest diffraction efficiency of holograms recorded using a symmetric system with parallel beams is 32%. Pis’ma Zh. Tekh. Fiz. 23, 62–65 (April 12, 1997)     

Perineurioma: an unusual cause of an external auditory canal polyp

BACKGROUND: Home parenteral nutrition (HPN) is used to treat intestinal failure. A minority of HPN patients are dependent on opiates and benzodiazepines to control pain and anxiety. The aim of this study was to determine what effects such drug dependence had on patient outcomes. METHODS: Ten dependent patients were prospectively compared with 10 well-matched, nondependent HPN patients for the same 12-month period. Episodes of line sepsis and other complications were documented and the cost of treatment estimated. Health status was measured using the SF36 and EuroQol instruments. RESULTS: The dependent group had significantly more episodes of central line sepsis (p = .0007) as well as other complications (p = .0002). This led to significantly longer periods of inpatient care (p = .0004) and therefore higher costs of treatment. Health status was lower in the dependent group; they reported more pain (p = .04) and less energy (p = .04). CONCLUSIONS: The complication rate and increased cost of treatment for opiate- and sedative-dependent patients receiving HPN significantly detract from the overall outcome of this therapy.