Decomposition of Mullite by Silica Volatilization

Thermal decomposition of mullite into corundum was investigated using a high-temperature X-ray single-crystal camera equipped with a gas-flame furnace and by scanning electron microscopy and electron probe microanalysis (EPMA). When heated to ∼1750°C, mullite decomposed to corundum by the liberation of the SiO₂ component with topotaxial relations of:

• (1) 

  (310)_mull∥(001)_cor; [001]_mull∥[110]_cor
• (2) 

  (130)_mull∥(001)_cor; [001]_mull∥[110]_cor
• (3) 

  (110)_mull∥(001)_cor; [001]_mull∥[110]_cor

Thus, it was considered that, when mullite decomposed into corundum, their oxygen close-packed planes were almost preserved. The SEM photographs showed that the crystals of the developed corundum are prismatic and ∼5 μm wide. The EPMA showed that the phase boundary between mullite and developed corundum is discontinuous.     

双束（H+/e-）辐照下氢对12Cr-ODS铁素体钢组织损伤影响研究

利用氢离子（H⁺）束和电子（e^-）束双束（H⁺/e^-）同时辐照用化学浸润法制备的新型12Cr-ODS铁素体钢,研究其辐照损伤效应及组织变化。实验结果表明：由于氧化物的钉扎,基体内保持低密度位错网络;辐照初期随辐照剂量的增加,缺陷团在位错线上及其周围形成,尺寸增加,密度不断增大,并形成间隙型位错环;不同温度下辐照均产生小尺寸高密度的空洞,随辐照剂量的增大,空洞长大速度降低,空洞密度缓慢减小;不同温度下,辐照剂量达15dpa时,空洞肿胀均小于0.15%。对辐照产生的点缺陷与氢相互作用进行理论分析,12Cr-ODS铁素体钢在623~823K经双束辐照后,表现出良好的抗辐照损伤性。     

Iron Loss Analysis of Permanent Magnet Motors Fed by PWM Inverter

Carrier harmonic losses that consist of iron loss, eddy current loss, and ac copper loss are produced in a permanent magnet machine driven by a PWM inverter. It is already known that a higher motor inductance can lead to lower carrier harmonic losses. This paper investigates the carrier harmonic loss composition of two motors with identical dimensions but different inductances. The results of finite element analysis (FEA) showed that the eddy current loss in the iron core accounts for most of the carrier harmonic loss. It is also shown that the carrier harmonic loss of the iron core is quantifiable using theoretical calculations.     

The Influence Analysis that a Phase Characteristic of the High‐Level Earthquake Gives to Vibration Response Characteristic of the 550‐kV Disconnectors

We developed the 550‐kV disconnectors that strengthened earthquake proofing by the addition of the damper unit and weight reduction of conductive part based on the damage of the 550‐kV disconnectors by the Great East Japan earthquake (March 11, 2011) and inspected the earthquake proofing performance by shake table test. In shake table test, we performed the test by the artificial seismic wave that varied in phase characteristic in addition to the test by resonance method. And, in a high‐level earthquake area, we analyzed it about the influence that a phase characteristic of the artificial seismic wave gave to stress to occur in disconnectors. As a result, it is thought that the stress to occur in disconnectors is decided by a primary natural frequency basically because a bending strain to occur to the disconnectors in the time when the resonance frequency ingredient becomes the big acceleration response value grows big. But, on a particular phase condition, it was confirmed that the bending strain to occur in disconnectors might grow big conspicuously. As for this, the possibility is thought about by influence of higher natural frequency doing superposition.     

Development of –1 MV DC Filter and High‐Voltage DC Measurement Systems for ITER NBI

This paper presents the development results of a ?1 MV dc filter and dc measurement systems for an ITER (International Thermonuclear Experimental Reactor) neutral beam injector (NBI) system. High accuracy of 0.5% and fast responsivity of 3.3 μs, ?3 dB are required for the dc measurement systems: both dc voltage dividers and DCCTs. Circuit design and thermal flow design were carried out to clarify and minimize their effects on the accuracy and responsivity. The validity of the established design was demonstrated by the actual‐product tests; temperature rise of each components fell below the allowable value; inner components of dc filter withstood dc ?1.2 MV; each voltage divider accurately measured the voltage during the dc ?1.2 MV withstand voltage test; the voltage dividers and the DCCTs were adequate to the requirements of responsivity (3.3 μs, ?3 dB).     

Investigation of Water Tree Degradation in Dry‐Cured and Extruded Three‐Layer (E‐E Type) 6.6‐kV Removed XLPE Cables

Dry‐cured and extruded three‐layer (E‐E type) 6.6‐kV cross‐linked polyethylene (XLPE) cables were introduced into electric power systems more than 30 years ago, but they do not experience failures because of water tree degradation. Also, the degradation index of water treeing for these cables has not been established. Therefore, investigating results of residual breakdown voltage and water tree degradation of these cables will help us plan for cable replacement and determine water tree degradation diagnosis scheduling, and will be fundamental data for cable lifetime evaluation. In this study, the authors measured the ac breakdown voltages of dry‐cured and E‐E type 6.6‐kV XLPE cables removed after 18 to 25 years of operation and observed the water trees in their XLPE insulation. As a result, it was observed that breakdown voltages were larger than the maximum operating voltage (6.9 kV) and the ac voltage for the dielectric withstanding test (10.3 kV). Water trees were mainly bow‐tie water trees and their maximum length was approximately 1 mm. Although the number of measured cables was limited, the lifetime of this type of cable was estimated to be approximately 40 years, even experiencing water immersion.     

Water quality characteristics of rivers and ponds in Japan

In Japan, various countermeasures have been taken to improve the water quality of public waters such as rivers and lakes. Though water quality has improved, it is still insufficient. In summer, eutrophication is seen in lakes and inner bays, as well as rivers. As a countermeasure to prevent eutrophication, the removal treatment of nutrient salts such as nitrogen and phosphorus is done, in addition to organic substance elimination in the domestic sewerage system. This report will show the water quality characteristics of rivers and ponds in Japan It is considered that these investigative results are effective when the water quality improvement of the stabilization ponds where eutrophication occurs are examined in China.     

Water quality and growth of phytoplankton for the Yellow River estuary reservoirs—The nutrients release from reservoir sediments

Effects of nutrients released from sediments on eutrophication in lakes and reservoirs were not well known in China. In the test, the release conditions of nitrogen and phosphorus from the sediments were observed by batch experiment. The test results revealed that the content released is correlated to the initial content of organic matter in sediments. In the Gengjing area, when the water quality of waterway, grit chamber and reservoir were compared, the water quality of the waterway was the highest, and lowered in the order of the grit chamber and the reservoir. The grit chamber could get not only fine sand removal but also the organic substance, nitrogen, phosphorus and phytoplankton, therefore it is important to operate and maintain the grit chamber to preserve the water quality of the reservoir. Due to little organic substance in sediments, ammonium nitrogen and phosphorus weren’t released during the incubation. But from the absorptiometric turbidity unit (ATU) test results, although the release of ammonium concentration was very low, ammonium oxidizing and nitrite oxidizing bacteria existed in sediments.     

污水处理排放水对小流量河流水体生态的影响

针对日本国鬼怒河流域小流量河流,通过对河床上附着生物膜的组成、底栖生物、细菌活性分析和AGP试验,研究了污水厂二级处理排放水对小流量河流生态的影响.研究表明,当污水厂二级处理排放水占河流流量比例较大时(研究河流所占比例为35%),同样会引发河流富营养化和影响河流水体的生态.因此,从保护水环境及其生态考虑,有必要对污水进行深度处理.