Effect of Deposition Rate on the Stress Evolution of Plasma-Sprayed Yttria-Stabilized Zirconia

The deposition rate plays an important role in determining the thickness, stress state, and physical properties of plasma-sprayed coatings. In this article, the effect of the deposition rate on the stress evolution during the deposition (named evolving stress) of yttria-stabilized zirconia coatings was systematically studied by varying the powder feed rate and the robot-scanning speed. The evolving stress during the deposition tends to increase with the increased deposition rate, and this tendency was less significant at a longer spray distance. In some cases, the powder feed rate had more significant influence on the evolving stress than the robot speed. This tendency can be associated with a deviation of a local deposition temperature at a place where sprayed particles are deposited from an average substrate temperature. At a further higher deposition rate, the evolving stress was relieved by introduction of macroscopic vertical cracks as well as horizontal branching cracks.     

Occurrence and sources of perfluorinated surfactants in rivers in Japan

We analyzed perfluorinated surfactants (PFSs) in 20 river samples and 5 wastewater secondary effluent samples in Japan to reveal their occurrence and sources. Nine PFS species were determined: perfluorooctanesulfonate (PFOS), perfluorooctane sulfonamide (FOSA), perfluoroheptanoate (PFHpA), perfluorooctanoate (PFOA), perfluorononanoate (PFNA), perfluorodecanoate (PFDA), perfluoroundecanoate (PFUA), perfluorododecanoate (PFDDA), and perfluorotridecanoate (PFTDA). PFSs were detected in all rivers, revealing nationwide contamination of rivers. In particular, 11 out of 20 river samples exceeded New Jersey guidance for PFOA in drinking water (40 ng/L). PFOS, PFHpA, PFOA, and PFNA were major species in Japan. Concentrations of PFOS, PFHpA, and PFNA in rivers were strongly correlated with population density, suggesting that the chemicals were derived from urban activities. PFOA showed a significant but weak correlation. We used crotamiton, a marker of sewage effluent, for further source analysis. Concentrations of PFOS, PFHpA, and PFNAwere strongly correlated with those of crotamiton, and plots of secondary effluents fell near the regression lines of rivers, indicating that the PFOS, PFHpA, and PFNA in rivers were derived from sewage effluent. On the other hand, PFOA was found at remarkably high levels (54-192 ng/L) in seven river samples containing low levels of crotamiton, suggesting that it was derived from nonsewage point sources, as well as sewage effluent. The total fluxes of sewage-derived PFOS, PFHpA, PFOA, and PFNA from Japan were estimated to be 3.6, 2.6, 5.6, and 2.6 t/year, respectively. This is the first report to identify PFOA in several rivers, derived from nonsewage point sources, by using a marker of sewage effluent.     

A three-dimensional soil–water coupled FE analysis of hollow cylinder test concerning non-uniform deformation

The hollow cylinder shear test is somewhat controversial due to its non-uniform stresses and strains, and has been analyzed by simple theoretical methods and two-dimensional FE calculations. In this paper, the hollow cylinder test under strain control was carried out numerically by treating the specimen as a three-dimensional initial-boundary value problem considering the inertial forces. At first, besides the known nonuniform strain, the non-uniformities of excess pore water pressure and overconsolidation ratio have been shown to benefit from a soil–water coupled analysis that employs the SYS Cam-clay model. Then, the influence of the specimen geometries, including wall thicknesses, heights and outer diameters on the non-uniformity was investigated sequentially. A new method for evaluating non-uniformity was proposed, which is suitable for the three-dimensional analysis. The response under a uniform deformation field, which is indicated by “the perfect path”, was presented to draw a comparison with the apparent behaviors, with non-uniformities taken into consideration. It should be noted that there is a critical height to prevent failure at the specimen ends according to the apparent behavior. Finally, the torque-controlled experiment indicated that 4 ribs could not transfer the torque reliably while 6 or 8 ribs were feasible.     

Synthesis of optical quality ZnO nanowires utilizing ultrasonic spray pyrolysis

ZnO nanowires were grown by an ultrasonic spray pyrolysis technique. The aspect ratio and size of the wire were dependent mainly on the pH value of a precursor solution and the growth temperature. By high-resolution transmission electron microscopic analysis and photoluminescence measurements, it was confirmed that the nanowires are monocrystalline with good optical quality.     

