Enhancement of micro-grid performance during islanding mode using storage batteries and new fuzzy logic pitch angle controller

Power system deregulation, shortage of transmission capacities and needing to reduce green house gas have led to increase interesting in distributed generations (DGs) especially renewable sources. This study developed a complete model able to analysis and simulates in details the transient dynamic performance of the Micro-Grid (MG) during and subsequent islanding process. Wind speed fluctuations cause high fluctuations in output power of wind turbine which lead to fluctuations of frequency and voltages of the MG during the islanding mode. In this paper a new fuzzy logic pitch angle controller is proposed to smooth the output power of wind turbine to reduce MG frequency and voltage fluctuations during the islanding mode. The proposed fuzzy logic pitch controller is compared with the conventional PI pitch angle controller which usually used for wind turbine power control. Results proved the effectiveness of the proposed fuzzy controller in improvement of the MG performance. Also, this paper proposed using storage batteries technique to reduce the frequency deviation and fluctuations originated from wind power solar power fluctuations. Results indicate that the storage batteries technique is superior than fuzzy logic pitch controller in reducing frequency deviation, but with more expensive than the fuzzy controller. All models and controllers are built using Matlab® Simulink® environment.     

Nonlinear analysis of an elastic cable under harmonic excitation

The nonlinear behavior of an elastic cable subjected to harmonic excitation is studied and solved. The method of multiple scales perturbation is applied to analyze the response of the nonlinear system near the simultaneous principle primary and internal resonance. The stability of the proposed analytic nonlinear solution near the simultaneous primary-internal resonance is studied and the stability condition is investigated. The effect of different parameters on the steady state responses of the vibrating system is studied and discussed using frequency response equations. The numerical solutions and chaotic response of the nonlinear system of the elastic cable for different parameters are also studied.     

Computational fluid dynamics applied to high temperature hydrogen separation membranes

This work reviews the development of computational fluid dynamics (CFD) modeling for hydrogen separation, with a focus on high temperature membranes to address industrial requirements in terms of membrane systems as contactors, or in membrane reactor arrangements. CFD modeling of membranes attracts interesting challenges as the membrane provides a discontinuity of flow, and therefore cannot be solved by the Navier-Stokes equations. To address this problem, the concept of source has been introduced to understand gas flows on both sides or domains (feed and permeate) of the membrane. This is an important solution, as the gas flow and concentrations in the permeate domain are intrinsically affected by the gas flow and concentrations in the feed domain and vice-versa. In turn, the source term will depend on the membrane used, as different membrane materials comply with different transport mechanisms, in addition to varying gas selectivity and fluxes. This work also addresses concentration polarization, a common effect in membrane systems, though its significance is dependent upon the performance of the membrane coupled with the operating conditions. Finally, CFD modeling is shifting from simplified single gas simulation to industrial gas mixtures, when the mathematical treatment becomes more complex.     

Application of high‐resolution NVD differencing schemes to the FTn finite volume method for radiative heat transfer

In this work, the STEP scheme and several schemes based on the normalized variable diagram (NVD), such as MINMOD, GAMMA, CLAM, NOTABLE, MUSCL, CUBISTA, SMART, WACEB, and VANOS schemes, are evaluated for solving the radiative transfer equation. Two‐dimensional and three‐dimensional rectangular enclosures containing transparent, emitting–absorbing, emitting–absorbing–scattering, or nonhomogeneous participating media are investigated using the modified FTn finite volume method. Although the NVD schemes are much more accurate than the STEP scheme, but they have more time‐consuming and require more iterations. Moreover, most of them often necessitate underrelaxation to ensure convergence. Results show that the MINMOD and GAMMA schemes are still much less accurate than other NVD schemes, but they converge the fastest of the NVD schemes, and do not require underrelaxation. Although the VANOS, WACEB, and SMART schemes give more accurate solutions, they are not competitive with other NVD schemes. However, the CLAM, NOTABLE, and CUBISTA schemes are relatively fast and accurate.     

Evaluation of the FTn Finite Volume Method for Transient Radiative Transfer in Anisotropically Scattering Medium

In this paper, we formulated, applied, and tested the FTn Finite Volume Method (FTn FVM) for transient radiative transfer in three-dimensional absorbing, emitting, and anisotropically scattering medium. Both the STEP and the Curved-Line Advection Method (CLAM) are introduced for spatial discretization of the transient radiative transfer equation. The results show that FTn FVM reduces largely the ray effects and it is more accurate than the standard FVM. Also, using both STEP and CLAM schemes, FTn FVM has smaller convergence time than the standard FVM for all cases. On the contrary, the STEP scheme is faster than the CLAM scheme but it has less accuracy. Then, the effects of optical thickness, scattering albedo, and anisotropy factor on incident radiation and radiative flux are presented and discussed.     

