Quality Evaluation of Groundwater Resources using Geostatistical Methods (Case Study: Central Lorestan Plain,Iran)

In this research, based on the qualitative data of 40 wells, variations of water quality parameters of the Central Plain Aquifer were evaluated using kriging and IDW (Inverse Distance Weighting) methods. Owing to the normal distribution of the studied parameters (except Na⁺, SO₄^2?, and TH: total hardness), ordinary kriging was used for modeling. The analysis of the data trends indicated that all the variables were influenced by in two general trends, i.e., NW–SE and NE–SW. In fact, these trends were a result of the effect of the structural conditions on aquifer properties such as transmissivity and flow direction. Variogram analysis (based on C₀ near zero and C₀/σ² ratio between 0.0–0.5) showed that the Na⁺, TDS (total dissolved solids), Ca²⁺, and TH variables have a good spatial structure and the BOD (biochemical oxygen demand), COD (chemical oxygen demand), NO₃^?, and EC variables have poor spatial structure. The BOD, COD, NO₃^?, and EC (electrical conductivity) variables have the smallest range and isotropic distribution. On the other hand, the Ca²⁺, Mg²⁺, Na⁺, SO₄^2?, Cl^?, HCO₃^?, pH, TDS, TH and Alk (alkalinity) parameters are characterized by anisotropic distributions. The Na⁺, TDS, Ca²⁺, and TH variables have the largest range. The results showed that both the IDW and kriging methods have close estimates to one another. The pH variable decreases toward the outlet whereas the EC and TDS variables increase along the direction of water flow and toward the outlet. The distributions of the BOD and COD variables do not perfectly match with the aggregation of industrial activities in the central part as well as the agricultural activities in the southeastern and central parts of the aquifer. The distributions of the Ca²⁺, Mg²⁺, and Alk variables completely follow the geology condition and regional spread of carbonate formations. The Na⁺ concentration increases from the center toward the outlet. The concentration of the Cl^? variable is the highest in the central part of the plain due to the concentration of agricultural and industrial activities. The distribution of the SO₄^2? variable is influenced by a natural factor (lithology), especially in the southeastern parts and the outlet as well as artificial factors (agricultural and industrial activities) in the central and southeastern parts of the aquifer. The NO₃^? variable, which is directly influenced by agricultural and livestock-farming activities, has its maximum concentration in the southeastern areas.     

Application of Semiochemicals to Assess the Biodiversity of Subcortical Insects following an Ecosystem Disturbance in a Sub-boreal Forest

From 2000 through 2003 we used semiochemical-baited traps in northeastern Minnesota, USA, to assess changes in assemblages of subcortical forest insects after a catastrophic wind storm in 1999 and subsequent (1999–2000) fuel-reduction activities (salvage-logging and prescribed-burning). We determined the regional efficacy of fifteen semiochemical blends (pheromones and kairomones) as attractants for target and non-target subcortical insect species (Coleoptera: Anthribidae, Buprestidae, Cerambycidae, Cleridae, Cucujidae, Curculionidae, Histeridae, Nemonychidae, Salpingidae, Scolytidae, Tenebrionidae, and Hymenoptera: Siricidae). During the four summers, we trapped 86,471 subcortical insects (143 species) in baited and unbaited Lindgren funnel traps, and 500 beetles (44 species) in baited and unbaited pitfall traps. We report 23 new state collection records of subcortical insects from Minnesota. Trap catches of subcortical insects were greatest in the wind-disturbed areas 2 years after the event, and declined thereafter. Similar trends were observed for subcortical insects in the burned areas. Both wind-disturbance and burning increased the subcortical insect species richness and diversity on the landscape. The subcortical insect species compositions of the salvaged and burned forest areas differed from those of the undisturbed and wind-disturbed areas. Trap catches of subcortical insects in response to semiochemical treatments also varied with year of sampling and land-area treatment. The greatest diversity of subcortical beetle species was in traps baited with attractants for the scolytids, Dendroctonus valens [(+)-α-pinene and (−)-β-pinene] and Dryocoetes spp. [exo-brevicomin and (−)-α-pinene], perhaps reflecting the generic nature of the baits. The most distinct species compositions were collected in response to the woodborer and Dendroctonus simplex baits, whereas the species compositions in traps with the D. valens and Dryocoetes spp. baits, and the unbaited funnel trap were the most similar. The variation in trap catch with time and across landscapes suggests that the responses of subcortical insects to semiochemicals are more complex than previously appreciated.     

Managing People to Promote Innovation

There is growing evidence available to suggest that Human Resource Management (HRM) practice is an important predictor of organizational performance. Drawing upon organizational learning perspectives, we argue that HRM systems also have the potential to promote organizational innovation. We present longitudinal data from thirty‐five UK manufacturing organizations to suggest that effective HRM systems – incorporating sophisticated approaches to recruitment and selection, induction, appraisal and training – predict organizational innovation in products and production technology. We further show that organizational innovation is enhanced where there is a supportive learning climate, and inhibited (for innovation in production processes) where there is a link between appraisal and remuneration.     

