Lattice Constants and Compositions of Manganese-Bearing Ferrites

When manganese-bearing ferrites (Mn _x Fe_{3- x} O_4-delta, with x = 0.17-1.09) were prepared in the present study via a solid-state reaction, manganese ions were incorporated into the lattice sites of the ferrites in the divalent state. The lattice constant ( a ₀) of those ferrites increased linearly as the manganese composition x increased. A ferrite with x = 1.28 contained manganese ions with a valence state higher than 3+; however, no further increase in a ₀ occurred at valences higher than 2+.     

Insights from ab initio molecular dynamics simulations for a multicomponent oxide glass

It remains a challenge to establish structural models of multicomponent oxide glass systems. In this study, we have investigated 68.3SiO₂–16.1B₂O₃–4.2Al₂O₃–11.4Na₂O glass and melt structures by ab initio molecular dynamics (AIMD) simulations. The atomic configurations obtained from AIMD simulations were validated against ¹⁷O solid‐state NMR spectrum under 24.0 T and neutron diffraction data, and excellent agreement was achieved. The bond lengths, angles, and coordination geometries were statistically analyzed for each atomic species. Here we particularly address the role of minor atomic species such as five‐coordinate Si (Si^V) and Al (Al^V). The Si^V–O bond lengths and O–Si^V–O angle distribution in the glass indicated 1.718 Å and three peaks at 90°, 120°, and 175°, which are assigned to a coordination geometry of the trigonal bipyramidal structure. Ring statistic analysis revealed that Si^V and Al^V were found to preferentially contribute to the formation of small ring sizes.     

Comparison of enteral nutrition with combined enteral and parenteral nutrition in post-pancreaticoduodenectomy patients: a pilot study

Background  

Many clinical studies have demonstrated that early postoperative enteral nutrition (EN) improved the postroperative course. Post-pancreaticoduodenectomy (PD), patients tend to suffer from postoperative nausea, abdominal distention, and diarrhoea, causing difficulty in the introduction of EN. In this pilot study, we investigated the appropriate nutritional mode post-pancreatic surgery.     

Albumin stabilizes (–)‐epigallocatechin gallate in human serum: Binding capacity and antioxidant property

(–)‐Epigallocatechin gallate (EGCg) is the major component of green tea and is known to show strong biological activity, although it can be easily oxidized under physiological conditions. In this study, we indicate that EGCg is stable in human serum and that human serum albumin (HSA) stabilizes EGCg under aerobic condition. Although EGCg is usually decomposed within 1 h in aqueous solution at neutral pH, EGCg in serum and phosphate buffer (pH 7.4) containing HSA was stable over 1 h, even at neutral and slightly alkaline pH. Under these conditions, EGCg binds to HSA non‐covalently. The sulfhydryl group acts as an antioxidant for EGCg oxidation. Incubation of EGCg with HSA is accompanied by the oxidation of a free sulfhydryl group in HSA. These results suggest that the antioxidant property and the binding capacity of HSA contribute to the stabilization of EGCg in human serum.     

Discussion on the equivalent conductivity and resistance of stress corrosion cracks in eddy current simulations

This study evaluates the numerical modeling of stress corrosion cracks from the viewpoint of eddy current simulations. Five stress corrosion cracks are artificially introduced into austenitic stainless steel plates measuring 25 mm in thickness, and then eddy current inspections are conducted to gather eddy current signals and destructive tests performed to confirm the true profiles of the cracks. The cracks are carefully introduced so as not to cluster, and the data obtained enables discussion of the modeling of a single crack quantitatively. Subsequent numerical simulations model each crack as a rectangular region with a fixed width and uniform conductivity, and evaluate the equivalent width and conductivity suitable for modeling the crack. The evaluation reveals that it is not reasonable to correlate the size of a crack and only its width or conductivity, and larger cracks tend to have greater resistance, which is defined as the width divided by conductivity. Furthermore, the values of width and conductivity depend also on the exciting frequency and probe used; however, the resistance remains almost unchanged by the experimental condition.     

