Lasing band-edge identification for a surface-emitting photonic crystal laser

The possibility of single-mode oscillation over a large cavity area for photonic crystal lasers emitting at the photonic band edge has resulted in much interest in such materials for new forms of solid-state laser. In this paper, we measure the photonic bandstructure in our sample and identify the lasing band edge. By mapping out the bandstructure at the /spl Gamma/-point, we have observed fine structure at the band edge. The experimental results are in good agreement with the theoretically predicted bandstructure. Above threshold, we observe a lasing peak at 965 nm at one of the band edges. The far-field distribution of the laser is measured, showing an annular profile and azimuthal polarization. Calculations on the far-field distribution at the lasing band edge suggest the annular profile is due to an anti-symmetric resonant mode.     

Transient liquid phase bonding of HfC-based ceramics

Transient liquid phase (TLP) bonding enables joining at lower temperatures than traditional bonding techniques and preserves the potential for high-temperature applications, making it particularly attractive for joining ultra-high-temperature ceramics (UHTCs) such as carbides and borides. The feasibility of a TLP joint between “pure” carbides has been recently demonstrated. The present study examines the interactions that occur between undoped HfC or MoSi₂-doped HfC and a Ni/Nb/Ni multilayer interlayer during TLP bonding. Bonding is performed at 1400 °C for 30 min in a high-vacuum furnace. SEM–EDS characterization shows that the reaction layer formed at the interlayer/ceramic interface contains mixed carbides and depending upon the ceramic, Ni–Nb–Hf, or Ni–Nb–Hf–Si, or Ni–Nb–Si alloys. Nanoindentation tests traversing the reaction layer between the bulk ceramic and Nb foil midplane also show a clear transition zone across which the indentation modulus and hardness vary. Crack-free joints have been obtained with undoped HfC. The addition of 5 vol% MoSi₂ introduces small (<5 μm long) isolated cracks within the reaction layer, whereas with 15 vol% MoSi₂ added, cracking was pervasive within the reaction layer. When the reaction layer exceeds a critical thickness, as in the case of the bond obtained with HfC doped with 15 vol% MoSi₂, residual stresses become sufficiently large to cause extensive cracking and bond failure. The results suggest a need to characterize and balance the positive role of additives on sintering with the potentially deleterious role they may have on joining.     

Performance of passive heat removal by an air‐cooling panel from a high‐temperature gas‐cooled reactor

An experiment was performed to simulate an air‐cooling panel system for passive decay heat removal from a high‐temperature gas‐cooled reactor to investigate the performance of decay heat removal and the temperature distributions of components of the system. The experimental apparatus consisted of a pressure vessel 1 m wide and 3 m high. Nineteen simulated standpipes containing heaters with a maximum heating rate of 100 kW simulated residual heat of the core, and the cooling panels surrounded the pressure vessel. An analytical code (THANPACST2) was applied to the experimental data to investigate the validity of the analytical method and the model proposed. Under the conditions of helium gas at a pressure of 0.64 MPa and temperature of 514 °C in the pressure vessel, the predicted temperature distribution in the pressure vessel was estimated and was within ?10 to +50 °C as compared to the experimental data. The analysis indicated that the heat transferred to the cooling panel was 15.4% less than the experimental value. © 2002 Wiley Periodicals, Inc. Heat Trans Asian Res, 31(8): 665–677, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/htj.10061     

Simultaneous induction of calcium transients in embryoid bodies using microfabricated electrode substrates

Precise control of differentiation processes of pluripotent stem cells is a key component for the further development of regenerative medicine. For this purpose, combining a cell-aggregate-size treatment for regulating intercellular signal transmissions and an electrical stimulation technique for inducing cellular responses is a promising approach. In the present study, we developed microfabricated electrode substrates that allow simultaneous stimulation of embryoid bodies (EBs) of P19 cells. Mouse embryonal carcinoma P19 cells can be induced to differentiate into three germ layers and serve as a promising stem cell model. Microcavity–array patterns were fabricated onto indium–tin–oxide (ITO) substrates using a standard photo-lithography technique, and uniform-sized EBs of P19 cells were inserted into each microcavity. Electrical stimulation was applied to the EBs through substrate electrodes and stimulus-induced intracellular calcium transients were monitored. We confirmed that the developed electrode device could simultaneously stimulate smaller (200 μm diameter) and larger (500 μm diameter) EBs inserted in the microcavities and induce specific spatio-temporal patterns of intracellular calcium transients in the EBs with fine reproducibility. We concluded that the developed microcavity array with embedded electrodes could simultaneously and effectively stimulate uniform-sized EBs inserted in it. Therefore, it is a promising experimental tool for precisely controlling cell differentiation processes.     

