Effect of Cation Doping on the Superplastic Flow in Yttria-Stabilized Tetragonal Zirconia Polycrystals

The superplastic characteristics of various cation-doped yttria-stabilized tetragonal zirconia polycrystals (Y-TZP) were examined. For 1 mol% cation doping the true stress of Y-TZP is very dependent on the ionic radii of the doped cations; for instance, smaller cation radii give rise to lower true stress when compared with the other compositions for the same grain size, strain rate, and testing temperature. The altered true stress level must be due to the change in diffusivity of the accommodation process for grain boundary sliding caused by the addition of cations in ZrO₂. The strain to failure of the doped zirconia is affected by both ionic radius and valence of the dopant cations.     

In-Flight Particle Measurement of Alkali-Free Glass Raw Materials in 12-Phase AC Arc Plasma

In-flight particle measurements of the surface temperature and velocity are important for understanding of melting behavior of glass particles during in-flight melting by multi-phase AC arc plasma. However, the use of optical pyrometry for particle surface temperature has inevitable uncertainties due to non-thermal emissions signals from the plasma plume. This work presents spectroscopic measurements of the non-thermal signals which were found to be caused mainly by the plasma emissions scattered by the particles and the radiation emitted by vapor. After that, the accuracy of thermal radiation measurement was estimated and surface temperature of in-flight glass particle was corrected.     

Variable-speed control of brushless half-speed synchronous motor byvoltage source inverter

The variable-speed control of a voltage source inverter-fed cylindrical rotor type of brushless half-speed synchronous motor with feedback of the rotor position is described. On the basis of an approximate analysis of the steady state, an expression for torque is derived, and two methods of speed control are discussed. The step response of speed in the drive system is almost the same as that in a speed control method based on a slip frequency control in an induction motor drive, and a relatively high torque is obtained even in a low speed region. The motor has the capability of line start and change over from an induction motor (Gorges phenomenon) to a self-controlled half-speed synchronous motor by using a simple position sensor     

Biochemical characterization of horA-independent hop resistance mechanism in Lactobacillus brevis

We isolated a strain from hop-resistant Lactobacillus hrevis ABBC45, which had lost a plasmid (pRH45) harboring a putative hop resistance gene, horA. The hop resistance level of this horA-deficient strain, named ABBC45(C), was initially low but gradually induced by repeated growth in media containing progressively increasing levels of hop compounds. Although the hop resistance level was substantially lower than that of the hop-adapted wild type strain, hop-adapted ABBC45(C) (ABBC45(CR)) was still capable of growing in beer, suggesting ABBC45 possesses at least two hop resistance mechanisms. Hop resistance acquired by ABBC45(CR) gradually diminished to the pre-adapted level, when the strain was grown repeatedly in the absence of hop compounds. ABBC45(CR) was found to be cross-resistant to several structurally unrelated drugs, including ethidium bromide, daunomycin and nisin. In addition, ABBC45(CR) was shown to extrude ethidium in an energy-dependent manner, while ABBC45(C) did not show such activity. This indicates that the efflux pump was induced by adaptation to hop compounds. The efflux activity of ethidium was reduced by the addition of hop compounds, suggesting hop compounds are also the substrate of the efflux pump. It was also shown that the efflux activity was completely dissipated with the abolition of proton motive force (PMF). These results, taken together, suggest the hop resistance mechanism of ABBC45(C) is mediated by PMF-dependent multidrug efflux pump.     

Successive changes in community structure of an ethylbenzene-degrading sulfate-reducing consortium

The microbial community structure and successive changes in a mesophilic ethylbenzene-degrading sulfate-reducing consortium were for the first time clarified by the denaturing gradient gel electrophoresis (DGGE) analysis of the PCR amplified 16S rRNA gene fragments. At least ten bands on the DGGE gel were detected in the stationary phase. Phylogenetic analysis of the DGGE bands revealed that the consortium consisted of different eubacterial phyla including the delta subgroup of Proteobacteria, the order Sphingobacteriales, the order Spirochaetales, and the unknown bacterium. The most abundant band C was closely related to strain mXyS1, an m-xylene-degrading sulfate-reducing bacterium (SRB), and occurred as a sole band on DGGE gels in the logarithmic growth phase that 40% ethylbenzene was consumed accompanied by sulfide production. During further prolonged incubation, the dominancy of band C did not change. These results suggest that SRB corresponds to the most abundant band C and contributes mainly to the degradation of ethylbenzene coupled with sulfate reduction.     