Swelling behaviour of rubber vulcanizates: 2. Effects of tensile strain on swelling

The effects of tensile strain on the swelling behaviour of acrylonitrile-butadiene copolymer rubber vulcanizates were studied by real-time pulsed nuclear magnetic resonance (n.m.r.) measurements and volume swelling measurements at equilibrium. It was shown that tensile strain causes an increase of the initial swelling rate evaluated by n.m.r. measurements and of the swelling ratio of the rubber matrix at equilibrium. This behaviour was discussed qualitatively in terms of the molecular mobility of the network chains on the basis of Treloar's theory for swelling under deformation. It was suggested that the presence of reinforcing fillers in the rubber matrix exerts two noticeable effects on swelling under deformation: (1) a transient effect through some oriented structure induced by stretching, which restricts the increase of the swelling rate; (2) a strain amplification effect, which causes the increase of the average local strain in the rubber matrix and enhances the swelling ratio more remarkably proportional to the filler concentration as compared with that of the unfilled system.     

Behavior of cellulose-degrading bacteria in thermophilic anaerobic digestion process.

Previously, we found that the newly isolated Clostridium sp. strain JC3 became the dominant cellulose-degrading bacterium in thermophilic methanogenic sludge. In the present study, the behavior of strain JC3 in the thermophilic anaerobic digestion process was investigated quantitatively by molecular biological techniques. A cellulose-degrading experiment was conducted at 55 degrees C with a 9.5 L of anaerobic baffled reactor having three compartments (Nos. 1, 2, 3). Over 80% of the COD input was converted into methane when 2.5 kgCOD m(-3) d(-1) was loaded for an HRT of 27 days. A FISH probe specific for strain JC3 was applied to sludge samples harvested from the baffled reactor. Consequently, the ratio of JC3 cells to DAPI-stained cells increased from below 0.5% (undetectable) to 9.4% (compartment 1), 13.1% (compartment 2) and 21.6% (compartment 3) at day 84 (2.5 kgCOD m(-3)d(-1)). The strain JC3 cell numbers determined by FISH correlated closely with the cellulose-degrading methanogenic activities of retained sludge. A specific primer set targeting the cellulase gene (cellobiohydrolaseA: cbhA) of strain JC3 was designed and applied to digested sludge for treating solid waste such as coffee grounds, wastepaper, garbage, cellulose and so on. The strain JC3 cell numbers determined by quantitative PCR correlated closely with the cellulose-sludge loading of the thermophilic digester. Strain JC3 is thus important in the anaerobic hydrolysis of cellulose in thermophilic anaerobic digestion processes.     

Evaluation of phosphate removal from water by immobilized phosphate-binding protein PstS

The phosphate (P(i))-binding protein PstS is a member of a family of periplasmic proteins that act as high-affinity receptors for active transport systems in bacteria. PstS protein purified from Pseudomonas aeruginosa was immobilized to N-hydroxysuccinimide-activated Sepharose, packed into a plastic column (5 x 70 mm), and examined for its potential ability to remove P(i) from water. The PstS-Sepharose column completely removed P(i) from 32P-labeled pond water containing about 0.5 microM P(i) (0.015 mg P per liter). More than 90% of 32P-P(i) that was retained in the column could be eluted by washing with low-pH water.     

Guidance and nonlinear control system for autonomous flight of minirotorcraft unmanned aerial vehicles

Small unmanned aerial vehicles (UAVs) are becoming popular among researchers and vital platforms for several autonomous mission systems. In this paper, we present the design and development of a miniature autonomous rotorcraft weighing less than 700 g and capable of waypoint navigation, trajectory tracking, visual navigation, precise hovering, and automatic takeoff and landing. In an effort to make advanced autonomous behaviors available to mini‐ and microrotorcraft, an embedded and inexpensive autopilot was developed. To compensate for the weaknesses of the low‐cost equipment, we put our efforts into designing a reliable model‐based nonlinear controller that uses an inner‐loop outer‐loop control scheme. The developed flight controller considers the system's nonlinearities, guarantees the stability of the closed‐loop system, and results in a practical controller that is easy to implement and to tune. In addition to controller design and stability analysis, the paper provides information about the overall control architecture and the UAV system integration, including guidance laws, navigation algorithms, control system implementation, and autopilot hardware. The guidance, navigation, and control (GN&C) algorithms were implemented on a miniature quadrotor UAV that has undergone an extensive program of flight tests, resulting in various flight behaviors under autonomous control from takeoff to landing. Experimental results that demonstrate the operation of the GN&C algorithms and the capabilities of our autonomous micro air vehicle are presented. © 2009 Wiley Periodicals, Inc.