Electron transport in InGaO3(ZnO)m (m=integer) studied using single-crystalline thin films and transparent MISFETs

We have investigated the characteristics of transparent metal-insulator-semiconductor field-effect transistors (MISFETs) fabricated using InGaO₃(ZnO)_m (m=integer) single-crystalline thin films as n-channel layers and amorphous alumina as gate insulator films. The MISFETs exhibit good characteristics such as insensitivity to visible light illumination, off-current as low as ∼1 nA with a positive threshold voltage of ∼3 V and on/off current ratio of 10⁵. The field-effect mobility increased from ∼1 to ∼10 cm² (V s)⁻¹ as the m-value increased. Room temperature Hall mobility also increased. However, unexpectedly these values were lower than the field-effect mobility. It is explained by existence of shallow localized state in the homologous compounds.     

Suppression of adjuvant arthritis in rats by oral administration of type II collagen in combination with type I interferon

Foliar application of cytozyme to 30-day-old black-gram plants resulted 48% increase of dry matter accumulation. The increase in fresh and dry weights of total plants was largely due to enhanced CO2 assimilation rates which were associated with increased RuBP carboxylase activities. The photochemical characteristics in the isolated chloroplasts exhibited an increase of 32, 28 and 40%, measured as the photoreduction of DCPIP, FeCN and NADP, respectively. Cytozyme treatment also resulted an increase in the chlorophyll content in leaves.     

An image analyzing system using an artificial neural network forevaluating the parenchymal echo pattern of cirrhotic liver and chronichepatitis

To objectively evaluate the parenchymal echo pattern of cirrhotic liver and chronic hepatitis, the authors applied an image analyzing system (IAS) using a neural network. Autopsy specimens in a water tank (n=13) were used to examine the relationship between the diameter of the regenerative nodule and the coarse score (CS) calculated by IAS. CS was significantly correlated with the diameter of the regenerative nodule (p<0.0001, r=0.966). CS is considered to be useful for evaluating the coarseness of the parenchymal echo pattern     

The principle and fundamental characteristics of brushless three-phase synchronous induction motor with two stators

Brushless three-phase synchronous motor involving a rotating ac exciter on the same shaft as the motor and with the windings linked through a shaft-mounted rectifier is widely used as medium and large capacity machines. However, the motor needs to fit with damping windings for self-starting outside of the field winding in the rotor and needs to equip discharge resistance with complex electronic device to dispose of electromagnetic force induced in the field winding at starting. Therefore, the rotor structure is very complex, and there are disadvantages, especially for the robust and highly reliable motor that is desired. To solve the problem found in traditional motors, the authors proposed a brushless three-phase synchronous induction motor with two stators and one wound rotor. This problem is solved because the proposed motor is of two-stators structure: the rotor winding operates as a secondary winding of induction motor at starting and as the field winding at synchronous operation. The motor can self-start as a wound-rotor induction motor without external secondary resistance. Therefore, discharge resistance is not necessary; the starting equipment is very simple and the rotor structure is robust. It is possible to start with high torque. In this paper, the basic constitution of the proposed motor and the principles of operation are described in detail. The experimental results at starting and pulling into synchronism are shown for confirming the principles of operation and the experimental and numerical results of the starting characteristics. The load ones and the generating ones are shown and then the practical use of the proposed motor is confirmed.     

Hydrogenation of CSC8 graphite intercalation compound by atomic hydrogen

A hydrogenated caesium-graphite intercalation compound, of which the Raman spectrum indicates its second-stage structure, is found to be formed by exposure of CsC₈ to atomic hydrogen generated on a hot tungsten filament.     