Kinetics of human erythrocyte acetylcholinesterase inhibition by a novel derivative of physostigmine: phenserine

The elastic properties of carotid arteries of spontaneously hypertensive rats (SHR) and normotensive controls (Wistar-Kyoto rats [WKY]) were examined in vivo, in situ, and in vitro. The changes of internal diameter were measured with a high-resolution A-mode echo-tracking device simultaneously with the intra-arterial pressure at the carotid. The internal diameter at mean arterial blood pressure (MBP) was substantially smaller in vitro than in vivo in SHR (-33.8%) and WKY (-48.3%). The arterial distensibility was lower in vitro in all arteries compared with in vivo conditions (SHR, -30.1%; WKY, -60.4%; at MBP) despite a reduced incremental elastic modulus in vitro (SHR, -56.9%; WKY, -45.1%; at MBP). However, the in vitro and in vivo measurements show consistent elastic behavior of the carotid arteries between both strains of rats. Carotid arteries from WKY were also examined in situ. Although no significant reduction in internal diameter could be observed in situ, distensibility was dramatically decreased (-87% at MBP). These results emphasize the importance of considering the original vascular geometry when determining elastic properties of arteries. We conclude that experimental conditions are likely to be a critical determinant for the assessment of the mechanical properties of conduit vessels.     

A monoclonal antibody-based enzyme immunoassay for detecting parasite antigenaemia and antigenuria in Schistosomiasis mansoni

Both specific polycolonal antibody and monoclonal antibody against the microsomal antigen of adult S. mansoni were used to detect antigenaemia and antigenuria by antigen-capture sandwich ELISA in the sera and urine of patients infected with S. mansoni and other parasites. Antigenaemia was detected in 22 sera out of 100 of patients infected with S. mansoni but no antigenuria was detected. None of the sera of S. mansoni free patients were positive for microsomal antigen. More standardization of the technique and more refining of the reagents used is required to improve the sensitivity of the test.     

A Study of Users' Buffer Variations in Random Access Satellite Channels

A novel approach to modeling the slotted-ALOHA random access channel is presented. The objectives of the model are threefold: (1) to identify the channel's stability boundaries analytically as a function of the system's independent input parameters; (2) to investigate the impact of buffer-control on the channel's behavior; and (3) to facilitate the structuring of individual users' buffer-control as the focus of a dynamic control scheme. The significance of maintaining channel stability via buffer-control lies in its conceptual simplicity and implementability. Simulation runs of a finite-population model have clearly revealed the variation in individual users' buffer sizes and their sensitivity to the retransmission procedure.     

Formation of neutral molecules of potential stellar interest by neutralisation of negative ions in a mass spectrometer. The application of experiment and molecular modelling in concert

This paper is a modified version of a lecture which describes the synthesis, structure and reactivity of some neutral molecules of stellar significance. The neutrals are formed in the collision cell of a mass spectrometer following vertical Franck-Condon one electron oxidation of anions of known bond connectivity. Neutrals are characterised by conversion to positive ions and by extensive theoretical studies at the CCSD(T)/aug-cc-pVDZ//B3LYP/6-31G(d) level of theory. Four systems are considered in detail, viz (i) the formation of linear C(4) and its conversion to the rhombus C(4), (ii) linear C(5) and the atom scrambling of this system when energised, (iii) the stable cumulene oxide CCCCCO, and (iv) the elusive species O(2)C-CO. This paper is not intended to be a review of interstellar chemistry: examples are selected from our own work in this area.     

Evaluation of mechanical properties using spherical ball indentation and coupled finite element–element-free galerkin approach

In the present work, the mechanical properties of pressure tube material (Zr-Nb2.5) are evaluated using the coupled finite element–element-free Galerkin approach. Penalty approach is used to impose contact constraints and non-penetration condition at the interface. An efficient node-to-segment algorithm is employed to model the contact behavior. An updated Lagrangian approach is used to model the large deformation. Loading and unloading response of the indentation process is analyzed using von-Mises and Gurson-Tvergaard-Needleman (GTN) plasticity models. In multiple indentations, the indentation depth is progressively increased up to a maximum specified limit with partial unloading. Load-indentation depth curves are used to extract the flow properties of the material.     

Optimizing Concentration of Drag Reducing Polymer in Case of One- and Two-Phase Flow in 90° Copper Elbow

Journal of Failure Analysis and Prevention - The rate of diffusion-controlled corrosion of 90° Copper Elbow by acidified dichromate has been investigated in relation to the following...     

Scheduling with an outsourcing option on both manufacturer and subcontractors

This paper addresses a single-stage scheduling problem with outsourcing allowed where each job can be either scheduled for in-house production or outsourced to one of the outside subcontractors available. The manufacturer has an unrelated parallel machine system, and each subcontractor has its own single machine. Subcontractors are capable to process all the jobs. Unlike most of past research, our study considers the joint scheduling of both in-house and outsourced jobs simultaneously. The objective is to minimize sum of the total weighted completion time and total outsourcing cost. An integer programming formulation is presented and then improved through an optimality property on job orders. A heuristic algorithm is also introduced to decompose the problem into smaller and easier subproblems and solve them to optimality.