Lithium/lithium vanadium oxide secondary batteries: IV. Evaluation of factors affecting the performance of test cells

With the aim of optimizing the performance of Li/Li_1+xV₃O₈ cells, several aspects of cathode preparation have been examined. The influence of synthesis technique, nature and amount of conductive additives, compacting pressure, cathode loading, and particle size, has been investigated. Furthermore, the role played by the solutions on cathode efficiency has been outlined. The formulations which perform best are based on small-sized particles blended with about 20% acetylene black and compacted at very high pressures to improve the contact between particles. Such cathodes can provide high capacities at high rates and good cycling efficiencies. The kinetic loss of capacity, observed during the first few cycles, may be alleviated by choosing solutions with high fluidity and conductivity.     

Oxidation and mineralisation of substituted phenols by Fenton's reagent and catalytic wet oxidation.

Catalytic abatement of solutions of 1,000 mg/L in phenol, ortho and para nitrophenol and ortho and para cresols was acomplished by using two catalytic systems. Fenton's reagent was used at 50 degrees C by adding 10 mg/L of ferrous cation and different dosages of H2O2. The mixture was reacting isothermically in a batch way during 3 hours. Catalytic wet oxidation (CWO) was carried out by using a commercial Activated Carbon, Industrial React FE01606A, CWO runs were carried out in a fixed bed reactor (FBR) with concurrent upflow. Temperature and oxygen pressure of the reactor were set to 160 degrees C and 16 bar, respectively. While phenols are quicky oxidised by the Fenton reagent higher mineralisation was obtained in the CWO process.     

Evaluation of constructed wetlands by wastewater purification ability and greenhouse gas emissions.

Domestic wastewater is a significant source of nitrogen and phosphorus, which cause lake eutrophication. Among the wastewater treatment technologies, constructed wetlands are a promising low-cost means of treating point and diffuse sources of domestic wastewater in rural areas. However, the sustainable operation of constructed wetland treatment systems depends upon a high rate conversion of organic and nitrogenous loading into their metabolic gaseous end products, such as N2O and CH4. In this study, we examined and compared the performance of three typical types of constructed wetlands: Free Water Surface (FWS), Subsurface Flow (SF) and Vertical Flow (VF) wetlands. Pollutant removal efficiency and N2O and CH4 emissions were assessed as measures of performance. We found that the pollutant removal rates and gas emissions measured in the wetlands exhibited clear seasonal changes, and these changes were closely associated with plant growth. VF wetlands exhibited stable removal of organic pollutants and NH3-N throughout the experiment regardless of season and showed great potential for CH4 adsorption. SF wetlands showed preferable T-N removal performance and a lower risk of greenhouse gas emissions than FWS wetlands. Soil oxidation reduction potential (ORP) analysis revealed that water flow structure and plant growth influenced constructed wetland oxygen transfer, and these variations resulted in seasonal changes of ORP distribution inside wetlands that were accompanied by fluctuations in pollutant removal and greenhouse gas emissions.     

Characterization of Tomato Pulp Stickiness during Spray Drying using a Contact Probe Method

A contact probe test was developed to characterize the surface stickiness of a tomato pulp droplet at various moisture contents and temperatures. To provide tomato pulp samples with different moisture contents, tomato powder produced by a laboratory spray dryer was wetted to seven different moisture levels. The instantaneous tensile force curve was recorded during the probe withdrawal from which the maximum tensile force and other useful information were obtained and cross-examined against images of bonding, debonding, and failure of the material. Generally, at higher moisture contents tomato pulp exhibited cohesive failure followed by semi-adhesive failure, but when moisture content decreased to a certain level, a peak tensile pressure was observed and the failure was adhesive. In addition, higher temperatures shifted the points of adhesive failure toward lower moisture content.     

Mixing power in the preparation of powdered composites

Translated from Khimicheskoe i Neftyanoe Mashinostroenie, No. 5, pp. 6–7, May, 1989.     

Pulse arithmetic in VLSI neural networks

This review explores the use of biological signaling methods to build silicon networks. Recent designs using a technique called `pulse stream', which employs fully analog, dynamic weight storage, are described. The pulse-stream concept is explained, and a comparison is made with conventional analog neural networks. An analog synapse based on the pulse-stream approach is presented. Chip details and simulation results are given     

Concurrent Cholesky factorization of positive definite banded Hermitian-matrices

First the Cholesky factorization is extended to cover uniformly partitioned banded positive definite matrices of rank n which may be real symmetric or Hermitian. Then two stratagems are given for the use of the algorithm in concurrent machines where the number of processing elements is less than required to factor the matrix in as few serial steps as possible, and where uniformly high efficiency is expected from all processing elements. Expressions are given for the efficiency factor e appearing in the speed-up expression g = eN, and these are specialized for the N node hypercube machine as a function of partition size s, the number N of processing elements of the hypercube machine, and the cost μ of interelement transmission relative to computation. It is shown that efficiency factor e is inversely proportional to μ/s, and that e is almost independent of N when N is large and μ/s = 0. The task is completed in n/s serial steps with no limit on n. The half bandwidth b of the matrix is 2Ns.