Strength and ductility under dynamic loading in fine- grained IN905XL aluminum alloy

Three IN905XL aluminum alloys with fine grain (1 μm), intermediate grain (3 μm), and coarse grain (5 μm) have been developed by a combination of mechanical alloying (MA) and conventional extrusion in order to investigate their mechanical properties at dynamic strain rates of 1 × 10³ and 2 × 10³ s⁻¹ and a quasi-static strain rate of 10^-3 s⁻¹. Flow stresses are found to increase with decreasing grain size for all the strain rates tested. Negative strain-rate sensitivity of flow stress is observed up to 1 × 10³ s⁻¹ in both intermediate- and coarse-grained IN905XL. At the highest strain rate of 2 × 10³ s⁻¹ however, all samples showed a positive strain-rate sensitivity of strength. Total elongation at high strain rates is generally larger than that at low strain rates. Total elongation also decreases with grain size for all the strain rates. This decrease in elongation results from an initiation of microcracks at interfaces between the matrix and particles finely dispersed near grain boundary regions, introduced during MA processing; then, this initiation leads elongation of alloys to small limited values. Formerly with the Department of Mechanical Systems Engineering, University of Osaka Prefecture. This article is based on a presentation made in the symposium “Dynamic Behavior of Materials,” presented at the 1994 Fall Meeting of TMS/ASM in Rosemont, Illinois, October 3-5, 1994, under the auspices of the TMS-SMD Mechanical Metallurgy Committee and the ASM-MSD Flow and Fracture Committee.     

Structure and dynamics of suspensions of silica particles in liquidcrystals under a low frequency AC applied voltage

Silica particles dispersed in liquid crystals exhibit a novel behavior such as a unique migrating behavior and alignment. These characteristics are found to depend on the size of the nanoparticles, the surface state of nanoparticles, the liquid crystal (LC) phases, the amplitude and the frequency of applied voltage. These are discussed in terms of anisotropic particle-particle and particle-LC molecules interactions in the anisotropic environment of liquid crystal matrix     

New method for measuring an optical property of a sample treated by FWA

In this article, a new method for measuring a total spectral radiance factor of a FWA‐treated sample illuminated by a specific standard illuminant is introduced. The method replaces an unstable real fluorescent standard by a bi‐spectral luminescent radiance factor data, which works as a virtual fluorescent standard (VFS) by knowing spectral intensity distributions of illuminations applied to the sample. The method utilizes two illuminations I₁ and I₂ whose relative spectral intensity distributions are different from each other and synthesizes a virtual illumination presenting the identical fluorescent spectral radiance factor to that presented by the standard illuminant with the VFS of the specific bi‐spectral luminescent radiance factor by linearly combining I₁ and I₂ with the suitable weighting factors. The applicability of the method is examined in principle by comparing ISO brightness and CIE whiteness index of fluorescent standard paper as a test sample obtained by this new method to the assigned values. © 2007 Wiley Periodicals, Inc. Col Res Appl, 32, 195–200, 2007     

Bias-stress-induced increase in parasitic resistance of InP-based InAlAs/InGaAs HEMTs

The reliability of InP-based HEMTs is studied, focussing on how it is affected by the doped layer material and gate recess structure. Bias-and-temperature stress tests reveal that fluorine-induced donor passivation in the recess region, formed adjacent to the gate electrode, causes the source resistance (R_s) to increase at large drain bias voltages. The increase in R_s can be prevented by using InP or InAlP as the carrier supply layer material instead of InAlAs. On the other hand, the increase in the drain resistance (R_d) does not depend on the material of the carrier supply layer, which suggests that a mechanism different from that in the case of R_s should be considered. It is also found that a deep gate recess suppresses the increase in R_d after long-term stressing.     

Surface characterization and catalytic properties of La1−x -Sr x CoO3

The surface chemical states of the perovskite-type compounds, strontium doped lanthanum cobalt oxides (La_1?x Sr _x CoO₃), have been investigated using X-ray photoelectron spectroscopy (XPS). Catalytic oxidations of both methane and CO have also been investigated using flow methods. The chemical composition of the surface of La_1?x Sr _x CoO₃ was very different from that in the bulk, which was measured by X-ray fluorescence spectroscopy (XRFS). The catalytic activity of La_1?x Sr _x CoO₃ increased with an increase in the quantity of cobalt atoms on the surface.