斜拉索-磁流变阻尼器系统半主动控制的神经网络法

磁流变阻尼器具有良好的可变阻尼特性，能用于结构的半主动控制。针对斜拉桥拉索-磁流变阻尼器系统，本文提出了利用神经控制器进行半主动控制的神经网络法，该神经控制器根据过去时刻的加速度响应和控制信号预测下一时间步的控制信号，并给出了训练方法及开展了数值仿真研究。仿真结果显示，采用神经网络半主动控制能取得很好的减振效果，证明该方法是可行的。     

基于CATV的一站式电子政务系统的构建

电子政务是Internet网络上的综合应用,利用外交互式技术在CATV网络上构建一站式电子政务是充分利用现有的CATV网络资源的最好选择;在CATV网络上构建电子政务最关键的是要建立起安全的信息通道,安全的信息通道的建立必须借助于PKI技术.     

高阶统计量地震子波估计建模

本文在反射系数序列为非高斯、平稳和统计独立的随机过程,地震子波为非因果、混合相位的假设条件下,分别应用滑动平均(MA)和自回归滑动平均(ARMA)模型对地震记录进行建模,并采用运算代价较小的基于高阶累积量的线性化求解方法——累积量矩阵方程法进行了子波提取和模型适应性的研究。数值模拟结果和实际地震数据处理结果表明:自回归滑动平均(ARMA)模型比滑动平均(MA)模型具有参数节省、模型更为高效的特点;累积量矩阵方程法可以有效地压制加性高斯噪声,但对累积量样本估计的准确性要求较高;如果累积量样本估计的误差和方差适度,结合自回归滑动平均(ARMA)模型描述的累积量矩阵方程法可以高效、准确地估计出地震子波。     

燕皮传统加工工艺中碱液对肉糜特性的影响

燕皮是以猪肉和甘薯粉为原料,手工制成的薄如纸且经煮不烂的传统食品。在传统制作燕皮过程中添加山榉灰配制的碱液是影响肉糜品质的关键步骤。通过测定制作燕皮过程中各工序样品的氮溶解指数、持水性、乳化稳定性、pH值和粘度,利用SDS-PAGE分析样品中的蛋白质组分、利用光学显微镜观察它们的结构变化,证实植物碱液能够提高样品的氮溶解指数、持水性和乳化稳定性并且延迟了肉糜硬化。同时实验证明碳酸碱(Na2CO3或K2CO3)可替代传统工艺中的植物碱,为后续标准化、工业化生产提供可行条件。     

Enhanced thermal stability of a sputtered titanium-nitride film as a diffusion barrier for capacitor-bottom electrodes

The effect of a thin RuO_x layer formed on the Ru/TiN/doped poly-Si/Si stack structure was compared with that on the RuO_x/TiN/doped poly-Si/Si stack structure over the post-deposition annealing temperature ranges of 450–600°C. The Ru/TiN/poly-Si/Si contact system exhibited linear behavior at forward bias with a small increase in the total resistance up to 600°C. The RuO_x/TiN/poly-Si/Si contact system exhibited nonlinear characteristics under forward bias at 450°C, which is attributed to no formation of a thin RuO_x layer at the RuO_x surface and porous-amorphous microstructure. In the former case, the addition of oxygen at the surface layer of the Ru film by pre-annealing leads to the formation of a thin RuO_x layer and chemically strong Ru-O bonds. This results from the retardation of oxygen diffusion caused by the discontinuity of diffusion paths. In particular, the RuO_x layer in a nonstoichiometric state is changed to the RuO₂-crystalline phase in a stoichiometric state after post-deposition annealing; this phase can act as an oxygen-capture layer. Therefore, it appears that the electrical properties of the Ru/TiN/poly-Si/Si contact system are better than those of the RuO_x/TiN/poly-Si/Si contact system.     

Discussion on "the fractal effect of irregularity of crack branching on the fracture toughness of brittle materials" by Xie Heping

International Journal of Fracture 41 (1989) 267–274     

GaN and AlGaN high-voltage rectifiers grown by metal-organic chemical-vapor deposition

In this paper, we report the study of the electrical characteristics of GaN and AlGaN vertical p-i-n junctions and Schottky rectifiers grown on both sapphire and SiC substrates by metal-organic chemical-vapor deposition. For GaN p-i-n rectifiers grown on SiC with a relatively thin “i” region of 2 μm, a breakdown voltage over 400 V, and forward voltage as low as 4.5 V at 100 A/cm² are exhibited for a 60-μm-diameter device. A GaN Schottky diode with a 2-μm-thick undoped layer exhibits a blocking voltage in excess of ∼230 V at a reverse-leakage current density below 1 mA/cm², and a forward-voltage drop of 3.5 V at a current density of 100 A/cm². It has been found that with the same device structure and process approach, the leakage current of a device grown on a SiC substrate is much lower than a device grown on a sapphire substrate. The use of Mg ion implantation for p-guard rings as planar-edge terminations in mesageometry GaN Schottky rectifiers has also been studied.     

Evaluating the impact of CASE: an empirical comparison of retrospective and cross-sectional survey approaches

The purpose of this paper is to evaluate two methods of assessing the productivity and quality impact of Computer Aided Software Engineering (CASE) and Fourth Generation Language (4GL) technologies: (1) by the retrospective method; and (2) the cross-sectional method. Both methods involve the use of questionnaire surveys. Developers' perceptions depend on the context in which they are expressed and this includes expectations about the effectiveness of a given software product. Consequently, it is generally not reliable to base inferences about the relative merits of CASE and 4GLs on a cross-sectional comparison of two separate samples of users. The retrospective method that requires each respondent to directly compare different products is shown to be more reliable. However, there may be scope to employ cross-sectional comparisons of the findings from different samples where both sets of respondents use the same reference point for their judgements, and where numerical rather than verbal rating scales are used to measure perceptions.     

Presupposition failure — A comedy of errors

Presuppositions of utterances are the pieces of information you convey with an utterance no matter whether your utterance is true or not. We first study presupposition in a very simple framework of updating propositional information, with examples of how presuppositions of complex propositional updates can be calculated. Next we move on to presuppositions and quantification, in the context of a dynamic version of predicate logic, suitably modified to allow for presupposition failure. In both the propositional and the quantificational case, presupposition failure can be viewed as error abortion of procedures. Thus, a dynamic assertion logic which describes the preconditions for error abortion is the suitable tool for analysing presupposition.