Processing effects on in-flight particle state and functional coating properties of plasma-sprayed manganese zinc ferrite

Magnetic properties of manganese zinc ferrite (MZF) coatings deposited by atmospheric dc plasma spraying largely depend on zinc and oxygen loss during particle flight. The temperature and velocity of in-flight MZF particles were widely varied by changing plasma spray conditions to examine these chemistry changes and resultant magnetic properties. Zn loss increases with increased particle temperature or decreased particle velocity. Meanwhile, wüstite (FeO) formation, related to the oxygen loss, is more complicated, partly because oxygen, which is lost during flight in the high-temperature zone of the plasma jet, can be recovered at longer spray distances. As a result, the saturation magnetization of MZF coatings decreases and the coercivity increases with increased particle temperature or decreased particle velocity.     

Preliminary spectrum shifter design for intermediate energy nuclear data benchmark experiments with DT neutrons

Integral benchmark experiments with DT neutrons are not always sufficient for nuclear data benchmarking in the MeV region, below 10 MeV. A neutron spectrum shifter, which will be placed between a sample and a DT neutron source, is effective to moderate DT neutrons incident to the sample. In order to estimate effects of the spectrum shifter, the ratio of the contribution of 14 MeV neutrons in the leakage neutron and gamma-ray spectra was calculated with MCNP-4C for an experimental configuration at FNS of JAEA, Japan. The calculations were carried out for a Li₂TiO₃ sample with a Be, D₂O, or ⁷LiD spectrum shifter. It was found out that the Be shifter was superior to others and the Be shifter was effective to decrease the contribution of 14 MeV neutrons especially for secondary gamma-ray spectrum measurements.     

Self-flux synthesis and photoluminescent properties of LiAl5O8

Pure-phase LiAl₅O₈ was selected as an oxide ceramic red phosphor material without dopants (color centers) and was synthesized using a self-flux method. The LiAl₅O₈ was formed by heating a powder mixture consisting of γ-Al₂O₃:Li₂SO₄ = 1:2 (molar ratio) at over 1100 °C for 1 h. Photoluminescence (PL) properties for the synthesized LiAl₅O₈ were investigated. The maximum intensity of the excitation spectrum for the photoluminescent emission of LiAl₅O₈ synthesized was at 274 nm. The peak intensity of the emission spectrum was at a wavelength of 667 nm (red color). The intensity of the peak emission spectrum increased with the heating temperature, i.e., the maximum peak intensity of the red emission spectrum was detected for the LiAl₅O₈ synthesized by heating at 1500 °C for 1 h.     

Detection of relative and uniform motion

We measured the lowest velocity (velocity threshold) for discriminating motion direction in relative and uniform motion stimuli, varying the contrast and the spatial frequency of the stimulus gratings. The results showed significant differences in the effects of contrast and spatial frequency on the threshold, as well as on the absolute threshold level between the two motion conditions, except when the contrast was 1% or lower. Little effect of spatial frequency was found for uniform motion, whereas a bandpass property with a peak at approximately 5 cycles per degree was found for relative motion. It was also found that contrast had little effect on uniform motion, whereas the threshold decreased with increases in contrast up to 85% for relative motion. These differences cannot be attributed to possible differences in eye movements between the relative and the uniform motion conditions, because the spatial-frequency characteristics differed in the two conditions even when the presentation duration was short enough to prevent eye movements. The differences also cannot be attributed to detecting positional changes, because the velocity threshold was not determined by the total distance of the stimulus movements. These results suggest that there are two different motion pathways: one that specializes in relative motion and one that specializes in uniform or global motion. A simulation showed that the difference in the response functions of the two possible pathways accounts for the differences in the spatial-frequency and contrast dependency of the velocity threshold.     

Histidine 210 mutant of a trypsin-type Achromobacter protease I shows broad optimum pH range

Achromobacter protease I (API), a lysine-specific serine protease, shows one order of magnitude higher activity than bovine trypsin, while its optimum pH is in the alkaline region at about pH 9. To improve the optimum pH range, mutant enzyme His 210 replaced by Ser(H210S), Ala (H210A), and Lys (H210K) were constructed. The optimum pH of H210S shifted from about pH 9 (wild-type enzyme) to about pH 7, retaining its high activity. The putative electrostatic interaction between His 210 and catalytic Asp 113 was elucidated by the optimum-pH shift of H210K and H210A. These results indicate that this unconserved His 210 in API, which plays a key role in generating the useful peptidase, broadened the optimum-pH range without decreasing lysylendo-peptidase activity.