Flexible and Highly Sensitive Strain Sensors Fabricated by Pencil Drawn for Wearable Monitor

Functional electrical devices have promising potentials in structural health monitoring system, human‐friendly wearable interactive system, smart robotics, and even future multifunctional intelligent room. Here, a low‐cost fabrication strategy to efficiently construct highly sensitive graphite‐based strain sensors by pencil‐trace drawn on flexible printing papers is reported. The strain sensors can be operated at only two batteries voltage of 3 V, and can be applied to variously monitoring microstructural changes and human motions with fast response/relaxation times of 110 ms, a high gauge factor (GF) of 536.6, and high stability >10 000 bending–unbending cycles. Through investigation of service behaviors of the sensors, it is found that the microcracks occur on the surface of the pencil‐trace and have a major influence on the functions of the strain sensors. These performances of the strain sensor attain and even surpass the properties of recent strain sensing devices with subtle design of materials and device architectures. The pen‐on‐paper (PoP) approach may further develop portable, environmentally friendly, and economical lab‐on‐paper applications and offer a valuable method to fabricate other multifunctional devices.     

棉浆粕定量水分监控系统的设计

基于“组态王”设计了一个棉浆粕生产过程的计算机监控系统，通过控制和调节棉浆的浓度，流量以及烘缸蒸汽压力，达到满足棉浆粕定量水分的生产要求，并且可在局域网上进行监控。     

从IPv4向IPv6的过渡

IETF提出的从IPv4向IPv6平稳过渡的多种机制分属双栈、翻译器和隧道等三个类型。在分别介绍了三类过渡机制之后，还讨论了影响过渡的其他因素，包括用户对IPv6的需求、网络升级的成本、新型设备的提供能力以及面临的技术问题。     

云平台架构下台间及台内节目内容分享体系的设计与实现

本文分析云平台架构下联盟台之间和台内单位之间内容分享的设计缘由,提出基于内容联盟模式的内容分享体系设计思路.     

双包层光纤放大器研究

双包层光纤放大器输出功率高,可用于密集波分复用系统、光纤CATV系统以及空间光通信系统中。本文采用分段方法,利用光子数平衡原理建立了半数值双包层掺稀土光纤放大器理论模型。利用本模型可以对双包层光纤放大器进行优化设计。     

LTCC-Based Highly Integrated Millimeter-Wave Receiver Front-End Module

This paper presents the design and fabrication of a highly integrated Low Temperature Co-fired Ceramic (LTCC) receiver front-end module. This LTCC module is a dual channel receiver module, works at Ka-band, and fabricated including six Ferro A6M dielectric layers and five metal layers, contains eight embedded resistors and eight MMICs. All MMICs are mounted into pre-making cavities on the top surface of the LTCC substrate. Three slot coupled waveguide-to-microstrip transitions are integrated at LTCC substrate to realize RF and LO signal input. The developed module is highly integrated and reliable, which has a compact size of 58 × 50 × 22 mm³ (including the metal cavity). Each channel of the receiver has the noise figure of less than 9 dB and the gain of more than 24 dB at Ka-band.     

空间级联可调谐光滤波器方式实现光分插复用器

提出一种采用空间级联可调谐光滤波器方式实现的OADM.该器件不但具有集成度高、体积小、插入损耗低、信道间插入损耗差异小的特点,而且能够在控制电路的作用下灵活选择上下路波长及其数量,为构建灵活、高性能的WDM网络提供了选择.     

防空兵火控雷达网及抗干扰效能评价

雷达组网作战是防空兵武器系统的发展趋势,给出了防空兵火控雷达组网的基本形式、系统组成模型和指挥控制过程,指出了火控雷达网的发展思路,构建了火控雷达网抗干扰效能综合评估指标体系,提出了火控雷达网、抗干扰效能评判方法,并通过实例分析结果表明了该模型具有实用性,为防空兵雷达组网提供辅助决策依据.     

Li掺杂量对Li-N共掺ZnO薄膜光学性能的影响

本文利用溶胶-凝胶旋涂法在玻璃衬底上制备了 本征、N单掺和Li-N共掺的ZnO薄膜。 研究Li掺杂量的改变对薄膜的晶体结构、表面形貌、透过性能和发光性能的影响。采用了紫 外-可见分光光度计(UV-VIS)、光致发光谱(PL)、扫描电子显微镜(SEM)和X射线衍 射 仪(XRD)等表征手段对样品进行了测试。结果表明:Li掺杂量的改变对薄膜的结构和性能 都有一定的影响,随着Li掺杂量的增加,(002)衍射峰强度增大,晶 粒尺寸先增加后减小, 紫外发射峰的强度和薄膜的透过性能同样是先增强后减弱。当Li元素的原子比为6at%时, 薄膜的c轴择优取向明显,结晶性能最好,薄膜紫外发光最强,透过率最大。     

第六讲 WWW和Java

本文主要介绍了上海热线网络服务的一些知识 ,包括主页 (Homepage)、WWW浏览查寻、HTML语言和Java语言等。