A 1-V 10.7-MHz switched-opamp bandpass /spl Sigma//spl Delta/ modulator using double-sampling finite-gain-compensation technique

A 1 V switched-capacitor (SC) bandpass sigma-delta (/spl Sigma//spl Delta/) modulator is realized using a high-speed switched-opamp (SO) technique with a sampling frequency of up to 50 MHz, which is improved ten times more than prior 1 V SO designs and comparable to the performance of the state-of-the-art SC circuits that operate at much higher supply voltages. On the system level, a fast-settling double-sampling SC biquadratic filter architecture is proposed to achieve high-speed operation. A low-voltage double-sampling finite-gain-compensation technique is employed to realize a high-resolution /spl Sigma//spl Delta/ modulator using only low-DC-gain opamps to maximize the speed and to reduce power dissipation. On the circuit level, a fast-switching methodology is proposed for the design of the switchable opamps to achieve a switching frequency up to 50 MHz. Implemented in a 0.35-/spl mu/m CMOS process (V/sub TP/=0.82 V and V/sub TN/=0.65 V) and at 1 V supply, the modulator achieves a measured peak signal-to-noise-and-distortion ratio (SNDR) of 42.3 dB at 10.7 MHz with a signal bandwidth of 200 kHz, while dissipating 12 mW and occupying a chip area of 1.3 mm/sup 2/.     

Abnormal junction profile of silicided p+/n shallowjunctions: a leakage mechanism

The leakage mechanism in p⁺/n shallow junctions fabricated using Co silicidation and shallow trench isolation processes has been investigated using transmission electron microscopy (TEM) combined with selective chemical etching. TEM and TSUPREM-4 simulation results show that dopant profiles bend upward near the edge of the active region. The formation of the abnormal profile is attributed to transient enhanced diffusion induced by source/drain implantation. Based on the TEM and simulation results, it is suggested that the shallower junctions formed near the active edge can serve as a source for leakage current in the silicided p+ /n shallow junctions     

An efficient optimistic message logging scheme for recoverable mobile computing systems

A number of checkpointing and message logging algorithms have been proposed to support fault tolerance of mobile computing systems. However, little attention has been paid to the optimistic message logging scheme. Optimistic logging has a lower failure-free operation cost compared to other logging schemes. It also has a lower failure recovery cost compared to the checkpointing schemes. This paper presents an efficient scheme to implement optimistic logging for the mobile computing environment. In the proposed scheme, the task of logging is assigned to the mobile support station so that volatile logging can be utilized. In addition, to reduce the message overhead, the mobile support station takes care of dependency tracking and the potential dependency between mobile hosts is inferred from the dependency between mobile support stations. The performance of the proposed scheme is evaluated by an extensive simulation study. The results show that the proposed scheme requires a small failure-free overhead and the cost of unnecessary rollback caused by the imprecise dependency is adjustable by properly selecting the logging frequency.     

Extended adaptive RBF equaliser for overcoming co-channelinterference

The authors investigate the problem of nonlinear adaptive equalisation in the presence of intersymbol interference, additive white Gaussian noise and co-channel interference. An extended radial basis function (RBF) network is proposed, in which regression weights are used in the output layer and the hidden unit is defined to have the Gaussian formula with the Mahalanobis distance. It is shown by simulation that the proposed structure gives reduced computational complexity without performance degradation, compared to that of the conventional RBF equaliser     

p53 gene therapy in vivo of herpatocellular and liver metastatic colorectal cancer

Tumor suppressor genes such as p53 contribute to the oncogenic process via loss-of-function mechanisms such as genetic mutation or complex formation with other cellular or viral proteins. p53 is mutated in approximately 50% of human tumors and has an important role in the genesis or progression of both colorectal and hepatocellular cancers. Colorectal cancer is leading cause of cancer mortality in the United States, whereas hepatocellular cancer is the leading worldwide cause of cancer death; the liver is a primary site of morbidity in both diseases. Because systemic tumor suppressor gene therapy is currently not feasible, we have chosen to develop a regional form of such therapy directed at primary or metastatic liver neoplasms. Gene replacement therapy with p53 is a promising new strategy to treat advanced human cancers.     