Efficacy of cefditoren pivoxil in the treatment of acute otitis media due to benzylpenicillin-insensitive Streptococcus pneumoniae

Clinical and bacteriological studies were carried out on cefditoren pivoxil (CDTR-PI) granule in infantile purulent acute otitis media treated at general practice settings and the following findings were obtained: 1. Two hundred forty eight strains were isolated from 210 patients, almost all of which (81.1%) harbored the following two strains: Streptococcus pneumoniae (42.3%) and Haemophilus influenzae (38.8%). Among S. pneumoniae, benzylpenicillin (PCG)-insensitive S. pneumoniae, (PISP) or PCG-resistant S. pneumoniae (PRSP) was 36.2%, corresponding to 15.3% of all the isolates and found in 18% of all patients. 2. The bacteria in the middle ear discharge and the nasopharyngeal swabs were correlated with conformity rate of more than 80% with regard to Streptococcus pyogenes, S. pneumoniae and H. influenzae but no Staphylococcus aureus was detected simultaneously from the two sources in any of the patients. S. aureus and coagulase-negative staphylococci (CNS) were considered to be contaminants that were originated from the external auditory meatus at the time of sampling. 3. Frequencies of isolation of S. pneumoniae from different age groups were higher in a lower age group between 0 and 4 years and those of PISP or PRSP had the similar tendency. 4. Antibacterial activities were determined for CDTR and related oral antibiotics against the strains of S. pneumoniae and H. influenzae as representative isolates. CDTR had stronger antibacterial activities against both bacteria than the reference antibiotics. CDTR was found to be transferred into the otorrhea at a mean concentration of 0.58 micrograms/ml after single administration of CDTR-PI granule formulation at 3 mg(potency)/kg. 5. As for bacterial eradication efficacies in the middle ear cavity and the nasopharynx, eradication rates were higher than 80% in the middle ear cavity in all cases without large differences among bacterial species but eradication rate of PISP was 30% in the nasopharynx, and it was significantly lower than those of PSSP and other bacteria. 6. In view of clinical effectiveness, the efficacy rate was 89.4% and bacteriological effects was 92.2%; in view of safety, adverse reactions were; observed in 9.5% and the rate of usefulness was 89.4%. 7. From above-stated results, CDTR-PI was considered as a useful oral antibiotic for infantile acute otitis media including PISP infections.     

Novel sensing system for glucose based on the complex formation between phenylborate and fluorescent diol compounds

From the standpoints of long-term stability and simple handling, a glucose sensor composed of totally synthetic sensing moieties should be of great advantage. This study was performed to demonstrate the feasibility of a novel glucose sensing system in an aqueous milieu based on a change in the fluorescence on competitive binding between a fluorescent diol compound and glucose toward a phenylborate compound. 6,7-Dihydroxy-4-methyl-coumarin (DHMC) was selected as a fluorophore, and 3-propionamidophenylboronic acid (PAPBA) as a phenylborate compound. The relationship between the glucose concentration and fluorescence intensity was linear in the range of 0 to 500 mg/dl of glucose. The availability of various derivatives of DHMC and phenylborate compounds allows the incorporation of these functionalities on the tip of an optical fiber to construct an opto-sensing system for glucose.     

Fibrolamellar carcinoma of the liver with a mixture of ordinary hepatocellular carcinoma: a case report

Fibrolamellar carcinoma (FLC) of the liver is a rare variant of hepatocellular carcinoma (HCC), and only 13 cases have been reported in Japan up to 1997. We described a histologically unusual case of FLC. A 52-yr-old man was admitted to our hospital for work-up of hepatic mass. Laboratory examinations revealed no abnormalities except elevated serum alpha-fetoprotein (AFP) (2098 ng/ml). A diagnosis of HCC was made by imaging findings, and left lobectomy of the liver was performed. Histologically, the tumor was composed of areas of FLC mixed with ordinary HCC and those of pure ordinary HCC. Staining for AFP was positive in the HCC component and negative in the FLC component. Some cases of such mixed tumors have been reported in Europe and the United States, but not in Japan. We regarded our case as the first of the mixed tumor in Japan.     

α-sulfonated fatty acid esters: II. Solution behavior of α-sulfonated fatty acid polyethylene glycol esters

Sodium α-sulfonated, fatty acid polyethylene glycol monoesters [C _m H_2m+1CH(SO₃Na)COO(C₂H₄O) _n H] and diesters [C _m H_2m+1CH(SO₃Na)COO(C₂H₄O) _n COCH(SO₃Na)C _m H_2m+1], wherem=10–16 andn=1–35, were prepared by esterification of α-sulfonated, fatty acids with polyethylene glycols, followed by neutralization with NaOH. Crude products were purified by reversed-phase column chromatography on an octadecyl-modified silica gel. Characteristic solution behavior of these α-sulfonated fatty acid esters was, examined, and the following features were observed. All monoesters prepared in this work had Krafft points below 0°C and also possessed good calcium stabilities. Critical micelle concentrations of the monoesters increased monotonously, as a rule, with an increase in the number of oxyethylene units. These results suggest that the polyethylene glycol residue of the monoester behaves as a hydrophile. On the other hand, diesters possessed high water solubility, low foamability, and critical micelle concentrations that were lower by a factor of ten compared to those of the monoesters.