Sequential Bayesian bit error rate measurement

As bit error rates decrease, the time required to measure a bit error rate (BER) or perform a BER test (i.e., to determine that a particular communications device's BER is less than some acceptable limit) increases dramatically. One cause of long measurement times is the difficulty of deciding a priori how many bits to measure to establish the BER to within a predetermined confidence interval width. This paper explores a new approach to deciding how many bits to measure, namely a sequential Bayesian approach. As measurement proceeds, the posterior distribution of BER is checked to see if the conclusion can be made that the BER rate is known to be within the desired range with high enough probability. Desired properties of the posterior distribution such as the maximum a postiori estimate and confidence limits can be computed quickly using off-the-shelf numerical software. Examples are given of using this method on bit error data measured with an Agilent 81250 parallel BER tester.     

A XRD study of Co/Au multilayers using a laboratory microdiffractometer

In this paper we show that by the analysis of 2D images collected with a laboratory X-ray microdiffractometer it is possible to non-destructively evaluate the structure, the microstructure, and the preferred orientation of films. In particular, the structural analysis of Co/Au multilayers on Si(1 0 0) deposited at different Ar pressures are reported and discussed.     

Formaldehyde content of milk in goats fed formaldehyde-treated soybean oil-meal

Formaldehyde is used in ruminant feeding for different purposes including the protection of dietary proteins from ruminal degradation. The formaldehyde content of milk of goats fed various levels of formaldehyde-treated soybean oil-meal has been determined by using a sensitive HPLC method. Results showed a significant linear correlation between ingested formaldehyde and formaldehyde concentration in milk. About 0.02% of ingested formaldehyde was excreted in milk, as free formaldehyde.     

Factors affecting cloud point analysis of palm oleins

Some of the factors affecting cloud point determination of palm oleins are described. These are the type of container used, method of stirring, rate of stirring and bath temperature. The repeatability and reproducibility standard deviations of the method are determined from collaborative trials. Recommendations for the test are made to reduce the large variations among laboratories.     

Purification of Ellagic Acid by UF Membranes

Ellagic acid (2, 3, 7, 8‐tetrahydroxy(1)benzopyrano(5, 4, 3‐cde)(1)benzopyran‐5, 10‐dione) was selected as a model pollutant which is present in the tannic fraction of cork processing wastewater. The ultrafiltration of aqueous ellagic acid solutions through three membranes was studied in tangential UF laboratory equipment. Two of the membranes were polyethersulfone (Biomax10K and Biomax5K, with MWCO of 10000 and 5000 Da, respectively), and the third made of regenerated cellulose (Ultracel5K, with MWCO of 5000 Da). The water hydraulic permeability was evaluated for each membrane. The evolution of the permeate flow rate with processing time was followed, and the influence of the main operating variables (feed flow rate, trans‐membrane pressure and nature of the membranes) on the permeate flux was also established. According to the hypothesis of the film theory, the intrinsic and apparent rejection coefficients, as well as the mass transfer coefficients, were also determined, and the values obtained were discussed as a function of the operating conditions used.