Multiple-gate SOI MOSFETs: device design guidelines

This paper describes computer simulations of various SOI MOSFETs with double and triple-gate structures, as well as gate-all-around devices. The concept of a triple-gate device with sidewalls extending into the buried oxide (hereby called a "/spl Pi/-gate" or "Pi-gate" MOSFET) is introduced. The Pi-gate device is simple to manufacture and offers electrical characteristics similar to the much harder to fabricate gate-all-around MOSFET. To explore the optimum design space for four different gate structures, simulations were performed with four variable device parameters: gate length, channel width, doping concentration, and silicon film thickness. The efficiency of the different gate structures is shown to be dependent of these parameters. The simulation results indicate that the the Pi-gate device is a very promising candidate for future nanometer MOSFET applications.     

Structural evaluation of thermal stratification for PWR surge line

Recent observations at operating plants and subsequent US NRC requirements have identified flow stratification in surge lines as a phenomenon that must be considered in the design basis of surge lines. To address these concerns, the stratified loading conditions were included in the design of YGN 3 and 4 surge line as a design basis transient and pipe temperature and displacement measurement were taken during YGN 3 pre-core hot functional testing to determine the degree of surge line flow stratification. The measured displacements and temperatures were extensively reviewed and evaluated in detail: (1) to verify the validity of the thermal hydraulic model used to predict the pipe top-to-bottom temperature differentials; (2) to analytically correlate measured surge line temperatures and displacements; and (3) to confirm the validity of the stratified flow analysis procedure. This paper shows that the stratified flow phenomenon is generic and therefore generic loadings can be developed and evaluated for the surge line analyses.     

C-t analysis of MOS capacitors under constant current stress

The effect of high oxide field stress is studied using capacitance-time (C-t) measurements of MOS capacitors. The stress results in parallel shifts of the C-t curve along the time axis. The flatband voltage shift ΔV_FB obtained from the initial deep depletion capacitance C(t=0⁺) follows the same trend as that from the high-frequency C-V characteristics. However, the discrepancy between the two flatband voltages becomes larger as the stress increases due to the effect of interface charges on C-t characteristics. The flatband voltage difference is converted to interface trap density, showing a steady increase of interface trap density with stress, similar to that from low-frequency C-V measurements     

Recording of volume hologram using a beam pattern from taperedoptical fiber

A photorefractive volume hologram was recorded and probed using light diffracted from a tapered optical fiber as a reference beam. A single-mode fiber (SMF) was chemically etched and tapered to give a complicated beam pattern, and it is shown that the tapered optical fiber can be utilized to increase the storage density of the volume hologram. Spatial selectivity of the volume hologram with this method was increased by two times compared to the normal SMF referencing, which is due to the fact that the complicated beam pattern has little correlation with its shifted version     

Hepatotoxin (microcystin) and neurotoxin (anatoxin-a) contained in natural blooms and strains of cyanobacteria from Japanese freshwaters

Amounts of hepatotoxic microcystin and neurotoxic anatoxin-a were estimated in natural blooms and strains of cyanobacteria from freshwaters in Japan. A simultaneous analysis method of anatoxin-a and microcystin was applied to natural bloom samples, which has been dominated by several species and the strains of cyanobacteria which produced simultaneously both toxins. The natural blooms examined in the present study were mainly composed of Anabaena and Oscillatoria, but most also contained Microcystis and other cyanobacteria. Only one sample was almost unialgal, Anabaena spiroides, collected from Lake Sagami. The toxins in 14 samples collected from nine different natural blooms during 1988-1992 were identified as microcystins-RR, -YR, and -LR; desmethyl-7-microcystin-LR (7-DMLR); and anatoxin-a. Microcystins were the main toxins contained in these natural blooms, with anatoxin-a not being detected or of very little quantity. 7-DMLR was detected in samples only from Lake Kasumigaura. Five strains of Anabaena isolated from waters in Japan produced a small amount of anatoxin-a, but no microcystins. One half of the strains of Microcystis produced microcystins and/or anatoxin-a. This is the first study showing Microcystis producing both anatoxin-a and microcystins.