可焊性高强度钢筋的开发与生产

为进一步开发国际钢材市场，研制开发了符合加拿大可焊性高强度钢筋标准要求的高强度钢筋．制定了化学成分及力学性能内控标准，分析了生产工艺各环节对成分和性能的影响，依据试验结果，在全面统计分析的基础上，调整了冶炼成分，生产的531批钢筋全部合格．通过直方图及回归分析，说明了制定的产品生产工艺可行，也为今后的生产提供了理论依据。     

钕电解阳极过电位的测定

用慢扫描示波法测定了钕电解的阳极过电位 .考察了温度、阳极电流密度、Nd2 O3添加量、电解质组成等因素对阳极过电位的影响 ,探讨了降低阳极过电位的可能途径 .结果表明 ,阳极过电位随阳极电流密度的增加而增大 ,随温度的升高而减小 ,一定范围内 ,阳极过电位与阳极电流密度的对数呈线性关系 ,满足塔菲尔方程 ;电解质中LiF和Nd2 O3浓度增加 ,阳极过电位降低 ;适当控制阳极电流密度、升高温度、增加电解质中LiF和Nd2 O3的浓度并尽可能减小极间距 ,均有利于降低阳极过电位     

基于非锐化掩模的实时自适应图像增强算法

针对传统的非锐化掩模算法的局限性,依据图像中各像素点及以其为中心的若干相邻像素点的均方差值,提出了自适应图像增强算法的原理,并分析其硬件实现方法,然后给出了该算法与其它算法应用于图像增强的对比结果,最后在FPGA（field programmable gate array）实验板上进行验证.实验结果表明,此算法有效的增强图像的细节区域,防止图像边缘区域出现过冲现象,抑制图像平坦区域的噪声放大.因此,该算法取得了良好的视觉效果,硬件实现简单,适合于实时条件下图像的增强.     

潜油电泵易损零部件失效分析方法

通过对大庆油田近5 a潜油电泵易损零部件的数据统计,应用可靠性分析理论和方法研究了易损零部件的失效规律,得出4大部件的故障率占整个机组系统的91.7%,其可靠度由小到大的次序为电机、保护器、电泵和分离器。在这4大部件中,可靠度较低的零件主要有泵轴、叶导轮、扶正轴承、胶囊和保护器轴,其中泵轴、叶导轮、扶正轴承的主要失效模式是磨损,连接螺栓的主要失效模式是断裂失效。     

星间激光通信技术进展与趋势

较详细地评述了目前国外卫星间光通信技术研究的现状．根据关键单元技术的进展情况，总结了未来星间光通信系统的发展趋势。     

Mitigation of polarization-mode dispersion in multichannel lightwave transmission systems

We propose a novel polarization-mode dispersion (PMD) compensation scheme for wavelength-division-multiplexing (WDM) systems, in which many WDM channels share one or a few PMD compensators at receiver site. It is shown, both analytically and numerically, that this scheme can achieve virtually the same performance as that using per-channel-based PMD compensation.     

微区电阻测试方法及新测试仪研制

文章对国内外开展微区薄层电阻测试的方法进行了综述，特别对改进范德堡四探针技术方法的测试原理、测试过程与测试结果进行了论述与分析，对微区电阻测试方法的进一步发展提出了一种可操作的方法，并研制出新型四探针测试样机。     

多排数翅片管空冷器风阻特性的数值模拟

本文对多排数翅片管空冷器空气侧的风阻特性进行了数值模拟.利用商用软件Fluent进行数值计算,结合经验公式和已有的实验数据,分析了不同入口风速下,阻力的变化规律以及流动阻力和温度变化对模拟计算的影响.     

Courtesy piggybacking: supporting differentiated services in multihop mobile ad hoc networks

Due to the salient characteristics such as the time-varying and error-prone wireless links, the dynamic and limited bandwidth, the time-varying traffic pattern and user locations, and the energy constraints, it is a challenging task to efficiently support heterogeneous traffic with different quality of service (CoS) requirements in multihop mobile ad hoc networks. In the last few years, many channel-dependent mechanisms are proposed to address this issue based on the cross-layer design philosophy. However, a lot of problems remain before more efficient solutions are found. One of the problems is how to alleviate the conflict between throughput and fairness for different prioritized traffic, especially how to avoid the bandwidth starvation problem for low-priority traffic when the high-priority traffic load is very high. In this paper, we propose a novel scheme named Courtesy Piggybacking to address this problem. With the recognition of interlayer coupling, our Courtesy Piggybacking scheme exploits the channel dynamics and stochastic traffic features to alleviate the conflict. The basic idea is to let the high-priority traffic help the low-priority traffic by sharing unused residual bandwidth with courtesy. Another noteworthy feature of the proposed scheme is its implementation simplicity: The scheme is easy to implement and is applicable in networks using either reservation-based or contention-based MAC protocols.     

国有大型军工企业科协组织机构设置研究与设想

在全党、全国认真贯彻“十六大”精神,全面建设小康社会的热潮中,各行各业审时度势,将发展作为第一要务,与时俱进,深化改革,不断开拓创新。国有大型军工企业科协如何顺应时代潮流,在建立完善现代企业制度的同时,进一步理清思路,构建精简、高效、合理的下属组织机构,充分发挥科协“四主一家”积极作用,是当前急待研究和解决的重要课题之一。1国有大型军工企业科协组织机构现状国有大型军工企业科协组织大都创建于改革开放前,机构设置带有较浓的计划经济色彩,如图1所示。科协下属组织机构一是按行政隶属关系设置的学组;二是按上级学会(主管局)…