Stabilization by harmonic intensities for the output signal in heterodyne detection

We experimentally demonstrated that the technique to stabilize the output signal by harmonic intensities is useful in heterodyne detection with an incoherent light source such as a halogen lamp. The relation between the relative standard deviation of an output signal and the fluctuation of the light intensity is analyzed and simulated. Using the fundamental to sixth harmonics increases the stabilities of output signal approximately 3 times, and subtracting the relative standard deviation of the intensity of light source enhances the stabilities 49 times. The fluctuating phase that is due to the fluctuating frequency and temperature and its power spectrum density for an interferometer is also calculated with the Allan variance.     

Production of lepidimoide by an endophytic fungus from polysaccharide extracted from Abelmoschus sp.: identification of the product and the organism producing it

A highly potent allelopathic factor, lepidimoide, was initially extracted from mucilage of germinated cress seeds. Polysaccharide extracted from okra (Abelmoschus esculentum Moench) is considered to have a similar structure to lepidimoide as its repeating unit. We therefore initiated the screening of enzymes capable of degrading okra polysaccharide into lepidimoide from endophytes. We discovered an endophytic fungal strain AHU9748 isolated from Coleus galeatus, which produced an oligosaccharide having similar properties to lepidimoide on thin layer chromatography. The physico-chemical data from ESI-MS, NMR spectra and other analyses also showed the purified product to be identical to lepidimoide. The strain AHU9748 was identified as a fungus belonging to the coelomycetes, closely related to the genus Colletotrichum, based on morphological characteristics and sequence analysis of the 18S rDNA and ITS region.     

Structural evolution in Fe ion implanted Si upon thermal annealing

We have performed high-dose Fe ion implantation into Si and characterized ion-beam-induced microstructures as well as annealing-induced ones using transmission electron microscopy (TEM) and grazing-incidence X-ray diffraction (GIXRD). Single crystals of Si(1 0 0) substrate were irradiated at 623 K with 120 keV Fe⁺ ions to a fluence of 4 × 10¹⁷ cm⁻². The irradiated samples were then annealed in a vacuum furnace at temperatures ranging from 773 K to 1073 K. Cross-sectional TEM observations and GIXRD measurements revealed that a layered structure is formed in the as-implanted specimen with ε-FeSi, β-FeSi₂ and damaged Si, as component layers. A continuous β-FeSi₂ layer was formed on the topmost layer of the Si substrate after thermal annealing.     

Structural changes of SiC under electron-beam irradiation: Temperature dependence

Electron-beam-irradiation effects on silicon carbide (SiC) was investigated as a function of the irradiated temperatures. Single crystalline 6H-SiC was irradiated with 300 kV electrons at temperatures ranging from −170 to 250 °C. It was found that amorphous SiC is induced at −170 °C and room temperature, while crystalline Si is formed at 250 °C with a high electron fluence. It is considered that preferential knock-on displacement of C atoms and damage recovery play an important role in the formation of the amorphous SiC and crystalline Si.     

MRF-based texture segmentation using wavelet decomposed images

In recent textured image segmentation, Bayesian approaches capitalizing on computational efficiency of multiresolution representations have received much attention. Most of the previous researches have been based on multiresolution stochastic models which use the Gaussian pyramid image decomposition. In this paper, motivated by nonredundant directional selectivity and highly discriminative nature of the wavelet representation, we present an unsupervised textured image segmentation algorithm based on a multiscale stochastic modeling over the wavelet decomposition of image. The model, using doubly stochastic Markov random fields, captures intrascale statistical dependencies over the wavelet decomposed image and intrascale and interscale dependencies over the corresponding multiresolution region image.