Novel oxidative in vitro metabolites of the mycotoxins alternariol and alternariol methyl ether

The Alternaria toxins alternariol (AOH; 3,7,9-trihydroxy-1-methyl-6H-benzo[c]chromen-6-one) and alternariol methyl ether (AME, 3,7-dihydroxy-9-methoxy-1-methyl-6H-benzo[c]chromen-6-one) are common contaminants of food and feed, but their oxidative metabolism in mammals is as yet unknown. We have therefore incubated AME and AOH with microsomes from rat, human, and porcine liver and analyzed the microsomal metabolites with HPLC and GC-MS/MS. Seven oxidative metabolites of AME and five of AOH were detected. Their chemical structures were derived from their mass spectra using deuterated trimethylsilyl (TMS) derivatives, and from the information obtained from enzymatic methylation. Several of the metabolites were identified by comparison with synthetic reference compounds. AME as well as AOH were monohydroxylated at each of the four possible aromatic carbon atoms and also at the methyl group. In addition, AME was demethylated to AOH and dihydroxylated to a small extent. As the four metabolites arising through aromatic hydroxylation of AME and AOH are either catechols or hydroquinones, the oxidative metabolism of these mycotoxins may be of toxicological significance.     

A low-wavenumber-extended confocal Raman microscope with very high laser excitation line discrimination

We describe the simple modification of a confocal Raman imaging microscope to incorporate two ultra-narrow holographic notch filters. The modified microscope rejects the laser excitation line (Rayleigh peak) by a discrimination factor of ～10(11) and allows simultaneous measurements of Stokes/anti-Stokes Raman shifts as close as ～10/20 cm(-1) to the Rayleigh line. The extremely high rejection ratio of the Rayleigh peak results in its intensity becoming comparable to typical Raman scattering signals. This is essential for micro-Raman spectroscopy and imaging in the low-wavenumber region. We illustrate the resulting performance with measurements on silicon/silica, sapphire, sulfur, L-cystine, as well as on single-walled carbon nanotubes (SWNTs). We find that both aggregated (bulk) and individual (deposited on substrate) SWNTs demonstrate strong and broad characteristic Raman features below ～100 cm(-1)-in a region which has remained essentially unexplored in measurements of bulk SWNT samples and which has so far been inaccessible for Raman spectroscopy of individual SWNTs.     

The Role of Oncostatin M and Its Receptor Complexes in Cardiomyocyte Protection,Regeneration, and Failure

Oncostatin M (OSM), a member of the interleukin-6 family, functions as a major mediator of cardiomyocyte remodeling under pathological conditions. Its involvement in a variety of human cardiac diseases such as aortic stenosis, myocardial infarction, myocarditis, cardiac sarcoidosis, and various cardiomyopathies make the OSM receptor (OSMR) signaling cascades a promising therapeutic target. However, the development of pharmacological treatment strategies is highly challenging for many reasons. In mouse models of heart disease, OSM elicits opposing effects via activation of the type II receptor complex (OSMR/gp130). Short-term activation of OSMR/gp130 protects the heart after acute injury, whereas chronic activation promotes the development of heart failure. Furthermore, OSM has the ability to integrate signals from unrelated receptors that enhance fetal remodeling (dedifferentiation) of adult cardiomyocytes. Because OSM strongly stimulates the production and secretion of extracellular proteins, it is likely to exert systemic effects, which in turn, could influence cardiac remodeling. Compared with the mouse, the complexity of OSM signaling is even greater in humans because this cytokine also activates the type I leukemia inhibitory factor receptor complex (LIFR/gp130). In this article, we provide an overview of OSM-induced cardiomyocyte remodeling and discuss the consequences of OSMR/gp130 and LIFR/gp130 activation under acute and chronic conditions.     