Influence of Aging Treatment on In-Situ Electrical Resistance Variation During Aging of Nickel-Rich NiTi Shape Memory Wires

Electrical resistance variations of Ni_50.9Ti_49.1 shape memory wires were studied during aging treatment at different temperatures via in-situ electrical resistance measurement. The results showed that during aging treatment, a cyclic behavior was observed in the electrical resistance variations, which could be related to the precipitation process. The evaluation of transition temperatures was conducted, after aging, using differential scanning calorimetry (DSC) analysis. The precipitation process is found to occur in four different stages. The results show that depending on the stress level around precipitates, two-, three-, or four-step martensitic transformation could be observed in DSC curves. In the points with maximum stress level (during precipitation process), four-step martensitic transformation is observed.     

Theoretical Prediction With Numerical and Experimental Verification to Predict Crosswind Effects on the Performance of Cooling Towers

A simple theoretical model, validated against available numerical and experimental data in the literature, is presented to predict the effects of crosswind on the performance of natural draft dry cooling towers. The intersection of asymptote method, along with scale analysis, is used to find a closed-form solution for the airflow rate at the tower exit for given crosswind speeds. The total heat rejected under a windy condition is then calculated based on the air mass flow rate at the tower exit. This theoretical model allows for parametric studies and can generate accurate data. Interestingly, the model results, expected to be accurate within an order of magnitude, are more accurate than anticipated when compared to available experimental and numerical data in the literature. In fact, the maximum relative error is observed to be 15% when current theoretical predictions are compared to available experimental data. The results of this study will be useful for future work on the development of air-cooled condensers, especially for geothermal and solar thermal power plants in Australia.     

Enrichment of linear hexahedral finite elements using rotations of a virtual space fiber

The present paper deals with the enrichment of 3D low‐order finite elements. The used concept is based on the idea that a 3D virtual fiber, after a spatial rotation, introduces an enhancement of the strain field tensor approximation. A consistent stiffness matrix is obtained, allowing a better approximation of the actual solution compared with that resulting from low‐order finite elements. Implemented for two eight‐node hexahedral elements, the performance of the space fiber rotation concept is assessed by running some classical beam, plate, and shell benchmarks, and the obtained results are compared especially with those given by linear eight‐node and quadratic 20‐node hexahedral elements. In particular, it is shown that the developed elements accuracy is significantly superior to that of the classical eight‐node hexahedral element and close to that of the classical 20‐node hexahedral element. Copyright © 2013 John Wiley & Sons, Ltd.     

Physiological changes, phenolic content and antioxidant activity of Salvia officinalis L. grown under saline conditions

BACKGROUND: Hydroponic culture was used to investigate the effect of NaCl concentrations on the growth, nutrient uptake, phenolic content and antioxidant activity of Salvia officinalis L. leaves. The antioxidant capacity of the methanolic extract of S. officinalis was evaluated by using 2,2‐diphenyl‐1‐picrylhydrazyl (DPPH) radical scavenging test and β‐carotene‐linoleic acid bleaching assay. Physiological and biochemical parameters of S. officinalis were assessed after 4 weeks of salt treatment with 0, 25, 50, 75 and 100 mmol L^?1 NaCl. RESULTS: Plant growth exhibited a reduction of 61% at 100 mmol L^?1 NaCl. Assessment of Na⁺, K⁺ and Ca²⁺ and water contents of shoots and roots showed that S. officinalis is able to regulate Na⁺ concentration by active compartmentation in vacuoles. Salvia officinalis phenolics were increased in response to salinity at the threshold of 75 mmol L^?1 NaCl. This herb was also found to be able to achieve important DPPH^? quenching activity and to inhibit the β‐carotene‐linoleic acid bleaching notably enhanced by salt treatment. It is interesting to highlight the correlation between the phenolic and antioxidant activity, suggesting the involvement of these compounds in this activity. CONCLUSION: Salvia officinalis treated with 75 mmol L^?1 NaCl constitutes a potential source for production of secondary metabolites useful in several applications. Copyright © 2011 Society of Chemical Industry