Performance evaluation of anti-radiation based on the gamma degradation process

In the environment of space radiation, the high-energy charged particles or high-energy photons acting on a spacecraft can cause either temporary device degradation or permanent failure. The traditional probability model is difficult to obtain reliable estimation of unit radiation resistance performance with small samples. Considering that different products will change differently after high-energy particle radiation, we construct a model based on the gamma degradation process. This model can efficiently describe the law of unit radiation resistance variation with the total radiation dose levels under the effect of the total dose and displacement damage. Finally, the proposed model is used to assess the anti-radiation performance of the N-channel power MOSFET device STRH60N20FSY3 produced by STM to obtain average unit radiation resistance, survival probability, survival function, etc.     

A generalized L2-discrepancy for cubature and uncertainty quantification of nonlinear structures

The numerical method for multi-dimensional integrals is of great importance, particularly in the uncertainty quantification of engineering structures. The key is to generate representative points as few as possible but of acceptable accuracy. A generalized L₂(GL₂)-discrepancy is studied by taking unequal weights for the point set. The extended Koksma-Hlawka inequality is discussed. Thereby, a worst-case error estimate is provided by such defined GL₂-discrepancy, whose closed-form expression is available. The characteristic values of GL₂-discrepancy are investigated. An optimal strategy for the selection of the representative point sets with a prescribed cardinal number is proposed by minimizing the GL₂-discrepancy. The three typical examples of the multi-dimensional integrals are investigated. The stochastic dynamic response analysis of a nonlinear structure is then studied by incorporating the proposed method into the probability density evolution method. It is shown that the proposed method is advantageous in achieving tradeoffs between the efficiency and accuracy of the exemplified problems. Problems to be further studied are discussed.     

Polybrominated Diphenyl Ethers in Surface Sediment from Songhua River Basin, Northeast of China

Sixty sediment samples were collected from the main Songhua River in three years. Twelve polybrominated diphenyl ether ( PBDE) congeners ( BDE17, 28, 47, 66, 99, 100, 153, 154, 138, 183, and BDE?209) w...     

频率响应法研究噻吩在CeY分子筛上的吸附行为

以NaY、液相Ce离子交换改性的Y型分子筛(L-CeY)为研究对象,运用N2吸附、XRD、NH3-TPD和Py-FTIR等实验方法表征两种Y型分子筛的物化性能。采用频率响应技术(FR)和智能重量分析仪(IGA)研究噻吩在两种分子筛上的吸附行为,并考察噻吩在稀土离子改性Y型分子筛上的不同吸附作用模式。结果表明,频率响应技术能够有效识别分子筛孔道内发生的不同传质过程。噻吩在NaY分子筛上的吸附行为较为简单,存在孔道吸附和π电子相互作用两种吸附过程;而在L-CeY分子筛上吸附行为较为复杂,同时存在孔道吸附和"S-M"吸附等多种吸附过程,另外,在高温条件下,还存在复杂的催化反应过程。     

Evaluation research on applicability of rapid iodide migration test

The applicability of the rapid iodide migration test was systematically studied. Comparative experimental tests of different test conditions, including several external voltages, test durations, concrete ages and mixing proportions, were carried out to make clear the transport behaviors of iodide under parallel electric fields. Numerical simulations were also done using the finite element method to found the correlation between chloride and iodide transport behaviors. The test and numerical results show that the chloride transport behaviors of RIM and RCM tests have a good correlation under the several conditions used in the present paper. Moreover, the influence of external conditions （external voltages, test durations） on the test results is small. Thus, it can be concluded that the RIM method is available to determine the chloride penetration resistance of the chloride-eroded structural concrete.     

基于表面反应和扩散迁移控制的灰岩单裂隙渗流—溶解模型及其数值模拟

针对碳酸盐类可溶岩地区水电站坝址流场、化学场以及固相介质属性等随时间发生改变,从而对工程安全运行造成不利影响等问题,研究了灰岩地区地下水运移过程中各物理场间的相互作用,分析了影响灰岩溶解速率的两个因素,即表面反应控制和扩散迁移控制。在此基础上,建立了单裂隙中的渗流—溶解耦合模型,并进行数值求解。模拟结果表明,在垂直裂隙延伸方向,其溶蚀锋面为非齐整平面,而是呈似“虫洞”状非均一变化,而沿裂隙延伸方向即自上游侧向下游方向溶蚀程度逐渐减轻;而通过裂隙的流量呈现随时间逐渐增大的趋势,但变幅不大;根据流量求得的等效水力隙宽,其增幅和增长速率均小于实际平均隙宽;同时,化学场中Ca2+浓度的分布与裂隙开度变化具有相似性,不同时刻下上游侧反应速率R均大于下游侧。就反应机制而言,在初期均受表面反应控制,而随反应进行,位于上游补给区部位转为受扩散迁移控制,但在下游位置仍受表面反应控制。     

高温预析出对Al-Zn-Mg-Cu铝合金显微组织、强度和应力腐蚀抗力的影响

通过改变固溶条件 ,对Al Zn Mg Cu高强铝合金采用先高温后低温的两步固溶处理 (高温预析出 )来改善晶内和晶界的析出状态 ,研究了高温预析出对Al Zn Mg Cu铝合金的金相组织、强度和应力腐蚀性能的影响。结果表明 ,4 6 5℃高温预析出在保持较高强度和塑性的同时 ,可以改善合金的抗应力腐蚀性能     

Nitrogen removal using recycled polystyrene bottles as biofilm media

The performance of an attached growth wastewater treatment process was investigated in an effort to improve nitrogen removal efficiency. Recycled Yakult (lactic acid fermentation drink) bottles made of polystyrene were used as a biofilm media. The use of Yakult bottles as a biofilm media has been attempted by numerous researchers in Japan for the removal of solids and organics. However, these studies focused only on the removal of solids and organics. This study extended their application to the removal of nitrogen for domestic sewage treatment. Yakult media was placed in a reactor with 70% apparent reactor volume in a conventional A/O process. The bottom of the Yakult media was removed, and randomly filled Yakult media were effectively able to reduce the flow in tanks, resulting in an increase in the contact time between pollutants and microorganisms. With higher HRT, the nitrogen removal efficiency was increased by up to 83% with 12 hr of HRT. Nitrification appeared to be the limiting factor of nitrogen removal at an HRT that is less than 12 hr, indicating that the Yakult process requires more retention time to achieve nitrification compared to other biofilm processes. The removal efficiencies of organics and solids were high regardless of the change of operational parameters. This article is based on a presentation in “The 7th Korea-China Workshop On Advanced Materials” organized by the Korea-China Advanced Materials Cooperation Center and the China-Korea Advanced Materials Cooperation Center, held at Ramada Plaza Jeju Hotel, Jeju Island, Korea on August 24–27, 2003.     

真空水冷铜坩埚感应炉模糊控制专家系统的研究

研究真空水冷铜坩埚感应炉中模糊控制专家系统。阐述该炉控制系统复杂性 ,介绍模糊控制专家系统的主要结构和各主要部分的功能和一些算法     

粘土砂旧砂再生效果与其含水量的关系

在影响粘土砂旧砂再生效果的诸多因素中,旧砂中水分含量是最重要的因素。本文就水分含量对再生效果的影响规律、再生效果最佳的水分含量等进行了研究和分析,得出了如下结论:并非含水量越低再生效果就越好,而是存在一个去泥率低谷区;再生效果最佳的适宜水分含量为1～2%。