Enzymatic esterification of glycerol III. Lipase-catalyzed synthesis of regioisomerically pure 1,3-sn-diacylglycerols and 1 (3)-rac-monoacylglycerols derived from unsaturated fatty acids

Lipases that display high regioselectivities and broad substrate tolerance were used as catalysts for the efficient esterification of glycerol under the conditions of irreversible acyl transfer. A variety of unsaturated fatty acids, such as oleic, linoleic, erucic, ricinolic, hydroxystearic and coriolic acid, were used for this purpose in the form of their vinyl esters. Suitable biocatalysts were chosen on the basis of systematic screening experiments regarding their regioselectivities (RE) and substrate tolerances. Distinct differences were found and expressed in numerical RE values as a measure for differences of these biocatalysts as being specific, selective, and nonspecific. Based on these experiments, a variety of molecules were synthesized on a preparative scale (>150 mmol) in good yield (ca.85%) and with high regioisomerical purities (>95% RE).     

Fragment Mass Distribution of “Secondary Fragments”

An analysis of the secondary fragments emerging from a target plate has shown that their mass distribution fits excellently to a formula established earlier by the author. This applies equally well to the secondary fragments of an explosive-formed fragment from a multi-P warhead, to those from the warhead's structural casing. and even to the fragments from the target plate itself, as well as to the sum of all of these 3 types of fragements. The correlation coefficient for the two constant parameters governing this formula (namely, the scaling factor B and the form factor λ) is always better than 0.99, when an optimum total mass M_o is southt and inserted, and when the first, large fragements are not included in the consideration, which means when one or two measured points are negiected. For secondary fragements, the form factor λ in the mass distribution is close to 1/2 = 0.5, whereas for the natural fragments of HE projectiles it is in the order of 2/3. namely, from 0.6 to 0.8.     

Corner-Turning Distance and Retonation Radius

All high explosives, at least the ones used in military applications, have a specific minimum detonation radius, R_min with which the detonation can change its direction through 90° or 180°. It is to be emphasized that this applies not only to thc so-called insensitive high explosives, but the sensitive explosives of course have smaller radii than the insensitive ones. The corner-turning distance, As, determined in the radial test, also corresponds to the minimum radius, R_min for the detonation wave to invert its direction through 180°. The radial test is a simple method, with regard to both design and analysis, that is suitable for determining the 90°-distance, or the minimum detonation radius, R_min.     

Enzymatic esterification of glycerol I. Lipase-catalyzed synthesis of regioisomerically pure 1,3-sn-diacylglycerols

Regioisomerically pure 1,3-sn-diacylglycerols are conveniently prepared in high yields (>80%) and in large quantities by enzymatic esterification of glycerol in the presence of various 1,3-selective lipases(Chromobacterium viscosum, Rhizopus delemar, Rhizomucor miehei) and a variety of different acyl donors like free fatty acids, fatty acid alkyl esters and vinyl esters. All reactions are carried out in aprotic organic solvents of low water content, namelyn-hexane, diethyl ether or tBuOMe. The creation of an artificial interphase between the solvent-immiscible hydrophilic glycerol and the hydrophobic reaction media by the adsorption of glycerol onto a solid support prior to use was essential for the success of these transformations. The effects of reaction conditions and the regioselectivities of the lipases on the product yields are described in detail.     

Processing of High-Density Submicrometer Al2O3 for New Applications

Sintered corundum components with submicrometer grain sizes exhibit properties which enable numerous new applications. Wet powder processing is developed to associate minimum grain sizes at highest densities with the lowest population of macrodefects. A closest ratio of powder particle size and sintered grain size is important for obtaining most fine-grained microstructures. This target was approached best by using powders with particle sizes in the range of 100–200 nm rather than with smaller nanoparticles.     

Alumina Grown during Deposition of Thermal Barrier Coatings on NiCrAlY

The microstructure of Al₂O₃ formed by oxidation of a model NiCrAlY alloy during electron-beam physical vapor deposition of ZrO₂–7.6 mol% YO_1.5 is examined and compared with that formed on the bare substrate. The growth rate, morphology, and chemical composition of the oxide vary among the different constituents of the alloy surface and are further influenced by the O₂ partial pressure and the physical presence of the thermal barrier coating (TBC) layer. These differences, however, are largely limited to the outer oxide layer. The interplay between the TBC and the growing oxide leads to the formation of a fine-grain Al₂O₃–ZrO₂"mixed zone" within the thermally grown oxide. A mechanism is outlined to explain this behavior, based on the dissolution of ZrO₂ in a transient Al₂O₃ structure growing by outward diffusion of Al, and its subsequent reprecipitation when the metastable phase transforms to the stable α-Al₂O₃ form.